Showing results: 2251 - 2265 of 5270 items found.
-
PEWM-3C -
EMSYST Ltd
The three-phase energy standard PEWM-3C is used for quick on-site tests of all types of electricity meters – for active, reactive or apparent energy, two-, three- or four-wire connection. Three voltages and three currents are measured at the same time. The current can be measured either via direct connection up to 10A (class 0.1), or with three current clamps (CC) to 120A, 150A or 1000A (class 0.2).
-
TES Electrical Electronic Corp.
Variable Frequency drive measurement. LoZ voltage measurement to drain ghost voltages. Check 3phase sequence. True RMS reading on AC and DC+AC mode. Inrush current measurement. A measurement for HAVAC flam sensors.
-
Kyoritsu Electrical Instruments Works, Ltd.
Can measure AC current up to 1000A Flexible and light weight by the air core coil used at the sensor part Designed to meet the international safety standard IEC 61010-1 CAT IV 300V, CAT III 600V
-
S6021 -
COMET SYSTEM, s.r.o.
Data logger is designed for record of current. Values are stored to a non volatile electronic memory. Data transfer to the personal computer for further analysis is performed via USB, RS232, GSM or Ethernet interface by means of a proper adapter.
-
Series 100 -
Pickering Electronics
The Pickering Series 100 is a complete range of Single-in- Line (SIL) reed relays primarily intended for direct drive from 4000B CMOS or similar low current sources. They feature a very low level of thermal EMF.
-
HH2705 -
Colluck Company Limited
Pocket size Analog Multimeter. Basic Accuracy 4.0%. 4 Functions / 12 Ranges. Voltage test up to AC500V and DC 500V. Current test up to 250mA. Resistance test R X 1KΩ
-
PPR -
CKD Corporation
This is a digital pressure sensor dedicated to mounting a modular type regulator.Displayed values and set values can be checked at the same time on a 2-screen display.You can check the displayed value (current value) on the main display and the set value on the sub display.
-
CZ20062 -
Aegis Pty. Ltd.
This multimeter is a rugged, weatherproof, digital multimeter (DMM) designed specifically for electricians and electrical contractors. Fully featured and well priced, this DMM should be in everyone's toolbox. Voltage, current, resistance, capacitance, and frequency are all included as standard.
-
8012S -
Sealevel Systems, Inc.
The 8012S PCI digital interface provides eight Reed relay outputs (SPST) and eight optically isolated inputs. Reed relays are well suited for low current applications. The relays are normally open, and close when energized.
-
ABB Ltd.
ABB field indicators provide a convenient way to access the field instruments data when they are located in remote or difficult to access areas. Powered directly from the 4-20 mA current loop, they require minimal effort to setup.
-
Knick Elektronische Messgeräte GmbH & Co. KG.
Especially to accurately measure large DC currents via shunt resistors, ie for making isolated detection of mV voltage on shunts. Variants with calibrated range selection. Working voltage up to 3600 V AC / DC.
-
Knick Elektronische Messgeräte GmbH & Co. KG.
Isolation and 1: 1 transmission of 0/4 ... 20 mA current signals without additional auxiliary power. Also for use in hazardous areas. Particularly high reliability and certified functional safety up to SIL 3 / PLe.
-
DST1000 -
ZOGLAB Microsystem Co., Ltd.
Design for airflow velocity and heat transfer rate Applied to HVAC and clean room High-accuracy,wide-measuring range Wide view angle LCD for sharp display Analog or digital output with current ,voltage and RS485 On line calibration-availability
-
WinSystems, Inc.
A signal conditioning board that provides eight independent SPDT relays, eight isolated outputs, and eight isolated inputs for applications requiring medium current capacity plus I/O isolation between an embedded computer and monitoring/control points.
-
TPWS and AWS -
Mors Smitt Group
The current Network Rail UK protection systems are TPWS and AWS. The functionality of both systems is combined in a single system, generally referred to as TPWS. TPWS comprises of OSS (Overspeed Sensor System) and TSS (Train Stop System).