Showing results: 16 - 24 of 24 items found.
-
75000 Auto Wave -
Hickok Inc.
Voltage Input Range:+/-150V (approx. 170V P/P viewable on LCDVoltage Ranges:150V, 100V, 50V, 20V, 10V, 5V, 2V, 1VSample Rate:1 Ms/Sec @ 100uS/DivisionVolt Meter :+/-150V DCAccuracy:+/-2% FS (per range)Storage:up to 9999 waves on SD card
-
62968 & 62901 -
Hickok Inc.
CST's high quality and easy to use design eliminates potential leak issues with rubber plugs or bladders. CST not only reduces set-up time, it also quickly pressurizes and maintains system pressure so you can find the leak the first time.
-
76462 -
Hickok Inc.
The Universal EFI Quick Probe is a battery-operated tester designed to quickly determine if a fuel injector is firing by detecting a mechanical vibration, such as a fuel injector's pintle movement.Simply press the 7" long probe tip against the injector body, adjust the sensitivity using the thumb-wheel and the bright LED strobe will flash each time the injector opens and closes. The strobe allows the you to determine if the injector is firing consistently, misfiring or not firing at all.
-
20560 -
Hickok Inc.
The ABS Sensor Pinpoint Tester is the quickest way to verify proper wheel speed sensor operation right from the service bay, no road test required. Simply connect the tester to the sensor and spin the wheel right in the service bay. The parade of LEDs provide visual confirmation of signal output. The signal error LED indicates erratic or intermittent signal output. When used with a scan tool that provides wheel speed sensor data, the signal simulation feature simplifies pinpointing wire harness and ECU problems.
-
78065 -
Hickok Inc.
Current diagnostic routines dicatate time consuming circuit testing and NEVER test the component.More and more of today's vehicles are using Pulse Width Modulated (PWM) motors, actuators and solenoids. You can't simply test them by directly applying 12 volts. This can cause expensive misdiagnosis. PWM Power Pro is the only tester that can adjust the output percentage from 0% 100% to effectively pinpoint the cause of the failure.
-
78265 -
Hickok Inc.
Quickly diagnose these common problems and more:Poor groundsTrailer electricalInoperative or intermittent headlamps, window / lock motors, wiper motors, blower motors, and moreReplacement of good parts due to mis-diagnosis
-
BPT02 -
Hickok Inc.
Three stage adapter has12MM & 18MM thread sizes to fit most domestic and import vehicles oxygen sensor ports. The standard 1/4"-20 tip provides the ability to test through the exhaust pipe when O2 sensor ports are inaccessible.* High temperature silicon hose prevents damage to tester from high exhaust temperatures.
-
FPT2600EX1 -
Hickok Inc.
Battery operated handheld tester electronically check's a fuel cap's ability to hold pressure.Complete set of cap adapters that meet EPA standards for recommended fleet coverage.Pass / Fail Standard for daily calibration checks.Brightly colored LEDs indicate NO LEAK, PASS, or FAIL test results in seconds.
-
76500 -
Hickok Inc.
Easy to use and saves time. Instantly verify an active or inactive ignition coil by simply placing the sensing tip near the coil while engine is cranking or running at idle. During normal operation, an ignition coil creates an open magnetic field each and every time the coil is energized. By placing the sensing tip of the tool near or against the ignition coil, a blue LED will illuminate each time a magnetic field is detected.