Showing results: 1231 - 1245 of 3415 items found.
-
DRK153 -
Shandong Drick Instruments Co., Ltd.
Whether this is by hand or by mechanical means. The crease recovery (spring back) can result in forces, which distort the erected carton or cause stresses to be applied to closures, which reducetheir effectiveness. With the Crease and Stiffness Tester, the Crease recovery is determined by the decrease in resistance offered by creased board after it is folded 90° at the crease measuring the recovery force after 15 seconds. Board Stiffness is determined by bending a 50mm length of board through a 15° angle.
-
65DL2 -
North Atlantic Industries
NAI’s 65DL2 is a 12-channel, 3-wire, LVDT/RVDT Simulation Instrument on a VXI board. This single-slot, message-based board features up to 12 stimulus channels of 3-wire LVDT/RVDT, wraparound self-test, and onboard programmable excitation supply. The board is uniquely versatile, as each excitation input and output voltage is programmable. In addition, each channel can be programmed to be controlled by an external DC voltage. A replacement for the 5410C-83, the 65DL2 is ideally suited for defense, commercial aerospace, and industrial applications.
-
IP-5000, IP-5300 -
WIT Co., Ltd
The IP-5000 series is a space-saving high-speed board inspection device with a compact design.
-
SIS3104 -
Struck Innovative Systeme
PCI Express and Ethernet to VME interfaceThe SIS3104 is the successor to the SIS3100 board.
-
ICS Electronics
• VXI-5501 has a Bare Copper-clad Prototyping Board for RF and microwave modules.
-
-
DBK - 308 -
Holding Informtest
BRK308 is designed to control boards of relay switches RK36, RK27 or similar.
-
-
-
SparkFun Electronics
This simple board breaks out a female USB type A connector's VCC, GND, D- and D+ pins to a 0.1" pitch header. If you want to add a USB to your project, but don't want to put up with soldering tiny connectors, this is the board for you.
-
E-CAM30_CUCRL -
e-con Systems Inc.
e-CAM30_CUCRL is a 3.4 MP 4 lane MIPI CSI-2 custom lens camera board for Google Coral development board. This Google coral camera is based on 1/3" inch AR0330 CMOS Image sensor from ON Semiconductor® with 2.2 µm pixel.
-
DP-cPCI-4296 -
Data Patterns Pvt. Ltd.
DP-cPCI-4296 board features cPCI based eight channels ARINC429 protocol interface. As part of the cPCI family, the DP-cPCI-4296 board is fully compliant with compactPCI® specification 2.0 R3.0. and CompactPCI® Hot Swap Specification 2.1 R1.0.
-
SparkFun Electronics
This is the newest revision of this board and this breakout board pairs an SP3485 RS-485 transceiver with an FT232RL USB UART IC to convert a USB stream to RS-485. The SP3485 is a half-duplex transceiver, so it can only communicate one way at a time, but it can reach transmission speeds of up to 10Mbps.
-
VPX3-4924 -
Curtiss-Wright Defense Solutions
The rugged VPX3-4924 NVIDIA Tesla Pascal GPU processor board is designed and manufactured by Wolf Advanced Technology. This board is part of a family of GPGPU modules available from Curtiss-Wright Defense Solutions to enable development of High Performance Embedded Computing (HPEC) systems.
-
Model 2303 -
ICS Electronics
* 2303 Board provides 40 high-power TTL I/O lines that can sink 23 mA or source 24 mA. * Easily interfaces to TTL or CMOS signals and contact closures. * User can configure the data bytes as inputs or outputs.* Transfer data as bits, bytes as data strings or transparently.* Dual Serial headers support conections with baud rate switch inputs or to a Serial Flat Ribon Cable Assembly. * Optional Relay Driver board drives 24-40 relays. * 114732 Board has the DIN connector on circuit side for use with the X3DVR Relay Driver Board or for piggyback mounting.* All other specifications are the same as listed above for the 2303.