Misum Systech Co., Ltd.
- +82-31-343-111
- Anyang IT Valley 1106~1110, 16-39, LS-no 91 beon-gil
Dongan-gu
Anyang-si, Gyeonggi-do 431-848
Korea, North
Filter Results By:
Applications
-
product
Earphone Tester
MS-158
This equipment is used for inspecting state of earphonethroughmeasurement of resistor, consumption current and sensivity. Depends on the setting value, OK or NG will displayed.
-
product
Mobile Phone Charger Test
MS-165
This equipment is used for inspecting state of travel adapter through AC Input & DC output. Depends on the setting value, OK or NG will displayed.
-
product
Dual PCM Tester
MS-177
This equipment is used for PCM function test to check thestate ofsingle IC PCM as well as dual IC PCM. It is applied for only 1Cell PCM and can consist ofup to 40 Channels.
-
product
Smart Module Tester
MS-134
This equipment is used for Firmware Write and Calibration for Smart Module PCM. Through this inspection, secure quality for mass production and development.
-
product
Smart Module Tester
MS-139
This equipment is used for inspecting the current, voltage and temperature of Smart Module in lap top battery. It can do EEPROM data read / verify.
-
product
Pack Tester
MS-152
This equipment is used for inspecting condition of cell or pack through charge/discharge operation, to make a precise measurement of performance characteristic, consumption current, ID/TH Resistor, initial resistance. Depends on the setting value, OK or NG will displayed.
-
product
BMS Tester
MS-159
This equipment used for F/W writing, Calibration and function test. It inspect current, voltage protection mode, consumption current and cell balancing measurement to check the state of BMS and applied to the full inspection and mass production.
-
product
Pack Tester
MS-154
This equipment is used for inspecting condition of cell or pack through charge/discharge operation, to make a precise measurement of performance characteristic, consumption current, ID/TH Resistor, initial resistance. Depends on the setting value, OK or NG will displayed
-
product
Universal Function Test System
UFTS-CM_20Ch/ 20Ch
All of the lithium batteries need protection circuit module to prevent any loss of battery function capacity and explosion during over charge , over current or short to cause increased temperatures. This equipment is used to test and inspect a battery's voltage, current, charge, discharge PCM status, IR, and others.
