Showing results: 901 - 915 of 3398 items found.
-
68G6 -
North Atlantic Industries
The 68G6 is a SOSA™-Aligned 3U OpenVPX board that can be configured with up to three NAI smart I/O and communication function modules. In addition to the standard expansion plane (EP) PCIe and control plane (CP) Ethernet control interfaces, the 68G6 facilitates convenient external access to supported NAI PCIe function modules through its 1 x1 PCIe interface, enabling seamless expansion of host SBC functions for enhanced project solutions, while also offering external access to supported NAI FMx modules via a SATA II interface. The 68G6 is on NAI’s certifiable product development roadmap supporting DO-178C and DO-254 design assurance guidelines for safety-critical applications. Ideally suited for rugged Mil-Aero applications, the 68G6 delivers off-the-shelf solutions that accelerate deployment of SWaP-optimized systems in air, land and sea applications.
-
APCI-2016 -
TEAM SOLUTIONS, INC.
16 isolated output channels, 10 to 36 V,. Output current 500 mA? Timer-programmable watchdog for the reset of the outputs to ì0î? One ground line for all outputs? At Power On/Reset, the outputs are set to "0"
-
DB-Audio2 -
ADLINK Technology Inc.
*Realtek ALC262 High Definition Audio codec*Three jacks: line-in, line-out and mic-in*5x2 pin header for cable connection to external audio header on SBC*4-pin header interface for CD audio output
-
Power Manager II -
Lattice Semiconductor
*Up to 12 differential voltage sensors with immunity to noise on ground plane*Voltage trimming to within 1%*Ruggedized CPLD with up to 48 macrocells for sequencing and supervisory signal logic*Large operating power supply range (3.3 V + 20% to 3.3 V -15%)*Up to 4 High-Voltage MOSFET Driver Outputs*Voltage Measurement with 10-bit ADC through I2C*Up to 8 On-chip DACs for Margining and Trimming
-
40-965-901 -
Pickering Interfaces Ltd.
Low cost converter card for 40-736 Data Communications Multiplexer. Adapts the 78-Pin D-type connector on the front of the module to 9 RJ45 sockets. Allows the multiplexing of up to 8 Ethernet signals with speeds up to 1G bit.
-
AmITX-RZ-G -
ADLINK Technology Inc.
*AMD® Ryzen™ Embedded V1000 processor family*Up to 32GB dual SODIMM socket DDR4*PCIe x16, PCIe x1, M.2 and Mini-PCIe expansion*4x DisplayPort
-
CB52 -
CAMI Research Inc. (CableEye®)
The CB52 is intended for periodic calibration verification of the Kelvin 4-wire resistance measurement module – an optional, add-on module that may be purchased with any new hipot system, or added to an existing high voltage tester as an upgrade. To ensure that 4-wire resistance measurements remain accurate, CAMI recommends running the verification check every quarter. A 4-wire measurement module that is out of calibration will give inaccurate results. Some (maybe all) resistance measurements will be incorrect. Consequently, it may Pass what should Fail and, conversely, Fail what should Pass. In other words product yield will be contaminated due to unreliable measurements.
-
CB50 -
CAMI Research Inc. (CableEye®)
Populated with precision resistors, it allows users to determine empirically whether the tester requires calibration. The CB50 may be used on all CableEye models. The CB50 is intended for periodic verification of tester calibration. To ensure that resistance measurements remain accurate, CAMI recommends yearly calibration. However, depending on environmental conditions and usage, testers may need calibrating more or less frequently. Certain components within models M3U, M3UH, HVX, and HVX-21 (i.e. those capable of measuring resistance) are analog components whose characteristics change slightly over time. This aging is a natural phenomenon common to all electronic components and may cause resistance measurements or gradually deviate from normal. A tester that is out of calibration will give inaccurate results. Some (maybe all) resistance measurements will be incorrect. Consequently, it may Pass what should Fail and, conversely, Fail what should Pass. In other words product yield will be contaminated due to unreliable quality.
-
APCI-3001-8-LAC -
TEAM SOLUTIONS, INC.
LACQUERED 8 single-ended or 4 differential inputs 12-bit resolution Optical isolation 500 V 100 kHz data transfer rate Automatic analog acquisition 8 digital I/O, 24 V, isolated, timer Trigger functions Graphical display of the measured data
-
VI Control Systems Ltd.
All channels provide for voltage division ahead of transient suppression before going into the S&H ICs. Channels that are sampled and held use a common sample and hold pulse that samples while high and holds while low. Jumpers on each S&H chip allow buffering of analog signals where sample and holds are not required. An advantage to the buffers is that it provides a high input impedance for high impedance voltage dividers.
-
cPCI-8602 -
ADLINK Technology Inc.
*Supports two single-size 32,64-bit/33,66 MHz PMC sites in 4HP width*PICMG® 2.0 32,64-bit/33,66 MHz cPCI bus*PICMG® 2.1 Hot Swap Specification Compliant*3.3V or 5V V(I/O) for cPCI bus and PMC sites*PLX® PCI-to PCI bridge PCI6154 for PCI bus*Power and HotSwap LED incidators on front panel
-
CEB94022 -
Axiomtek Co., Ltd.
*MXM type A supported*SATA-600*LVDS, VGA, HDMI, and DisplayPort*4 USB 2.0 and 2 USB 3.0*2 PCI Express Mini Card slots*3 RS-232/422/485 and 1 RS-232
-
SMT750 -
Sundance Multiprocessor Technology Ltd.
The SMT700 is one of the first of a new range of Sundance cards that includes a direct connection to SLB (Sundance Local Bus) compatible mezzanine card, without the need for a Sundance TIM. This enables a variety of cards to be added to a system, for example extra Ethernet ports, video in/out, High speed ADC / DAC etc. Data from these extra cards (along with data from the SMT700’s own inputs – up to 1Gb/s Ethernet, 2.5Gb/s optical links, and RSL links) can be processed via the Virtex 5, or by another linked card or module.
-
Lt-C/M3200B -
Teledyne Lumenera
In challenging outdoor imaging applications, having the ability to capture clear images in varying lighting conditions is key. The 7.1 megapixel Sony® Pregius™ IMX428 is capable of large full well capacity and brings increased dynamic range to the Lt-C/M3200B camera. This, in combination with larger pixel sizes, also allows for high levels of detail in low light environments.
-
Lt-C/M1630B -
Teledyne Lumenera
With a high dynamic range and the High Conversion Gain feature of the IMX430 within the Lt-C/M1630B camera, embedded systems can capture images in a variety of lighting conditions. This can be especially useful in factory automation applications like quality control where cameras need to be engineered in tight design spaces. Additionally, by having a high frame rate, production can operate at greater speeds without any worry about the reliability of the image quality.