Filter Results By:
Products
Applications
Manufacturers
Aerosol
a colloid dispersed in gas.
-
product
Cloud Height Instruments
Bristol Industrial & Research Associates Ltd
Ceilometers are stand-alone instruments designed to measure cloud and aerosol height profiles using a laser based LIDAR (Light Detection And Ranging) technique. The light emitting component is a low power diode laser with the output power limited to an eye-safe level. They determine cloud base heights, penetration depths, mixing layer height and vertical visibilities. Within their operating range they reliably detect multiple cloud layers and cirrus clouds.
-
product
eVe LIDAR
eVe LIDAR aims to provide the ESA-Aeolus mission with a flexible, mobile reference ground-based LIDAR system capable of providing well-characterized fiducial reference measurements of aerosol optical properties
-
product
Masks Bacterial Filtration Efficiency Tester
Sataton Instruments Technology CO., Ltd
Face Masks bacterial filtration efficiency BFE tester is to determine the bacterial filtration efficiency (BFE) of medical face mask materials by employing a ratio of the upstream bacterial challenge to downstream residual concentration of the tested medical face mask materials. The tester provides certain flow rate of bacterial aerosol. The operator can measure the number of colony forming units passing through the medical face mask material, which is clamped between a six-stage Anderson cascade impactor and an aerosol chamber, expressed as a percentage of the number of colony forming units present in the challenge aerosol.
-
product
Proton Induced X-ray Emission (PIXE)
Elemental Analysis Incorporated, utilizing Proton Induced X-ray Emission (PIXE), provides a non-destructive, simultaneous analysis for the 72 inorganic elements from Sodium through Uranium on the Periodic Table for solid, liquid, and thin film (i.e. aerosol filter) samples. The PIXE technique offers the advantage of analysis, without the necessity for time consuming digestion, thereby minimizing the potential for error resulting from sample preparation.
-
product
Laser Type PM Sensor
SN-GC
Panasonic Industrial Devices Sales Company of America
Panasonic’s Laser Type Particulate Matter Sensor has a very small footprint of W37 x D37 x H12 mm, and can be used to detect a wide variety of particulate matter including but not limited to dust, fly ash, soot, smoke, aerosols, fumes, mists and condensing vapors, solid fuels, construction materials, cooking/smoking of plant matter, fireplaces and furnaces, house/forest fires, waste incineration and much more.
-
product
Aerosol Particle Monitor
AES-1000
The Kanomax Aerosol Particle Monitor features an easy-to-read display, can connect to a network via ethernet, and offers simplified monitoring of particulates at multiple locations.
-
product
Bio-Threat Detection & Collection
IBAC 2
The IBAC 2 is a fully automated bio-detection sensor that can support continual, 24/7, air monitoring or can be set to targeting sampling windows to align to hours of operation. It alarms in less than 60 seconds when a bio-threat is present. IBAC can be configured to support automated aerosol sampling either in conjunction with its’ triggered alarms or at a set frequency sampling time. In wide service throughout the world, IBAC 2 is used to collect and detect aerosolized agents for all four classes of biological threats (spore, viral, cellular, and protein toxins) with low false alarm.
-
product
Aerosol Smoke Dispenser
Solo 330
Fundamental to functional smoke checking for many professionals around the world the Solo 330 contains the test aerosol and ensures that it is applied correctly and contained only where required. Used with the access poles it enables safe testing at heights but is equally valued at low level.
-
product
Aerosol Monitor
DUSTTRAK DRX-8533
Real-time dust monitoring takes a giant leap forward! Only the DUSTTRAK™ DRX Aerosol Monitor 8533 can simultaneously measure both mass and size fraction - no other monitor can do both. The DUSTTRAK DRX desktop monitor is a battery operated, data-logging, light-scattering laser photometers that gives you real-time aerosol mass readings. It uses a sheath air system that isolates the aerosol in the optics chamber to keep the optics clean for improved reliability and low maintenance.
-
product
Digital Dust Monitor
3443
The Kanomax Digital Dust Monitor – Model 3443 measures aerosol concentrations corresponding to PM10. The intake isolates the aerosol sample so that the optics chamber is kept sterile for improved reliability and low maintenance. The unit measures 0.1 to 10µm particle size aerosol contaminants such as fumes, dust, smoke and mists. It is battery-operated, data-logging, light-scattering laser photometer that gives you real time aerosol mass readings. It is also suitable for clean office settings well as harsh industrial workplaces, construction and environmental sites, and outdoor applications.
-
product
Handheld Ultrafine Particle Size Distribution Measurement.
partector 2 Pro
Naneos Particle Solutions gmbh
The naneos partector 2 Pro version is a further development of the well-established Partector 2. The Pro version of the partector 2 can additionally switch through different deposition voltage levels and therefore scan an 8-channel size distribution of an aerosol of interest.
-
product
Adaptive Infrared Imaging Spectroradiometer
AIRIS
The Adaptive Infrared Imaging Spectroradiometer (AIRIS) has been developed for real-time standoff detection of chemical vapors and biological aerosols as well liquids and solids (such as chemical agents and trace explosive residues) on surfaces.
-
product
Thermal-Optical Analysis
As with other current organic carbon and elemental carbon (OC/EC) procedures, Thermal-Optical analysis is method-defined. However, this unit has been designed to specifically address some of the problems observed in other methods in assigning carbon to either the organic or the elemental fraction. By careful system control and continuous monitoring of the optical absorbance of the sample during analysis, this method is able to both prevent any undesired oxidation of original elemental carbon and make corrections for the inevitable generation of carbon char produced by the pyrolitic conversion of organics into elemental carbon. The OC/EC instrument utilized by EAC is used to analyze both bulk samples, and aerosol particles collected on quartz-fiber filters.
-
product
Spray Particle Size Analyzer
Spraytec
Malvern Panalytical's Spraytec laser diffraction system allows measurement of spray particle and spray droplet size distributions in real-time for more efficient product development of sprays and aerosols. It has been specifically designed to address the unique requirements for spray characterization and deliver robust, reproducible droplet size data.
-
product
Mask Testing Instrument(N95,KN95,Disposable Mask)
Sanwood Environmental Chambers Co ., Ltd.
Is used to test the filtration level of aerosol particles by respirator filter element under certain environmental conditions.
-
product
Piezobalance Dust Monitor
3520 Series
The Kanomax Piezobalance Dust Monitor 3521/3522 is a unique respirable aerosol monitor, providing direct mass concentration of particulates using PIEZOBALANCE technology; ideal especially for oil mist monitoring. The Kanomax 3521 is equipped with 4 and 10µm impactors while the 3522 is equipped with a 2.5µm impactor. Unlike conventional dust meters, which count particles, a piezobalance dust meter like the 3521 or 3522 “weighs” mass concentration of particulates. As an air sample enters the system, it travels through the impactor, which captures and removes larger particulates away from the sample. Smaller particulates become electrically charged and deposited on the piezo-crystal. The total mass of the deposited particulates affects the piezo-crystal’s frequency. Since the change in frequency is proportional to the mass of the particulates, the actual weight of the particulates is obtained.
-
product
Aerosol Optical Tweezers
Bristol Industrial & Research Associates Ltd
Biral Manufacturers Aerosol Optical Tweezing instruments that offer the ability to study individual particles over indefinite periods. Developed in collaboration with the Bristol Aerosol Research Centre at the University of Bristol the instruments are used in research applications such as atmospheric chemistry, pharmaceutical drug development and basic aerosol research.
-
product
Aerodynamic Particle Sizer (APS)
3321
The Aerodynamic Particle Sizer® 3321 (APS™ spectrometer) provides high-resolution, real-time aerodynamic measurements of particles from 0.5 to 20 microns. These unique particle sizers also measures light-scattering intensity in the equivalent optical size range of 0.37 to 20 microns. By providing paired data for each particle, the APS spectrometer opens up exciting new possibilities for those interested in studying the makeup of an aerosol.
-
product
Sunphotometers
SP02 & SP02-L
The Middleton Solar SP02 Sunphotometer is a simple low-cost instrument for the determination of the spectral optical depth of the atmosphere. It can be configured for total & aerosol optical depth measurement, column ozone measurement, and assessment of water vapour amounts. It consists of four precision spectro-pyrheliometers axially aligned in a sealed enclosure.
-
product
Biological Wide-area AeRosol Detector
BioWARD
Standalone sensor in weatherproof enclosure detects thermal objects with consistent appearance/behavior to a bioaerosol plume and determines a threat probability
-
product
Quality & Dust Monitor
To assess aerosol concentrations of contaminants such as dust, smoke, fumes and mists.
-
product
DRX Aerosol Monitor
8534
Real-time dust monitoring takes a giant leap forward! Only the DUSTTRAK™ DRX Aerosol Monitor 8534 can simultaneously measure both mass and size fraction - no other monitor can do both. The DUSTTRAK DRX handheld monitor is a battery operated, data-logging, light-scattering laser photometers that gives you real-time aerosol mass readings. It uses a sheath air system that isolates the aerosol in the optics chamber to keep the optics clean for improved reliability and low maintenance.
-
product
Advanced Aerosol Neutralizer
3088
Aerosol neutralization is an important component of aerosol science and engineering. Neutralizing aerosol particles can reduce electrostatic losses of particles within tubing or to other surfaces. Neutralization is also critical to gathering reliable particle size data when using a sizing instrument based on electrical mobility.
-
product
Automated Filter Tester
3140-1
The model 3140 filter tester uses the same aerosol generation technology as the model 8130A respiratory filter tester. It works with Emery oil, DOP, DEHS, paraffin and other oils. Two new generation CPCs simultaneously count upstream and downstream particles. This enables accurate, repeatable and fast measurements, for example a HEPA filter can be tested in less than 15 seconds.
-
product
Aerosol Neutralizer
3077A
The Aerosol Neutralizer model 3077A is a general-purpose radioactive neutralizer suitable for use with highly-charged and/or highly concentrated aerosols. The Model 3077A can be used with flows up to 5 L/min. If your flow rate will always be significantly higher than this, consider model 3012 and/or 3012A. If your particles will not be highly-charged and/or highly concentrated, consider model 3077.
-
product
Aerosol Neutralizer
3054A
The Aerosol Neutralizer Model 3054A is a radioactive neutralizer suitable for use with highly-charged and/or highly concentrated aerosols in flows up to 150 L/min. If your flow rate will always be significantly lower than this, consider model 3012 and/or 3012A. If your particles will not be highly-charged and/or highly concentrated, consider model 3054A.
-
product
Environmental Enclosure
8535
The custom designed, weatherproof DUSTTRAK™ Environmental Enclosure 8535 protects the DUSTTRAK II and DRX Aerosol Monitor Models 8530 and 8533. This environmental enclosure allows you to make the same accurate and precise measurements outdoors or in harsh industrial environments.
-
product
Aerosol Neutralizer
3077
Aerosol neutralization is an important component of aerosol science and engineering. Neutralizing aerosol particles can reduce electrostatic losses of particles within tubing or to other surfaces. Neutralization is also critical to gathering reliable particle size data when using a sizing instrument based on electrical mobility.
-
product
Aerosol Neutralizer
3054
Aerosol neutralization is an important component of aerosol science and engineering. Neutralizing aerosol particles can reduce electrostatic losses of particles within tubing or to other surfaces. Neutralization is also critical to gathering reliable particle size data when using a sizing instrument based on electrical mobility.
-
product
Aerosol Neutralizer
3012
Aerosol neutralization is an important component of aerosol science and engineering. Neutralizing aerosol particles can reduce electrostatic losses of particles within tubing or to other surfaces. Neutralization is also critical to gathering reliable particle size data when using a sizing instrument based on electrical mobility.
