Showing results 1 - 8 of 8 products found.
-
FM1 - NG Systems Ltd
This unit will allow fine adjustment of overall focus of a CCTV camera, especially useful whenever a monitor is not available. It operates by analysing the detail in the centre of the picture and provides a 10 bar LED readout, displaying maximum output when the camera image is in sharpest focus. An input impedance switch provides selection between terminated (75O) and unterminated (high impedance) input.
-
CLM1 - NG Systems Ltd
The Cable Length Meter CLM1 will allow the accurate measurement of severed or open/short-circuit CCTV coaxial cable. For use with RG59 (75O) and RG58 (50O) or equivalent coaxial cable, this meter provides a direct readout in metres of the length of an unterminated run of coaxial cable with a resolution of 2-3 metres.
-
TCG1 - NG Systems Ltd
This generator provides a standard 75O, 1-volt p-p; PAL encoded CCIR video signal for the testing of monitors and other CCTV equipment. The Test Card Generator TGC1 may display one of four test patterns , (i) Colour bars with reference, (ii) Red Raster, (iii) Peak White Raster and (iv) Composite Test Card (see picture below).
-
Aenigma IP - NG Systems Ltd
The Aenigma IP Video Hub is a purpose built wall-mounted enclosure housing a powerful video server PC with an independent on-board status monitor that provides auto-start and watchdog facilities. It has been specifically designed as a stand-alone network-based PC that may be accessed only by authorised users and administrators in order to protect it from casual or malicious misuse.
-
VLM1 - NG Systems Ltd
This meter provides a direct reading in volts of peak white and sync levels of a CCTV signal on a 4 digit LCD display. An input impedance switch provides slection between terminated (75O) and unterminated (high impedance) input.
-
VideoStik VSS1 - NG Systems Ltd
VideoStik is the latest addition to the successful Ranger series of CCTV test equipment from NG systems. This low-cost, battery-operated video sensing device will detect the prescence of standard 1v p to p video by simply probing the BNC terminated cable.
-
PM1 - NG Systems Ltd
The Phase Meter PM1 provides a simple method of synchronising the field sync of two line locked CCTV cameras without the need of a dual-beam oscilloscope.
-
DataBug - NG Systems Ltd
DataBug is a serial to Ethernet converter designed to interface RS232 serial devices to a local area network (LAN). It may be used, in conjunction with its D9 interceptor, to monitor dataflow between an RS232 source and receiver such as an EPOS (Electronic Point Of Sale) system or cash register and its printer or any other RS232 source.
