Filter Results By:
Products
Applications
Manufacturers
-
product
RF Test Spectrum Measurements over CPRI
Integris 3000
Most modern cell tower network configurations place the Remote Radio Head (RRH) at the top of the tower and the baseband unit(BBU) at the bottom of the tower. While this configuration is advantageous for both computational efficiency and mitigation of RF loss across the cable, it means the only place along RF can be accessed is at the top of the tower. This forces field technicians to have to climb the tower to measure and debug RF noise problems.
-
product
Fault Finder and Cable Length Measurement TDR
Snap Shot™
Accurately finds cable length, impediments in the cable and conditions at the end of every wire in your data, power, or communications/video system up to 3,000 ft.
-
product
Integrated Turbine Rotor Measurement and Assembly Platforms
iMAP
Rotary Precision Instruments UK Ltd
Improve productivity and achieve higher levels of quality by reducing inspection times and the need for costly teardowns due to inefficient rotor assembly. iMAP is the definitive system for productivity improvement in turbine rotor assembly for large volume and heavy loads such as aircraft engines and gas turbines.
-
product
Conductivity Cell for Ultra Pure Water Measurement
9371-10D
Stainless made Conductivity cell is now available!This conductivity cell is tough to shock and the best choise to measure Organic Solvent as well as Ultra pure water sample by employing the stainless material for its body.
-
product
Return Loss, Impedance & Balance Measurement Accessory
Model SLM620-1
For Loss- Frequency Range : 300Hz to 620KHz.- Impedance : 60 to 1000 ohms (40dB maximum).- Accuracy : ±1dB (upto 300KHz) ±2dB (300KHz to 620KHz).For Impedance- Frequency Range : 300Hz to 620KHz.- Impedance : 60 to 3000 ohms.- Accuracy : ±10% (upto 300KHz) ±20% (300KHz to 620KHz).
-
product
Handheld Ultrafine Particle Size Distribution Measurement.
partector 2 Pro
Naneos Particle Solutions gmbh
The naneos partector 2 Pro version is a further development of the well-established Partector 2. The Pro version of the partector 2 can additionally switch through different deposition voltage levels and therefore scan an 8-channel size distribution of an aerosol of interest.
-
product
Configurable System For Temperature Measurement With CAN Interface
MU thermocouple1 CAN
The thermocouple measuring unit offers connections for 8 thermocouples, which are designed for the temperature measuring ranges J, K or T, depending on the product version.
-
product
Automated Laser Beam Quality Measurement System
Beamage-M2
Large Apertures: The only M2 system on the market equipped with a complete set of 50mm optics. Also, the sensor is 11.3 x 11.3 mm. Simple Alignment: Two beam-steering mirrors are included for quick and easy alignment of your laser into the system. The internal mirrors are factory-aligned and the pre-set height also simplifies the alignment.Available Fall '17
-
product
*High Power Measurement From Short Exposure
Ophir has a number of ways to measure high laser powers up to 12kW without heavy water cooled equipment. Most of today’s lasers can be set to emit for a short, precisely controlled period of time. If a short exposure to the laser of 0.3 – 10s is sufficient to measure the power then there are compact, uncooled sensors available for this purpose.
-
product
Power Quality Measurement & Digital Fault Recording
In view of the growing number of factors with a disturbing influence on power systems and the ever increasing sensitivity of devices and installations on the consumer side, simple monitoring criteria such as undervoltage or overcurrent are no longer adequate. Reliable registration of all the relevant processes within the electrical power system calls for constant observation of a wide variety of derived parameters, such as individual harmonic content, system unbalance and interharmonics, and the swift identification of even slight deviations from the norm.
-
product
Fiber Optic Crank Angle Measurement System
CP-5730/CP-0610/CA-6000B
CP / CA series are systems that detect the rotation angle of the engine crankshaft composed of CP-5730 Fiber Optic Crank Angle Detector, CA-6000B Crank Angle Amplifier and CP-0610 Rotation stop jig.
-
product
Measurement of Dew Point in Compressed Air Systems
HP480 – HP481
Compressed air is used for several purposes, many of which require compressed air with a low humidity level, and so comes the need to know the dew point (DP) of water vapour in the compressed air that circulates in the system.
-
product
olar Cells and Modules Online Measurement System
PV-LIT
The fully automatic PV-LIT testing system offers individual and serial testing options for solar cells and complete solar modules. The modular testing system allows easy integration into existing production lines and can be used in automated serial testing for quality assurance.
-
product
Electric Insulation Oil Automatic Measurement System
DAC-5016
DAC-5016 is an automatic test system of insulation oils according to JIS C-2101.The system automatically enables changing over samples (liquid cells) up to max 8 pieces and testing the dielectric loss tangents and the volume resistivities.In automatic mode, the dielectric loss tangents and the volume resistivities are automatically measured, and then the results are printed out with the built-in printer. And the relative permittivities and the volume resistivities calculated are also printed out. Therefore the test time is greatly saved compared to the conventional test methods.
-
product
Propeller and Rotor Blade Strain Measurement Systems
Advanced Telemetrics International
ATi Telemetry Systems are typically used to transmit data from rotating shafts or machinery to a stationary telemetry receiver. The 2040BC Miniature Strain Gage Transmitter can be connected to strain gauges adhered to propellers or rotors in order to transmit blade strain or shaft torque in flight.
-
product
Engine Speed Control and Measurement (Test Set A)
MS 1100
*Checks the parameters such as current, voltage, speed, and turbine gas temperature of 804E and 811 engines Portable instrument*Testing of Automatic engine control system and after burner control system*Simulates the temperature signal derived from the engine TGT (Temperature Gas Turbine) thermocouples*Simulates the speed signal, NL (low pressure shaft speed signal) drive from the L.P shaft Probe*Indicates the current signal to the FCU solenoid derived from the engine control amplifier*Measure the TGT and NL simulated signal at static position*Measure the signal produced by the engine TGT thermocouples*Measure the NL signal produced by the LP shaft*Measure the NH (High-pressure shaft speed) signal produced by HP shaft*Indicates the solenoid current, produced by the engine control amplifier*Indicates the solenoid voltage, produced by the engine control amplifier*Used to test engine in both static and dynamic states
-
product
type 1 ios test and measurement microphone
iprecisionmic
iPrecisionMic is the only Type 1 certified microphone that is also an iOS direct-connect Lightning accessory. iPrecisionMic is factory calibrated to +/-0.1dB using a NIST traceable pressure-compensated calibrator. The calibration offsets are store in the microphone's nonvolatile memory, and are transferred automatically to an iOS device running our AudioTools app.
-
product
CO2 Air Quality & Differential Pressure Measurement
Our Rotronic CO2 and differential pressure instruments complete the PST range of parameters important for environmental monitoring.
-
product
Industrial Gas Chromatographs for Trace Impurity Measurements
The industrial gas chromatographs from LDetek ensure the quality of over 30 pure gases and UHP gases. They can be calibrated to detect over 50 different gases as trace impurities including permanent gases, sulphurs and noble gases as well as many others. Contact us if you have any special requirements for any background gas or impurity not listed.
-
product
Compact Optical Environment Test Measurement System
Durability test with temperature, humidity and "sunlight"●Espec SH-241 small environmental tester combined with a solar simulator for durability testing under temperature, humidity and light environments●Software is also available.●Please inquire about the system configuration individually.
-
product
Flow Measurement Trainer Using Orifice Meter
Unitech Scales And Measurements Pvt. Ltd
This setup is a table top model, it comprises of source and measuring tank. The measuring tank is of acrylic with liters graduated. A small FHP pump is fitted to circulate the water. A orifice meter with U-tube manometer is provided to measure the flow rate. A rotameter is provided to measure the exact flow rate. Control valve is provided to control the water flow rate. Digital timer is provided to notedown the duration of flow.
-
product
Phase Stable Test & Measurement Cable Assembly
Accu-Test 150 & 200
The Accu-Test® line of assemblies was designed to provide exceptional performance in applications requiring both durability and phase stability vs. flexure. The result? Calibration accuracy is maintained, with worry-free handling.
-
product
Patented Phantom Powered Microphones For Test & Measurement
PCB's patented phantom powered preamplifier (426A14) boasts a versatile modular design compatible with any ½" or ¼" IEC 61094-4 compliant microphone cartridge. This adaptability empowers users to choose the cartridge best suited for specific tests while utilizing a single universal 48V preamplifier.
-
product
Handheld Gauge for Nondestructive Coating Thickness Measurement
PHASCOPE PMP10 DUPLEX
The professional for duplex measuring. The specialist for measuring the thickness of duplex layers from automotive to roof panels.
-
product
Handheld Gauge for Nondestructive Coating Thickness Measurement
PHASCOPE PMP10
The most experienced device in our tactile portfolio – reliably solves all special applications.
-
product
Measurement Of Straightness, Flatness, Positioning Uncertainty Of Round Tables
ELCOLEVEL - Software For 3D-straightness Measurement
Optik Elektronik Gerätetechnik GmbH
ELCOLEVEL is a software with interfaces to electronic autocollimators and inclination levels of different manufactureres. This allows for example the 3D-Straightness measurement (twist-, roll- and yaw-angle) of slides in one and the same measuring procedure.
-
product
Measurement Of Straightness, Flatness, Positioning Uncertainty Of Round Tables
RTM - Measurement Of Positioning Uncertainty Of Indexing Tables
Optik Elektronik Gerätetechnik GmbH
RTM is a software for the measurement of positioning uncertainty of indexing tables using an electronic autocollimator and a polygon mirror as angle reference.
-
product
Measurement Of Straightness, Flatness, Positioning Uncertainty Of Round Tables >
ELCOWIN - Software For 2D-straightness Measurement With Electronic Autocollimators
Optik Elektronik Gerätetechnik GmbH
The software ELCOWIN serves for the measurement of straightness, squareness, parallelism of slides and flatness of precision tables by the autocollimation principle. ELCOWIN can be used in connection with electronic autocollimators of the ELCOMAT series from Moeller-Wedel-Optical.
-
product
Manual Four Point Probe Sheet Resistance/resistivity Measurement
RT70V series
• Combinational measurement system by Measurement tester(RT-70V) & Stage.• Thickness input with easy JOG dial operation (RT-70V Tester)• Tester self-test function/Auto change-over measurement range function• Thickness & Temperature correction function for Silicon sample
-
product
Spectral Light And Color Meter w/ Flicker measurement
BTS256-EF
Spectroradiometer for the illuminance (photopic, scotopic, melanopic), spectrum, light color, color rendering index, and flicker. Cosine field of view illuminance measurement for accurate evaluation of extended illumination. Flicker measurement. Spectral measurement technology, required for LED light, color, color rendering, color effects. Photodiode for synchronization to pulse width modulated light and flicker measurement.