Showing results: 1 - 15 of 18 items found.
-
Aquila Engineers Pvt. Ltd.
Manufacturer of a wide range of products which include 100 KVA Power Stabilizer, Three Phase Power Stabilizer, Electric Power Stabilizer, Industrial Portable Stabilizer, 50 KVA Power Stabilizer and 100 Kva Power Stabilizer.
-
Aquila Engineers Pvt. Ltd.
We are a leading Manufacturer of Single Phase Servo Voltage Stabilizer, 3 Phase Air Cooled Voltage Servo Stabilizer and Oil Cooled Servo Stabilizer from Vadodara, India.
-
MS 7643 -
Meltronics Systemtech
VSTAB is a voltage stabilizer, regulates the incoming supply +28V voltage into the required +15V. The electrical specifications meets MIL704 standard. Over load and short circuit protections are provided. Voltage stabilizer Module is a part of shipborne unit and it is meant for ensuring the power supply of the devices of this unit when fed from DC mains with nominal voltage of 28 V and variations of voltages from minimum 16V to maximum 32 V. The power consumption is 45 watts. The module is subjected to Qualification Tests as per MIL-STD-810G.
-
ST-1 -
ELMA Electronic, Inc.
Cabinet stabilizers are cast aluminum construction. They extend 10” (254mm) from the base and are adjustable with leveling screw/pads.
-
POS-202 -
General Photonics Corp.
The POS-202 has optical ports for signal input and output. It stabilizes the output SOP to linear, aligned to the slow axis of the output PM fiber.
-
POS-203 -
General Photonics Corp.
The POS-203 has optical ports for signal input and output and a third port for an optical feedback signal. It automatically optimizes the output SOP to either maximize or minimize and optical or electrical feedback signal. It also allows the operator to control the step size, feedback delay, activation threshold, and search algorithm (maximum or minimum) from the front panel as well as remotely via one of the digital interfaces.
-
Series KLR -
Kepco, Inc.
The KLR Power Supply Series are automatic crossover, 1U high, 2400-watt voltage/current stabilizers with a full rectangular output characteristic within the voltage and current ranges listed in the Models Table.For each model a multitude of limit models can be configured. Limit models allow the unit to be configured to maximum settings below the rated voltage and/or rated current. When a limit model is established the unit will not accept programming values above the user-defined limits.The standard KLR Models (no suffix) have built-in GPIB and RS 232 interfaces. The E-Series models (suffix E) have built-in GPIB and LAN interfaces. The LAN interface is an ethernet-based interface that allows multiple-user access via a standard web browser.
-
Series CC -
Kepco, Inc.
These current stabilizers with built-in, dual range current-sensing resistors and a full complement of meters and controls, are 1/6-rack size units designed to plug directly into their own carrier cases and rack adapters. These power supplies offer ultra low noise and ultra low ripple at the output and are MIL-STD-461 compliant.
-
Spectronix
The Phase Modulation Capable RF Driver / Stabilizer is an eight channel, two phase RF driver intended to drive devices such as the Harris H-401. The driver provides both amplitude and phase modulation capabilities in a single unit. The device can be operated in driver mode where the operator has full control over amplitude, frequency, and phase, or in stabilizer mode where the driver automatically adjusts the operating parameters based on optical feedback from an optical pick-off point.
-
STEVE-6D -
Image Engineering GmbH & Co. KG
STEVE executes controlled movements and delivers results about the performance of a camera's image stabilizer. The included control software includes an automated analysis and can also operate the Digitus, a device for automated triggering of a camera.
-
Series PRM -
Kepco, Inc.
These units are modular ferroresonant MIL-STD-461-compliant voltage stabilizers which obtain their source-isolated, overload-protected output from Kepco's proprietary transformer, Flux-O-Tran. This design lends itself to custom volt-ampere combinations, consult factory.
-
V2002 -
Guzik Technical Enterprises
The spinstand V2002 with the media-testing automation loads and unloads the cap of the vacuum chuck1 and moves the disk stabilizer shroud on and off media without operator’s intervention. As a result, less time is required for a media replacement, so the same number of disks can be tested faster.
-
Parker Hannifin Corp.
Parker's Aerospace actuator and cylinder selection comprises hydraulic, pneumatic, and electromechanical actuators and cylinders. It offers industrial cylinders and linear, electrohydraulic, and electrohydrostatic actuators, including devices such as hydraulic servoactuators, flight-control, mechanical-input, stabilizer, variable-bypass, vane, and thrust-reverser actuators or actuation systems.
-
Series PCX-MAT -
Kepco, Inc.
These voltage stabilizers with a full complement of meters and controls, are 1/6-rack size units designed to plug directly into their own carrier cases and rack adapters. Seven models are available. These power supplies offer ultra low noise and ultra low ripple at the output and are MIL-STD-461 compliant. A modular version of PCX-MAT called PCX is also available. Contact Kepco for details.
-
Series BHK-MG -
Kepco, Inc.
Kepco's BHK-MG are high voltage, linear, voltage-current stabilizers with rectangular (automatic crossover) output characteristic and ultra low noise and ultra low ripple at the output. All models are MIL-STD-461 compliant. They are offered in two sizes: a 40 watt half-rack design and a 200 watt full-rack power supply. The four models in each size have outputs of 0-300 volts, 0-500 volts, 0-1000 volts and 0-2000 volts. Both digital and analog programming control is featured.