Showing results: 6946 - 6960 of 11167 items found.
-
PRE-01 -
Audiomatica
The microphone preamplifier PRE-01 has been designed to match Audiomatica’s microphones MIC-01, MIC-02 andMIC-03. It is particularly useful when the microphone has to be operated far from the analyzer or when weighted measurements are needed. PRE-01 powers the microphone connected to its input with an 8.2V phantom supplyand adds a selectable weighting filter (A or B or C); also available there is a 20 dB gain stage
-
Arduino llc
The MKR Family is a series of boards, shields & carriers that can be combined to create amazing projects without any additional circuitry. Each board is equipped with a radio module (except MKR Zero), that enables Wi-Fi, Bluetooth®, LoRa®, Sigfox, NB-IoT communication. All boards in the family are based on the Cortex-M0 32-bit SAMD21 low power processor, and are equipped with a crypto chip for secure communication.
-
mSATA SSD Series -
ADLINK Technology Inc.
ADLINK’s mSATA SSD Series with the SATA 6Gb/s interface is fully compliant with the standard mSATA form factor, also known as JEDEC MO300. Utilizing Toggle 2.0 MLC flash technology, capacities of up to 1TB are available with support for read/write speeds of up to 550MB/sec and 500MB/sec respectively . Additionally, the power consumption of the ADLINK’s mSATA modules is much lower than that of traditional hard drives.
-
MSR160 -
MSR Electronics GmbH
Four integrated analogue inputs, a high measurement rate of up to 1000/s per channel and its gigantic memory capacity, all packed into a small format are the key characteristics of the MSR160 data logger. The analogue inputs of the robust mini logger can be used for conventional sensors with analogue outputs (e.g. CO2, conductivity, pH etc). In addition, a multiple output switching power supply is also provided.
-
Tenmars Electronics Co., Ltd.
*LCD display with maximum reading of 6000, plus decimal point.*Analog Bargraph.*AC voltage range: 0 to 600V.*DC voltage range: 0 to 600V.*Auto power off (15 minutes).*Frequency measurement.*AC and Frequency measurement with only one test lead.*Phase sequence test.*Phase conformity test.*Continuity test.*Double injection outer case.
-
Elcontrol Energy Net S.r.l.
NANOVIP® CUBE™ is a modern, powerful, S-Class portable network analyzer developed for professional analysis of consumption and power quality of the most complex electrical networks.It can be used on single-phase, two-phase, three-phase (balanced and unbalanced) networks, low and medium voltage.The advanced features and analysis software supplied makes it a suitable tool to the most demanding professional needs.Your product description goes here.
-
DS3 -
NTi Audio AG
The Dodecahedron Speaker Set offers a lightweight, yet powerful signal source for room & building acoustic measurements. The optimized frequency response ensures precise measurements in accordance with the ISO 16283 and the ISO 3382 standards. The set includes the robust omnidirectional DS3 odecahedron Speaker and the remote-controlled PA3 Power Amplifier. Equalized acoustic frequency spectrum from 100 Hz to 8 kHz.
-
FLS100 Series -
Shanghai Tarluz Telecom Tech Co., LTD
FLS100 Optical Light source could provide maximum 4 wavelengths in one unit, it is an cost effective solution to work with FPM100 series optical power for installing fiber optic network. The unit support Single mode and Multimode (50/125um or 62.5/125um MM fiber) optical cable in one unit. It could support FC, SC, ST, LC and 2.5mm universal optical connector.
-
Coaxial Dynamics
The Coaxial Dynamics series of High-Power Panel Mount Meters are designed to measure RF power in 50-Ohm 1-5/8 to 6-1/8 inch coaxial transmission lines. Several different models are available with either 5/10/25 scales or 15/30/60 scales. The Panel Meter can be installed up to 200-feet from the Line Section with the permanently attached DC cables (10-foot normally supplied).
-
Electro Mechanical Enterprises
Partial discharge instruments have two modes of Wide Band and Low Frequency. You can use it for Partial Discharge tests of High-Voltage Equipment, Insulation Materials, High-Frequency Equipment, and Power Semiconductor devices. Partial discharge Measuring Equipment can easily realize the test of Partial discharge on print-circuit boards, connectors, semiconductors, small motors and other insulation materials, to make a judgment on good / bad of them
-
DPR -
Lectrosonics, Inc.
This unique plug-on transmitter design will ideally match any microphone or line level source via a standard XLR connector. The DPR can tune in 100 kHz or 25 kHz steps across the UHF television band from 470.100 to 607.950 MHz, with a selectable output power of 25 or 50 mW. The purely digital architecture utilizes AES 256-CTR encryption for high level security applications.
-
Fairview Microwave Inc.
Fairview Microwave’s quick connect attenuators are made up of 31 models that support operating frequency ranges from DC to 6 GHz. These attenuators are available with QMA, QN or 4.3-10 connectors for easy mating. They feature VSWR as low as 1.15:1 and attenuation values from 0 to 20dB. The 4.3-10 attenuator models deliver low-PIM performance and have power handling up to 15W maximum.
-
310104369 -
Virginia Panel Corporation
This 50 module platform receiver is equipped with a locking handle to ensure proper ITA engagement. A standard integrated microswitch shuts off power when the ITA disengages from the receiver. Uses all standard VPC modules and contacts, includes a microswitch and is available with optional table legs and keyboard tray kit. Includes mounting flanges and instrument brackets. A slide kit is required for use.
-
310130105 -
Virginia Panel Corporation
The i2 Micro iCon receiver is a one piece connector capable of holding up to 120 Signal QuadraPaddle contacts and 12 Micro Coax or Micro Power. QuadraPaddle modules are molded on .100” (2.54 mm) centers to meet the need for high-density I/O in a compact assembly. This i2 receiver is made for crimp contacts. Accessories such as keying pin kits, protective covers, and strain relief are available.
-
SMK-3000 -
Bird Technologies
The SMK calibration kits are precision, high power calibration standards that are used to calibrate RF radios, wattmeters, directional couplers and other high-power RF test equipment in the field or metrology lab. Unlike other calibration solutions, the SMK-3000 calibration kits reduce the cost of ownership and provide a much faster time-to-calibration with lab precision and accuracy you’ve come to expect from Bird.