Showing results: 1441 - 1455 of 2477 items found.
-
HH2210 -
Colluck Company Limited
Auto Ranging High Voltage test up to 1000V DC and 750V AC. Higher Current test up to 20A AC/DC. Diode test and Transistor test. Continuity check with buzzer sound. Measure Resistance up to 30MΩWide. Frequency test range up to 300kHz
-
Hanco International
Hanco units provide a full high voltage electrical test as required by OSHA. Front-loading, top-loading and portable units are available.- Sticks can be tested wet or dry.- Test units are available to test sticks up to 14 or 21 feet maximum length or up to 8 feet for the portable unit.
-
Advanced Energy
Explore rack-mount high voltage power supplies that feature IGBT switch mode technology or active power factor correction. And check out our rack-mount modules equipped with disc sets, which are ideal for ion-beam and electron-beam systems and X-ray equipment. Choose from standard modules or customize.
-
LG Series -
Powerohm Resistors, Inc.
The Powerohm LG Series Braking Module offers an economical and compact solution with surprisingly high current ratings reaching up to 300 amps. The standard features of this design include external or internal brake enable, under voltage detection of logic supply, heatsink overtemperature protection and master/slave capability.
-
Naprotek, LLC.
The SemiGen 8000 and 8100 series of MIS Capacitors are available in a wide variety of capacitance ranges and sizes. They are made with prime starting material and consist of an Oxide/Nitride layer that provides low dielectric loss and high standoff voltage. These RF microwave chip capacitor products are available in chip form only.
-
7117 -
Peaceful Thriving Enterprise Co Ltd
This is a low power consumption, high accuracy and stable hand held 6000 counts multi-meter; with special designed IC to support true RMS measurement. It performs measurements of DC voltage/current, true RMS AC voltage/current, resistance, capacitance, frequency, diode, continuity, temperature and non-contact voltage sensing.
-
Jackmark Engineering Ltd.
With the introduction of electric powertrains, Jackmark Engineering has developed a large range of products to support battery pack assembly lines & vehicle assembly plants. We can design and manufacture custom ruggedised non-domestic high voltage connectors & battery charging leads along with functional check and control products.
-
63800 -
Chroma Systems Solutions, Inc.
The Chroma 63800 Loads can simulate load conditions under high crest factor and varying power factors with real time compensation even when the voltage waveform is distorted. This special feature provides real world simulation capability and prevents overstressing resulting in reliable and unbiased test results.
-
PXD7113 -
VX Instruments GmbH
The PXD7113 FlexRay Digitizer features a 100MS/s input with 16Bit resolution, input voltages up to ±10V and a bandwidth up to 10MHz. The PXD7113 FleyRay Digitizer has a 2MB memory which allows up to1 million samples. The device has a high common mode rejection ratio (CMRR).
-
6684A -
Keysight Technologies
Keysight high performance DC power supplies offer speed and accuracy for test optimization. The single output, 5000W, GPIB 6680A-6684A provide low output ripple and noise; selectable compensation for inductive loads; analog control of output voltage and current; and fan-speed control to minimize acoustic noise.
-
V6533 -
CAEN S.p.A.
The V6533 is a 1-unit wide VME 6U module housing 6 High Voltage Power Supply Channels 4 kV, 3 mA (9W max). The board is available with either positive or negative output polarity; mixed version with 3 positive and 3 negative channels is also available.
-
40-972-009-0.5m-FU-HV -
Pickering Interfaces Ltd.
A range of 9-Pin D-Type High Voltage cable assemblies with unterminated connections on one end, constructed from PTFE Type C insulated wire. The unterminated connections are coded to match the connector pin designation and include crimped on ferrules to ensure the wire strands cannot break when they are terminated.
-
40-972-009-2m-FU-HV -
Pickering Interfaces Ltd.
A range of 9-Pin D-Type High Voltage cable assemblies with unterminated connections on one end, constructed from PTFE Type C insulated wire. The unterminated connections are coded to match the connector pin designation and include crimped on ferrules to ensure the wire strands cannot break when they are terminated.
-
40-972-009-2m-MU-HV -
Pickering Interfaces Ltd.
A range of 9-Pin D-Type High Voltage cable assemblies with unterminated connections on one end, constructed from PTFE Type C insulated wire. The unterminated connections are coded to match the connector pin designation and include crimped on ferrules to ensure the wire strands cannot break when they are terminated.
-
40-972-009-0.5m-MU-HV -
Pickering Interfaces Ltd.
A range of 9-Pin D-Type High Voltage cable assemblies with unterminated connections on one end, constructed from PTFE Type C insulated wire. The unterminated connections are coded to match the connector pin designation and include crimped on ferrules to ensure the wire strands cannot break when they are terminated.