Showing results: 496 - 510 of 925 items found.
-
CDCM100A-2 -
Systems Engineering & Management
The CDCM100A Series Down-Converter is an IP-67 rated device designed for installation on antenna pedestals. It is a pressurized, water-proof module designed for use with antennas that have a Tri-Band Feed. The CDCMA100 Series Down-Converter is a block down-converter supporting 1415-1585 MHz, 1650-1850 MHz, 2185-2485 MHz and 4400-5250 MHz, down-converting 4400-5250 MHz to 300-1150 MHz.
-
E7000A -
Deviser Instruments
The E7000 Series of Cable & Antenna Analyzers provide all of the necessary measurement functions and performance to accurately diagnose and verify the site's cable feedline, connectors and antenna system, including signal reflections (return loss or VSWR), fault location (distance to fault), cable loss and RF transmission power in a lightweight, handheld instrument.
-
-
-
TR70 Series -
Systems Engineering & Management
The TR70 series of telemetry receiver products are stand-alone, multi-channel, multi-band systems designed for use with fixed antennas.
-
TR70RM Series -
Systems Engineering & Management
The TR70RM series of telemetry receiver products are stand-alone, multi-channel, multi-band systems designed for use with fixed antennas.
-
RefRad X -
Seibersdorf Labor GmbH
A comb generator is built inside a conical antenna element. Therefore no cable between antenna and generator is required. Thus leads to repeatable measurement results and reliable simulation of radiation performance.Optionally a fibre link for synchronisation with the receiver is used.Frequency Range 10 kHz - 3 GHzFrequency Spacing 10 kHz, 1 MHz, 5 MHz
-
XGtd® -
Remcom Inc,
XGtd is a general purpose ray-based electromagnetic analysis tool for assessing the effects of a vehicle or vessel on antenna radiation, predicting coupling between antennas, and predicting radar cross section (RCS). It is ideally suited for applications with higher frequencies or very large platforms where the requirements of a full physics method may exceed available computational resources.
-
-
AFJ Instruments
High accuracy CISPR 16-1-1 EMI receivers and high precision calibrated antennas for radiated emission measurements.
-
ifm efector, inc.
- Wide range of interfaces for RFID evaluation units- Robust antennas and ID tags with long writing / reading distance
-
Psiber Data Systems
The SignalScout (SS40) provides fast and accurate measurement of signal strength when tuning an antenna for a local TV channel.
-
West Coast Custom Designs, LLC
When the antenna and/or the Disc are touched to the tubing wall or electrode wires, the tester will cause the viable tubing to illuminate.
-
Praxsym
Low Noise Pre-Amplifier and companion external low noise amplifier (LNA) are used to amplify low level microwave signals. The Pre-Amplifier contains an AC/DC power supply, internal low noise amplifier, and a bias tee to source a DC bias voltage on the RF input connector.To overcome cable loss between the test antenna and the Pre-Amplifier assembly, a remote low noise amplifier (LNA) is mounted directly onto the 10 GHz antenna. A bias tee inside the Pre-Amplifier chassis powers the remote LNA through the coax cable interconnecting the pre-amplifier and the 10 GHz test antenna.
-
R3755A / R3760 -
Advantest Corp.
low in cost and with a space-saving design, measures and evaluates the frequency characteristics of receiving/transmitting antennas and filters, which are used for wireless communications such as mobile phones, WiMAX, WiFi, and ETC systems for ubiquitous communication. evaluates the frequency characteristics of electronic components, such as the crystal resonator and ceramic resonator used in a broad range of electronic equipment, as well as antennas for receiving/transmitting wireless signals.