FRANKONIA GmbH
Manufactorer of RF-Shielded Rooms / Anechoic Chambers and EMC Testequipment. Turn-key delivery and installation of complete EMC-Test-Laboratories. Worldwide sole manufactorer of non-combustible RF-Absorbers.
- +49 9177 – 98 500
- +49 9177 – 98 520
- info@frankonia-emc.com
- Industriestrasse 16
Heideck, 91180
Germany
Filter Results By:
Products
Applications
-
product
Chambers
Our EMC anechoic chamber solutions paired with the Frankosorb® unique non-combustible absorber technology, we are the first choice when it comes to reliable and state-of-the-art test facilities. Our solutions are adapted to every kind of vehicle and its different power train units, incl. hydrogen, gasoline, petrol, from small-sized passenger cars up to large and heavy-weight transport vehicles.
-
product
EMI Receiver
Core-6
The "CORE-6" is a very compact (19", 1 RU), new digital EMI receiver which enables the user to make frequency-sweeps within a few seconds what saves hours of measuring timeduring developments.
-
product
Power Amplifier, RF
Is a type of electronic amplifier that converts a low-power radio-frequency signal into a higher power signal. Typically, RF power amplifers drive the antenna of a transmitter.
-
product
Power Signal Generator
PSG-300
The PSG-300 contains a linear precision power amplifier with a wide bandwidth (DC-300 kHz), suitable for all applications concerningfast alternating signals at high output power. The built in generator provides sine, square and triangle waves.
-
product
RF-Relay Switching Unit
RSU
The RSU Relay Switching Unit is applicable for all fields of RF- and EMC measurements toswitch (manual or remote-controlled) from one input to 2 or 3 outputs.
-
product
Bulk Current Monitoring Probe
MP-50
The Current Monitoring probes may be used whenever RF current measurements are required. Current measurements are made by placing a current carrying conductor within the “sensing” window of the probe and measuring the probe’s output voltage with an RF detector. Calibration of the probe permits the conversion of the voltages measured to current. Current measurements can be made over the frequency range shown in the transfer impedance curve furnished with each probe. There is virtually no loading of the circuit and the technique permits normal operation of the device under test during measurements. The MP-50 can be used for the procedure for clamp injection when the common- mode impedance requirements cannot be met given in chapter 7.4 of IEC/EN 61000-4-6 „Immunity to conducted disturbances, induced by radio frequency fields”. The MP-50 can also be used as current monitor for BCI testing as per ISO11452-4, RTCA/DO-160 section 20, MIL-STD-461 and various automotive standards.
-
product
Magnetic-Field Test System
MTS-800
The MTS-800 is a compact test system for broadband generation and measurement of magnetic fields. Its internal components allow automatic EMC tests according to automotivestandards where high field strength need to be generatedor measured.
-
product
Conducted Immunity Test System
Conducted RF immunity tests acc. to IEC/EN61000-4-6 and BCI tests acc. to ISO 11452-4 and MIL-STD 461 CS 114 Signal generator,RF-power amplifier, RF-power meter and directional coupler (optional) in one 19”-caseStand-alone operation possible with optional available netbookControl-software includedMost important parameters are shown on an integrated displayAutomatic EUT-monitoringOperation via USB port of a PC or NotebookComplete range of CDNs available
