Filter Results By:
Products
Applications
Manufacturers
-
product
Resonance Dip Meter
NRM-2
National RF’s Resonance Dip Meter is a test instrument used to determine the resonant frequency of a tuned circuit or resonant network, such as an antenna system. In addition, the unit may function as an RF detector, or a secondary frequency source. The instrument is analogous to the older vacuum tube “grid dip meter,” once popular in every electronic laboratory or radio station. Unique to this updated version is a buffered output that may drive a digital frequency counter for exact measurement of resonant frequency, or connected to an oscilloscope to be used as an RF detector and waveform/modulation monitor.
-
product
FREQUENCY DISPLAY UNIT
TYPE NFD-1
The National RF Type NFD-1 Frequency Display Unit was designed for use with vintage and classic communications equipment, to display the received or transmitted radio frequency. The unit incorporates an internal processor that allows the intermediate frequency (IF) to be counted out by the frequency counter. The resultant display is the actual frequency that the equipment is receiving or operating at.
-
product
MOD MONITOR
TYPE HFX-1
The Type HFX-1 Modulation Monitor is an ancillary piece of equipment, which is used with narrow bandwidth, or older oscilloscopes to allow viewing of RF signals and particularly modulated signals as high as 55MHz. The equipment contains an RF signal source and a broadband mixing circuit which converts the high frequency signal to an intermediate frequency within the oscilloscope’s range. The frequency control dial is simply adjusted until the RF signal is viewed on the scope. BNC connectors are mounted on the rear panel to allow interconnect to the scope and RF probe. This product was previously called "oscilloscope frequency extender" and may be used to view other high frequency signals on older or narrow band scopes.
-
product
Low Frequency RF Impendence Transformers
0 kHz to 3 MHz 100W - 4000W 1 input, up to 7 outputs Step-Up / Step-Down Transformers Impedance matching outputs from 1.2 Ohms to 2500 Ohms Compact Design Compatible with T&C''s Class A 10 kHz - 20 MHz LF Generators & Amps Compatible with Class B 20 kHz - 6 MHz LF Generators & Amps
-
product
RF Plasma Generators & Amplifiers
100 W to 2400 W 13.56 MHz Analog/Digital, RS-232, USB interfaces Low Harmonic Distortion Automatic and Manual Gain Control High Speed Pulsing (Bursting) controls Compatible with T&C''''s Matching Networks GUI Software (complete PC control) Includes all essential RF power/communication cables and mounting brackets Air cooled (Air & Water 1200 W +) Half rack mount or stand alone versions Ideal for: Industrial, Scientific, and Medical Applications
-
product
RF Power Delivery Systems
100 W to 2400 W 13.56 MHz Half rack mount or stand alone versions Air cooled (Air & Water 1200 W +) Analog & Digitial Interface Complete generator & tuner control via front panel GUI Software Includes all essential RF power/communication cables and mounting brackets
-
product
Waveguide Switches
With over 70 years of RF experience, EVERAXIS specializes in designing the most demanding Waveguide Switches in extremely complex systems, including in low quantities.
-
product
Through Bore Slip Rings
Through Bore Slip Rings are used in applications where the customer requires the bore space for some other capabilities (cooling or air media; optical or RF channels, etc.). The Slip Ring can be designed to accommodate a wide variety of bore sizes.
-
product
Swivel Joints
The Swivel Joint is a special type of RF waveguide joint. It is a joint that is limited in rotation angle, compact in size, with low mechanical torque and high peak power capacity.
-
product
Fail Safe Waveguide Switches
Waveguide switches enable very rapid switching between two RF channels. Fail Safe Waveguide Switches return to the de-energized position when the power is disconnected and requires a small holding current in the energized position. All models have low VSWR and high power handling capacity. They withstand the full power rating of the waveguide and most models can be pressurized to 0.2 MPa (2 ATO) for high peak power applications.
-
product
Latching Waveguide Switches
Waveguide switches enable switching between two RF channels. The latching type is stable in both positions without holding current. Manual and automatic (electromagnetic) actuators are available.
-
product
RF Rotary Joints
EVERAXIS is the market leader and supplier of choice for integrated waveguide assemblies, passive microwave components, RF Rotary Joints and rotating subsystems to the military and commercial radar and satcom markets. Working together with customers to create tailor-made solutions optimized to meet their needs has been the EVERAXIS business model for more than 70 years.
-
product
Contactless Slip Rings
EVERAXIS is a major supplier of customized slip rings to meet specific customer requirements for the transmission of power, data, optical and RF signals, including contactless solutions.Our technology offers compact, reduced-size, maintenance-free slip rings capable of operating in harsh environments.
-
product
Fluid Rotary Joints
EVERAXIS Fluid Rotary Joints are designed to operate at extreme pressure and with high flow. The main application is the cooling of radar antennas. Fluid Rotary Joints are commonly integrated into rotary joint systems together with RF rotary joints, FORJ and slip rings.
-
product
MORA Ready Development Platform: CompacFrame Integrated With SOSA Aligned PICs And Sciens Innovations Helux Core RF Tools
SE9M3PS9YIBXNLY
The MORA-Ready Development Platform (MRDP) simplifies the process of creating RF signal processing capabilities and accelerates integration of existing applications. Featuring Sciens Innovations helux™ Core powerful software tools to accelerate RF signal generation and system development.
