Filter Results By:
Products
Applications
Manufacturers
- Pickering Interfaces Inc.
product
50-Pin D-Type Fem with Backshell, HV
40-960-050-F-HV
This connector is designed to allow users to directly terminate cables with soldered connections.
-
product
68-Pin SCSI Micro-D Fem. Right Angle PCB
40-963-068-RF
Accessory allows a user to create their own PCB based termination solution mounted directly on the front of the product or on the end of a cable. Interfacing PCBs should be designed with suitable clearances for the voltage the application requires.
-
product
Test System Optimized for High Throughput, Low Cost of Test for Single Site, Multi-site and Index Parallel Applications
ETS-88RF
Targeting the needs of power amplifier (PA) and front-end-module (FEM) semiconductor manufacturers, the ETS-88RF test system is aligned with the test challenges associated with these direct RF radio wave interface components. The precision with which the ETS-88RF can measure high-gain, wideband frequency performance, adjacent channel leakage and power supply efficiency makes this test system the most cost-effective alternative to bench set-ups. Teradyne routinely provides timely updates to a substantial library of RF Standards (such as 802.11xx and 3GPP) targeted for PA and FEM test.
-
product
Waveguide Rotary Joints
Waveguide Rotary Joints are used for the rotary transmission of power and signal between the stationary and rotating parts of a radar or satcom system.EVERAXIS has designed and produced single and multi channel Waveguide (WG) Rotary Joints since 1958. Every new design is simulated in FEM software as well as physically tested for optimal performance. Each high power Waveguide Rotary Joint is tested at maximum peak power before shipment.
-
product
Software
ThreeParticle
Imagine 3D simulation would be easy to learn in a few days, entry barriers would be minimal, and applications almost limitless. This is already a reality with our revolutionary ThreeParticle ™ software . In a single simulation platform, the Discrete Element Method (DEM) can be used to simulate multi-physical systems with complex particle shapes, including multi-body dynamics (MBS), structural mechanics (FEM) and liquids (CFD) - without coupling to external packages. The simple and intuitive operation via a new user interface is the daily routine of simulation.