Showing results: 226 - 240 of 284 items found.
-
EM-6115 | 10 KHz – 2 GHz -
Electro-Metrics Corp.
The EM-6115 is a broad band collinear array allowing very wide Omni-Directional frequency coverage in a single package. Below approximately 100 MHz, the EM-6115 acts as an active vertical rod which offers 10 to 12 dB Greater unsaturated instantaneous dynamic range than competitive antennas (overload field strength: 2 V/meter) which greatly reduces intermodulation generated signals in a typical read world RF environment. In the congested spectrum above 100 MHz the antenna is passive and contributes no intermodulation products so the overload point is determined solely by the receiving instrument. This immunity to overload can often make the difference between useful signal output and an indecipherable jumble of spurious products and is accomplished without compromising sensitivity. The antenna collapses for convenient storage and transport.
-
6900 -
KANOMAX USA, Inc.
Kanomax has developed the most advanced Duct Air Leakage Tester (DALT) for commercial duct systems. It’s designed to be simple to use, accurate, and extremely convenient. The instrument provides step-by-step duct leakage test configuration and automated leakage testing based on the SMACNA HVAC Air Duct Leakage Test Manual, and is accurate to ±2.5% of reading. Though built tough with an on-board, powerful motor, the DALT 6900 is very easy to transport on its pneumatic tires and leaves little to no footprint on the job site.
-
L-RF-MN-RX -
QuestTel
The QuestTel''s L-RF-MN-RX module optical receivers are versatile, low-cost and compact optical receivers for use in HFC fiber applications. It is perfect solution for the transport and distribution of CATV RF signals over fiber optic cable. The L-RF-MN-RX module housed in a small housing and have adjustable RF output level. May be used as a hand held device for testing, or placed at a customers premise for the reception of cable television services. The Receiver is designed to operate with a very low optical input level between the range of +3dBm to -12dBm.
-
dbTENT -
DVTest Inc.
The dbTENT is an easy-to-assemble, store and transport high-performance RF test enclosure. Whether you need to make measurements in the field or in the lab, the dbTENT provides superior 90 dB of isolation over a wide frequency range thanks to its patented double layer conductive fabric design. Featuring an interchangeable customisable I/O panel, the dbTENT meets all your needs for non-permanent isolated testing. With a setup time of only minutes, the dbTENT will get you ready for testing instantly in a wide variety of environments.
-
AMR130 -
Mividi, Inc.
The Mividi® Broadcast Recording and Compliance Logging System (AMR130) provides a cost-effective solution for broadcast compliance monitoring and logging. It is a Windows PC based system that utilizes GPU encoding for low-cost video transcoding. The software supports stream recording, file management, editing and playback. The recorder takes transport stream input from UDP over IP or ASI interfaces, as well as Internet OTT streaming input using HLS, RTMP, RTSP, and MPEG-DASH protocols. A single system can support continuous recording of 30 streams.
-
Mividi, Inc.
The Mividi® Audio Loudness Monitoring and Logging System (Loudness Logger) provides a cost-effective solution for broadcast compliance monitoring and logging. It is a Windows PC based system that supports audio decoding, loudness monitoring and logging, log file management and playback. It takes transport stream input from UDP over IP or ASI interfaces, as well as Internet OTT streaming input using HLS, RTMP, RTSP, and MPEG-DASH protocols. A single system can support continuous monitoring and recording over 50 channels simultaneously.
-
CFIP Marathon II -
SAF Tehnika, As
CFIP Marathon 300 MHz / 1.4 GHz point-to-point long-haul microwave system is the perfect solution for industrial applications where fiber is not available. Primarily designed for remote and rural areas Marathon Full Indoor Unit can establish a link in adverse weather conditions and over long distances, frequently exceeding 100 km. SAF Tehnika Marathon solution is particularly recommended for utility (electricity, water), oil & gas, public safety, and transport companies who are looking for reliable data & voice transmission.
-
EdgeProbe Nano DVB-T/T2 -
TestTree
With its small, compact and easy to handle design, the EdgeProbe Nano DVB-T/T2 is the ideal tool for field technicians to transport in order to validate and monitor 24/7 all points of a DTV network.EdgeProbe Nano is able to monitor DVB-T and DVB-T2 signals through its RF input (144 x 137 mm compact format).Combined with a Network Monitoring System or not, the EdgeProbe Nano provides a powerful broadcast network alert & diagnosis tool allowing DTV network operators to monitor global trends and anticipate potential failures.
-
Lansmont Corporation
Inclined impact testing simulates environmental dynamic forces that packaged goods may endure throughout transport and handling operations. These hazardous dynamics are simulated using impact test systems. Inclined impact test systems utilize a carriage that propels the test sample down a ramp at predetermined velocities before impacting into a fixed backstop. The specimen’s reaction to these extreme conditions indicates how the product would fare in real-world supply chain settings, allowing design engineers to make improvements to either the product and/or the protective packaging as needed.
-
Sataton Instruments Technology CO., Ltd
Sweating guarded hotplate is the textile testing instrument for measuring of thermal and water-vapour resistance properties under steady-state conditions. By testing the thermal resistance and water-vapour resistance of textile materials, the tester provides a direct data for characterizing the textiles’ physiological comfort which involve a complex combination of heat and mass transfer. The hotplate is intended to simulate the heat and mass transfer processes which occur next to human skin and measure the hence transport properties in a steady-state conditions involving combinations of temperature relative humidity, air speed, and in liquid or gaseous phase.
-
ACMAS Technologies Pvt. Ltd.
Weiber xenon lamp chamber uses xenon lamp to simulate the whole sunlight spectrum that can produce many destructive effects on the products. This simulation environment provided in the chamber is used to test the resistance of various manufactured products towards these destructive conditions. This chamber is used for quality control, product development and scientific researches and many more. With a variety of models and options, you can customize your chamber to fit your testing needs. Reach in chambers provide a compact testing area for small applications. These are easy to install, transport and occupies less space.
-
STB Electrical Test Equipment, Inc
From the company who builds the popular analog ground fault detector comes the newest phase rotation indicator on the market. No other manufacturer offers a phase rotation indicator like STB's DX2 that will read up to 5kV! The phase rotation indicator is used to determine the phase sequence of three-phase voltages. This meter is most commonly used for phasing-in a power line which has supplied power to motors and plants. It is essential for testing departments of public utility systems for laboratory and field testing. The convenient and durable carrying case allows user to safely transport the unit to wherever the job takes them.
-
Astronics Corporation
The TS 717 Test Set for ARINC 717 is a convenient, easy-to-use tool for test and maintenance of aircraft systems that are tied to the Digital Flight Data Recorder (DFDR). The compact interface/cable hardware is conveniently stored in a rugged carrying case for easy transport and quick deployment.The webFLT™ is a wireless functional tester for aircraft systems using the Digital Flight Data Recorder ARINC 717 bus. It connects directly to the aircraft system test plug and transfers data to the test computer via an 802.11 b/g wireless link, eliminating cabling in the crowded cockpit that can be tripped over or damaged.
-
cPCIS-2500 Series -
ADLINK Technology Inc.
The cPCIS-2500 series 3U CompactPCI 6-slot Cubic Chassis is designed for 3U CompactPCI cards and modules without rear I/O. It is 4U in height, 237 mm deep, and suitable for bench top use or wall mounting. It is ideal for industrial or transport applications where small chassis size and versatility are important. A built in cooling system with removable filter provides maximum cooling efficiency, and the 250W cPCI power supply allows easy maintenance. The cPCIS-2500 series' ability to handle a wide range of temperatures and excellent shock and vibration characteristics make it suitable for operating in a rigorous environment.
-
InverTS -
ENENSYS Technologies
InverTS is ENENSYS’ DVB-T2 Gateway inverse function that de-encapsulates a T2-MI stream into one or several MPEG-2 Transport Streams over ASI and IP.The InverTS is designed to receive a single PLP or Multiple PLP T2-MI stream over ASI or IP in order to de-encapsulate the T2-MI stream into one or several MPEG-2 TS over ASI and IP. It outputs the MPEG-2 TS encapsulated by a DVB-T2 Gateway.The InverTS can also apply to a lot of use cases wherever applications require to retrieve the genuine and multiple MPEG-2 TS that are carried over the T2-MI stream. It can be operated for re-multiplexing a DVB-T2 stream with regular TS content or for simulcasting the same content over different networks.The InverTS is the ideal product to help monitoring a T2-MI stream either using its optional internal advanced monitoring tools or by connecting it to existing monitoring tools through ASI or IP. The Advanced monitoring option enables to supervise in real-time PLP bandwidth allocation, DVB-T2 transmission parameters and the MPEG-2 TS encapsulated within the T2-MI stream.
