Showing results: 2881 - 2895 of 7546 items found.
-
LEDLS-60/LEDLS-12 -
Lisun Electronics Inc.
• The tester includes A Group Measuring Module and B Group Measuring Module. The A Group measuring module can test 6pcs LED Driver AC Parameters. The B Group measuring module can test 6pcs LED Driver AC, DC and AC/DC Parameters. • There are 12 windows to display the input and output parameters, it is good for comparing and analyses. • Quick test for all of the parameters in 0.1 seconds. • It can set up the testing parameters PASS/FAIL range, it will have Noise/Light warning if it is Fail. We also supply handle port (Extra cost) • Software communicate with PC (Extra cost)
-
FMT-500 -
Sinton Instruments
Advanced analysis of solar modules including light I-V and Suns-Voc data. Capability to accurately measure high-efficiency modules.
-
Teledyne LeCroy quantumdata
The Teledyne LeCroy quantumdata 980 48G Protocol Analyzer / Generator module for HDMI 8K Testing is equipped with both an HDMI Tx/Output port for TMDS and Fixed Rate Link (FRL) video generation and an HDMI Rx/Input port for TMDS and Fixed Rate Link (FRL) video and protocol analysis. The HDMI Tx and Rx ports support testing of formats up to 8K formats at 1485MHz pixel rates. Full compliance test suites are supported in FRL and TMDS modes for both HDMI sources and sinks.
-
Metravib
Temperature increase in rubber is the principal cause of degradation and can lead to fatigue cracking.
-
40-965-911 -
Pickering Interfaces Ltd.
The 40-965-911 is a converter card for the 40-201 Ethernet/AFDX Fault Insertion Switch. Adapts the 78-Pin D-type connector on the front of the module to 8 RJ45 sockets and one 9-way D-type connector for fault signals. Allows the fault insertion testing of 100 BaseT Ethernet signals.
-
TestingXperts
Integration testing primarily focuses on verifying data communication among different modules of the software project. Integration tests determine the effectiveness and performance of different software modules when they are connected to each other.
-
FMC DIO -
Sundance Multiprocessor Technology Ltd.
The fmc-dio-5chttla 5-channel digital I/O module is a simple board for digital I/O on LEMO connectors. It has been designed for testing White Rabbit functionality as part of the SPEC Demonstration Package for White Rabbit, and it can be used for other general purpose applications too.
-
King Design Industrial Co., Ltd.
Stable solar cells are needed for durability testing of different combinations of module ... cause, the focus fell on light induced degradation (LID) .... module using the same cells as in the initial modules was used.
-
DG Technologies
Fiber Optic converters Electrically isolate signals from the vehicle bus using common bridge and satellite modules interconnected with fiber optic cable for EMI and EMC testing.
-
GenRad 2287 -
Datest
3560 Hybrid Test NodesWindows InterfaceTotal GenRad 227X Migration Capability20 Mhz Clock, Sync, and Trigger, 5 Mhz data ratesVector Test for VLSI, PLCC’s & ASICSTest Express Vectorless TestingMultiple Chain Boundary ScanAnalog Functional Test Module
-
Teledyne LeCroy quantumdata
The Teledyne LeCroy quantumdata 980 HDMI Phy & Protocol Aux Channel Analyzer module supports compliance testing of the HDMI DDC bus and HDMI 2.0 CEC testing (partial support only). The module’s CEC compliance tests enable you to identify compliance failures early in the development cycle. The solution is ideal for pre-testing and self-testing (where permitted) your HDMI 2.0 device. The module also supports compliance testing of the HDMI DDC bus voltage and timing parameters in accordance with HDMI 1.4b. Future releases of the module will support functional tests and compliance tests on other HDMI auxiliary channels.
-
HGH USA
INFRATEST is a powerful software for testing visible to IR cameras, goggles and laser rangefinders. Based on video acquisition modules compatible with a wide range of communication protocols, INFRATEST acquires, displays and analyzes the video signal from all types of electro-optical devices. In addition, INFRATEST manages the optical stimuli delivered to the camera through the control of blackbodies and visible/NIR optical sources and their accessories (collimator, target wheel, harmonization modules, etc.).
-
Acculogic, Inc.
The Relay Expander Module (REM-08) is a powerful, and versatile control module with a wide range of applications. It is designed for use in various capacities for the testing and control of electronic circuitry. The power of the REM-08 is inherent in its ease of use and the great flexibility provided over control and configuration of its general purpose relays.
-
F8200 -
Manta Test Systems
Use the F8200 Power System Simulator for testing single-phase conventional schemes, digital protection systems, and more. This four-module F8000-series instrument is available in four standard configurations of HVA Current, HVA Voltage, and Low-Density Logic I/O modules.
-
Metravib
Resistance to fatigue, ageing and crack growth are major issues for rubber like materials. Current commercial methods for crack growth testing have been restricted to time to failure test.