Filter Results By:

Products

Applications

Manufacturers

Showing results: 1726 - 1740 of 2362 items found.

  • RTD Thermometers

    CHY firemate Co., Ltd.

    Automatic, positive implied, negative polarityindication.Low battery indication: The “ ” is displayed when thebattery voltage drops below the operating level.Measurement rate: 1 times/second.Operating environment: 0°C to 50°C at<70% R.H.Storage temperature: -20°C to 60°C, 0 to 80% R.H. withbattery removed from meter.Accuracy: Stated accuracy at 23°C±5°C, <75% R.H.Battery: 1.5Vx4pcs AAA size.Dimensions: 160mm(H) x 83mm(W) x 38mm(D).Weight: approx. 255g including batteries.

  • SparkFun RP2040 MikroBUS Development Board

    SparkFun Electronics

    The SparkFun RP2040 mikroBUS Development Board is a low-cost, high performance platform with flexible digital interfaces featuring the Raspberry Pi Foundation's RP2040 microcontroller. Besides the Thing Plus or Feather PTH pin layout, the board also includes a microSD card slot, 16MB (128Mbit) flash memory, a JST single cell battery connector (with a charging circuit and fuel gauge sensor), an addressable WS2812 RGB LED, JTAG PTH pins, four (4-40 screw) mounting holes, our signature Qwiic connectors, and a mikroBUS socket.

  • Stick Meters

    Fieldpiece Instruments, Inc

    Stick Meter and is packed with the portability, toughness and modular expandability HVACR professionals expect. This slim-shaped digital multimeter fits easily in your pocket or on your belt in the included case. Features most of the electrical parameters you use everyday including microamps DC for flame rectifier diode tests and capacitance for motor-run and motor-start capacitors. It’s a manual ranging meter and features a rugged ABS plastic housing with an O-ring to block contaminants, MAX hold, hi-voltage and continuity LEDs and beepers, and auto power-off (APO) to conserve battery life.

  • Switching Regulators

    Analog Devices Inc.

    Analog Devices offers a wide range of switching regulators that operate in step up (boost), step down (buck), and inverting modes. These devices are capable of generating a fixed or adjustable output voltage, and offer up to 2 A of output current. Some of the features available in ADI’s portfolio of switching regulators are low battery detector, user adjustable current limit, a variety of switching frequencies, and a reduced number of external components. This highly integrated, versatile family of products is intended to minimize external components for space challenged applications.

  • Thermocouple Thermometers

    CHY firemate Co., Ltd.

    Polarity: Automatic, positive implied, negative polarityindication.Low battery indication: The “ ” is displayed when thebattery voltage drops below the operating level.Measurement rate: 1 times/second.Operating environment: 0°C to 50°C at<70% R.H.Storage temperature: -20°C to 60°C, 0 to 80% R.H. withbattery removed from meter.Accuracy: Stated accuracy at 23°C±5°C, <75% R.H.Battery: 1.5Vx4pcs AAA size.Dimensions: 160mm(H) x 83mm(W) x 38mm(D).Weight: approx. 270g including batteries.

  • Voltage Calibrators

    Practical Instrument Electronics, Inc.

    PIE has a voltage calibrator to fit your needs from the PIE 235 voltage and pH simulator to the advanced troubleshooting capabilities of the PIE 532 milliamp and voltage calibrator. The PIE 532 includes our patented Loop Diagnostic Technology! All the voltage/milliamp calibrators have fuse-less protection, rugged design and long battery life. With the PIE 535, source 4 to 20 milliamps or 10 to 50 milliamps into loop instruments and drive final control elements such as valves and actuators with up to 42 volts.

  • XP2i Digital Pressure Gauge

    AMETEK Sensors, Test & Calibration

    We provide some of the world’s most popular XP2i digital test gauges for a variety of applications and markets. Included are intrinsically safe "percent of reading" gauges, process gauges, differential pressure gauges, panel mounted gauges, and gauges specifically designed for use in the maritime industry. Whether you’re looking for a gauge with long battery life to mount in hard to reach locations, a gauge to collect and store readings in the field in extreme conditions, or one that doesn’t require recalibration for up to three years, we have the perfect gauge for you.

  • Isolation Measurement System

    DM-8000H - IWATSU Electronic Co., Ltd.

    *The input block, control block and display block are isolated with optical fiber cables. (DM-900A/AL, DM-910A/AL)*Frequency bandwidth: DC to 500MHz.*Simultaneous multi-channel measurement of many channels of different reference potentials. (2 to 24 channels) (DM-900A/AL)*Long-life battery drive. (The system can be driven by three batteries for about 12 hours) (DM-900A/AL, DM-910A/AL)*Measurement using long memory. (DM-900A/AL, DM-910A/AL)*Simultaneous measurements of the inverter's switching waveform and ON-voltage. (DM-910A/AL)

  • 50 Ohm Bridge / Freq Counter

    HecKits

    * Generates a 3 to 30 MHz low level signal displayed on small 8 x 2 LCD * 50 ohm bridge supports tuning 50 ohm antennas * Adjust POT to find the resonate frequency of antenna * 30 turn POT allows easy smooth frequency adjustment * Bright red LED extinguishes when bridge is balanced * Function switching allows for use as frequency counter * 50 ohm termination included * measures 5.5 x 2.5 x 1.1 inches * 9 volt battery operation

  • Active FET Probe Kit 1.2 GHz, 10x, ±40 V

    CT4121 - Cal Test Electronics

    The CT4121 is a compact FET probe with very high input resistance and low input capacitance. With a 1.2 GHz bandwidth, this probe is ideal for timing analysis or troubleshooting high speed logic circuits, for design verification of disk drives, as well as for wireless and data communication design. The CT4121 can measure up to ±40 V (DC + AC peak). Compatible with oscilloscopes from all major manufacturers, the probe is powered by the included 9 V battery or direct from the oscilloscope using the included USB power lead.

  • CANdo Module

    Auto - CanDo

    The CANdo AUTO Module is a rugged, multi-purpose CAN bus module with a USB port, two precision analogue inputs & a DC power supply input. The module is capable of operating either connected to a PC, or in a standalone mode powered from a 12 or 24V DC supply, such as a vehicle battery. The module maybe used as an interface between a PC & a CAN bus, or between analogue sensors & a CAN bus, in standalone mode. In addition, the module maybe programmed to transmit fixed, periodic CAN messages automatically on power up.

  • Smart G-Scope

    Dou Yee Enterprises (S) Pte Ltd

    Auto focus digital microscope & telescopeReal fast auto focus by using liquid lensInfinity(x10) ~ Contact (x250) hole area auto focus by changing mode switchAuto focus & manual focus functionChangeable various End caps to support 3pi coner end capHigh luminance OLED displayInfrared wireless controlSupport Android & Windows (XP, Win 7, Win 8)Various image filters & digital zoom functionSpecial design for portablility (aluminum case) No battery neededProvide software for Android and PC

  • Sonde Locator

    VM-540 - Vivax-Metrotech Corp

    The VM-540 Sonde Locator comes standard with sonde/camera frequencies of 512Hz, 640Hz and 33kHz, making it compatible with the major push cameras and crawler cameras on the market. In addition to a visual peak bar graph that reaches its peak when over the sonde, a matching audible tone is heard which is loudest when over the sonde. The dot matrix display in the VM-540 shows a peak response in a bar graph with matching signal strength numbers, battery condition, speaker level, frequency setting and depth to the sonde with the push of a button.

  • Bluetooth® Enabled Nitrate & Temperature Pen

    UltrapenX2™ PTBT6 - Myron L Company

    *Nitrate Concentration (ppm N or ppm NO3-) or mV*1 and 2 Point Calibration Options*Proprietary ISE Sensor Design*Built-in Double Junction Reference Electrode*Compatible with EPA Approved Standard Method 4500-NO3-D*Live or Hold Mode – User Selectable*Measurement Storage with Time, Date and Location*Export Stored Measurement Data Via Email*Rugged Design with Aircraft Aluminum Body*Durable, Epoxy Encapsulated Electronics*Waterproof*Powered by One N Type Battery (Included)

  • Core Fusion Splicer with Dual Observation

    STC-OFS701H - Shanghai Stone Communication tech Co., Ltd

    The smallest Core to core fusion splicer with dual observation Weight 1.2kg only 3.5 inch TFT color LCD monitor with X & Y view simultaneously Fiber core can be displayed clearly with large magnification Alignment mode: Core, cladding and manual alignment 9 seconds splice time and 30 seconds heat time Friendly operation interface and smart menu Operation with Max wind velocity of 15m/s Operation with max 5000m above sea level Typical 120 cycles with battery

Get Help