Filter Results By:
Products
Applications
Manufacturers
Impulse Generators
produce single electric pulses for device verification and fault detection.
See Also: Transient Generators
-
product
Impulse Generators
HYPERLABS triggerable impulse generators create precise high-speed pulses with 50 to 100 ps rise time. They can be triggered by input from antennas and other signal generator systems.
-
product
Impulse Generators
Provides pulse widths (measured at the 20% rise timepoint) in the range of 130 ps to 2 ns, amplitudes as high as 100 Volts, with pulse repetition frequencies to 1 MHz.
-
product
TRANSIENT & IMPULSE GENERATORS
TIG-7
Criterion Instruments Limited Transient Interference Generator Model TIG-7 produces a high-coltage damped oscillatory waveform to be applied to the unit under test, eg a relay. This waveform simulates the kind of transient experienced in utility and telecommunication switching stations.
-
product
Impulse Generators and Measurement Systems
Designed to generate impulse voltages that simulate lightning strokes andswitching surges as defined by IEC, ANSI/IEEE, and other national standards on:• Distribution transformers• Small power transformers• Cables (type tests)• Arrestors (impulse current tests)• Motors / generatorsTesting ApplicationsImpulse Generators andMeasurement Systems• Insulators• Bushings• GIS• Instrument transformers
-
product
Complete Set of 1200KV/2400KV/4800KV Impulse Voltage Generators
Shanghai Launch Electric Co., Ltd.
The series impulse voltage generators are used for the impulse voltage tests of lightning impulse full wave, lightning impulse chopping, switching impulse voltage wave and steep wave, so as to check the insulation performances.
-
product
GDT Testing
Impulse generators with current outputs for testing gas discharge tubes. Models designed for two terminal and three terminal devices. Generators combine multiple impulse types.
-
product
Impulse Test Generator
SUG-CCITT-A
Impulse Test Generator SUG-CCITT-A (1a. 10/700us, 6KV, figure is according to N.1 in IEC60950-1:2005 Annex N). N.1 ITU-T impulse test generators.
-
product
SPD Testing
Impulse generators with current and voltage outputs for testing complex Surge Protection Devices comprising combinations of varistors, gas arrestors and resistors
-
product
Magnetic Field Testing
Accessory to test generators. Range of coils for testing AC magnetic fields up to 1000A/m or impulse and damped oscillatory wave magnetic fields.
-
product
Varistor Testing
Impulse generators with variable voltage and current outputs for testing disk varistors. Models designed for clamping voltage, energy absorption, surge withstand and combination wave testing.
-
product
Qualification and Quality Control Tests
Techsquare
New IEC standards, IEC 60034-18-41 and IEC 60034-18-42, have been issued to define the procedures for testing partial discharge inception voltage and the long-term performance (endurance) of Type I and Type II insulation systems used in rotating machines fed from voltage converters. Voltage impulse generators are required at least to test turn insulation, but they would be recommended for any testing under power electronics supply because of their capability to simulate the real electrical stress conditions. More generally, any type of electrical insulation system when subject to impulsive voltage waveform during life should be carefully evaluated in terms of partial discharge and endurance behaviour. This is why voltage impulse generators able to provide impulses with controlled amplitude and frequency are needed to face this new testing challenge.
