Filter Results By:

Products

Applications

Manufacturers

Analyzers

examine data methodically by separating into parts and studying their interrelations. AKA: Analysers

See Also: Analyze, Analytics, Analysis


Showing recent results 2671 - 2685 of 3077 products found.

  • AC Hipot w/ Ground Bond Test Capability

    HypotULTRA® Series - Associated Research

    In a world where data is king, HypotUTLRA improves traceability with on-board data storage and allows you to automate hipot testing with a variety of communication interfaces. Increase efficiency with our direct barcode scanner connection and intuitive touch screen interface. Models 7804 and 7854 are a 4-in-1 solution with the addition of 40A AC Ground Bond test capability added to HypotULTRA's already impressive feature list. HypotULTRA is a dielectric analyzer designed to take your production line to the next level.

  • Transient Limiters

    Com-Power Corporation

    Transient limiter LIT-153A and LIT-930A protects a spectrum analyzer input from high-level transients from the line impedance stabilization networks during EMC conducted emissions testing. It has a combined frequency range of 9 kHz to 30 MHz. The built in high pass filter helps reduce 50/60 Hz line feed through. (see application notes)

  • AC Power Sources

    Compact iX Series - California Instruments

    The Compact iX Series represents a new generation AC and DC power source that addresses increasing demands on test equipment to perform additional functions at a lower cost. By combining a flexible AC/DC power source with a high performance power analyzer, the Compact iX Series is capable of handling complex applications that have traditionally required multiple systems.

  • Current Sources

    CS Series - California Instruments

    The CS Series represents an advanced AC current source that addresses increasing demands on manufacturers to test products using real-world current profiles. By combining true current transconductance amplifiers with an advanced digital controller and harmonic power analyzer, CS Series current sources are capable of performing tests that would traditionally have been difficult to accomplish.

  • XYZ Color Sensor

    AS7261 - ams AG

    Calibrated XYZ color sensor provides complete, integrated platform for handheld color analyzers, color calibration and mobile analysis devices. Tri-stimulus XYZ realized by silicon interference filters. UART or I²C slave digital Interface. 16-bit ADC with digital access. Programmable LED drivers. 20-pin LGA package 4.5mm x 4.7mm x 2.5mm, with built-in aperture. Compact true-color sensing. Applications; Color/CCT sensing, Fluid or reagent analysis, Color point comparison, Display calibration.

  • Harmonic Mixers

    HXI, llc

    The HHM series of broadband harmonic mixers covers full waveguide bands from 26.5to 110 GHz. The mixers utilize a low loss finline structure mated to a GaAs Schottky beam lead diode for minimum conversion loss and maximum bandwidth. The millimeter wave RF frequency is down converted (using a lower microwave LO frequency) to an intermediate frequency (IF) which can in turn interface with a spectrum analyzer, frequency counter, etc.

  • Tone Generator

    ComTekk Engineering, LLC.

    Control and test 2-way radio systems, repeaters, ANI, Paging and more. Activate 2-tone or 5/6-tone pagers. Operate or test EIA tone-remote systems. Record generated signals to a WAV file Accomplish MORE, by carrying LESS hardware in the field. Monitor inputs and outputs with our FREE built-in audio scope and spectrum analyzer. No external hardware required. Output may be fed directly into radio, twisted pair, or service monitor.*

  • Extrel RGA

    Extrel CMS, LLC

    The Extrel RGA is a reliable, easy-to-use residual gas analyzer that includes full range pressure measurement. It is the best performing RGA at an affordable price, which makes the system an ideal choice for background gas analysis, leak detection and vacuum chamber characterization. The Extrel RGA is available in two (2) mass ranges, 1 to 100 amu or 1 to 300 amu. The system comes standard with a Faraday detector or an optional dual Faraday/Electronic multiplier detector.

  • Driver Fatigue Analysis Alarm Device

    FIRS Technologies(Shenzhen) Co.,Ltd.

    The driver fatigue analysis alarm device, designed based on the intelligent video analysis technology, is composed of the intelligent video surveillance camera and analyzer. Camera is used for captures of the facial image, and accurate locating of the driver's eyes. This product can make automatic estimation and analysis of the state of the eyes to judge the fatigue degree according to pre-set rules. If eyes' closing time reaches the alarming value, the product then will automatically alarm to warn the driver. Meanwhile, the alarm information will be sent to the back-end monitoring center.

  • Solar Test Systems

    Princeton Applied Research

    Ametek Scientific Instruments manufactures a range of application specific XM (Xtreme Measurement) products focused on solar cell / photovoltaic research (developed in collaboration with Professor Laurie Peter of the University of Bath, UK). These products are so versatile that they can also be used for photoelectrochemical (PEC) water splitting applications; and make use of Solartron’s unique high performance XM specified potentiostats and frequency response analyzers to provide a full complement of techniques for research into energy, corrosion and analytical electrochemistry.

  • Maintenance & Service

    Teledyne Advanced Pollution Instrumentation

    Get peace of mind with preventative maintenance procedures that when performed regularly, will help to ensure your analyzer continues to operate accurately and reliably over its lifetime.Proactive maintenance at scheduled intervals is key to your equipment’s accuracy and longevity. Pre-planned, periodic maintenance provides cost control with complete trust that your equipment is achieving:Consistent, accurate resultsExtended instrument lifeEliminate premature replacement of equipment.The best performance possibleEquipment downtime is decreased and the number of major repairs are reduce

  • Handheld Test Instruments for HDMI

    780 Series - Teledyne LeCroy quantumdata

    The Teledyne LeCroy 780 series handheld test instruments for HDMI® are battery powered (except 780C, 780D and 780E), portable video and audio generators and HDMI analyzers that enable you to conduct quick, on-site verification testing and troubleshooting of your HDMI system and analog video displays. The 780 series instruments are equipped with both a reference source and a reference sink interface allowing you to test audio, video and protocols of any type of digital video device: sources, repeaters and sinks.

  • Frequency Converter

    FC5-29M - Elmika

    Frequency converter FC5-29M is a measurement instrument which is designed for spectrum conversion of 75 - 170 GHz to 1 MHz ÷ 2,6 GHz range and automatic frequency measurement of sinusoidal signals. When combined with the 1 MHz - 3,0 GHz spectrum analyzer, FC5-29M can be used for examination of the continuous and periodically repeating pulse signals.The instrument is meant to be used for measurement of various signal sources, radio-transmitting instruments, synthesizers, frequency converters, measurement generators and also for adjustment and verification of various radio-transmitting or communication instruments in laboratory and workshop conditions.

  • Maintenance & Test Equipment

    Mors Smitt Group

    The D-dock system consists of a D-dock Test Block which is put between the existing relay socket and the existing D-U plug-in relay. All 14 relay-pins are wired to the Break-Out Box enabling to connect measuring equipment like multimeters, scope meters or data analyzers to log operations during longer period. This makes fault finding easy. The D-dock fits in tightly packed relay panels and small cabinets. It can operate unattended enabling normal passenger operating service.

  • Power Line EMI Adapters

    OnFILTER, Inc.

    How much EMI noise is on your power lines indeed?  How to assess the levels of noise and its properties when it is obviously a bad idea to connect your oscilloscope or a spectrum analyzer directly to your power lines?Our EMI interface adapters provide a barrier for high mains voltages but a straight passage for high-frequency signals so that you can connect your sensitive instrument to power lines for analysis and quantification. We offer plug-in and hand-held adapters which can measure both differential ("normal") and common-mode noise.