Showing results: 1 - 9 of 9 items found.
-
MS-158 -
Misum Systech Co., Ltd.
This equipment is used for inspecting state of earphonethroughmeasurement of resistor, consumption current and sensivity. Depends on the setting value, OK or NG will displayed.
-
MS-165 -
Misum Systech Co., Ltd.
This equipment is used for inspecting state of travel adapter through AC Input & DC output. Depends on the setting value, OK or NG will displayed.
-
MS-177 -
Misum Systech Co., Ltd.
This equipment is used for PCM function test to check thestate ofsingle IC PCM as well as dual IC PCM. It is applied for only 1Cell PCM and can consist ofup to 40 Channels.
-
MS-134 -
Misum Systech Co., Ltd.
This equipment is used for Firmware Write and Calibration for Smart Module PCM. Through this inspection, secure quality for mass production and development.
-
MS-139 -
Misum Systech Co., Ltd.
This equipment is used for inspecting the current, voltage and temperature of Smart Module in lap top battery. It can do EEPROM data read / verify.
-
MS-152 -
Misum Systech Co., Ltd.
This equipment is used for inspecting condition of cell or pack through charge/discharge operation, to make a precise measurement of performance characteristic, consumption current, ID/TH Resistor, initial resistance. Depends on the setting value, OK or NG will displayed.
-
MS-159 -
Misum Systech Co., Ltd.
This equipment used for F/W writing, Calibration and function test. It inspect current, voltage protection mode, consumption current and cell balancing measurement to check the state of BMS and applied to the full inspection and mass production.
-
MS-154 -
Misum Systech Co., Ltd.
This equipment is used for inspecting condition of cell or pack through charge/discharge operation, to make a precise measurement of performance characteristic, consumption current, ID/TH Resistor, initial resistance. Depends on the setting value, OK or NG will displayed
-
UFTS-CM_20Ch/ 20Ch -
Misum Systech Co., Ltd.
All of the lithium batteries need protection circuit module to prevent any loss of battery function capacity and explosion during over charge , over current or short to cause increased temperatures. This equipment is used to test and inspect a battery's voltage, current, charge, discharge PCM status, IR, and others.