Filter Results By:
Products
Applications
Manufacturers
-
product
Network Interface
VadaTech offers AMC Network Interface Cards (NICs), FMC networking modules and ATCA rear transition modules (RTMs) with a wide range of connector interfaces to make it easier for you to integrate an embedded computing system into your solution.
-
product
Rack Mount Kestrel Chassis M/E/F-Series 37-slot
0228
This chassis has a 38-slot 21MX backplane of which 37 are available to the user. It also includes power supply and cooling fans. A firewire Chassis Interface Card (CIC) must be purchased to provide back-plane signals from the Kestrel to the chassis.
-
product
2-channel, 12 bit, 20 MS/s Waveform Digitizer
ATS9120
ATS9120 is a single-lane PCI Express (PCIe x1) Gen 1 card, which supports up to 200 MB/s bus throughput. ATS9120 is an ideal solution for any scanning applications that involve acquisition of data with a rapidly occurring trigger.
-
product
32-bit / 33 MHz PMC to PCI Adapter
4933
This PMC to PCI Adapter product from Technobox permits delivery of PMC-derived applications in a standard PCI environment. Mechanically, a PMC card fits cleanly on a short-length PCI board, resulting in a highly acceptable delivery solution for desktop applications.
-
product
8" Cables
RCONP1553-1
Transitions from each card end (non-IRIG) connector on various boards into two 8" cables with CJ70 Twinax, 3 lug, 1553 cable jack ends, and two 8" cables with BNC cable jacks for I/O triggers.
-
product
13-slot ATX-supported PICMG 1.3 Bus Passive Backplane
FAB113
*Designed for PICMG 1.3 SBC*Compatible with the AX61400, AX6145, and AX6156LE chassis*Supports one PICMG 1.3 CPU card slot, seven PCIe x1 slot, one PCIe x16 slot, and four 32bit/33MHz PCI slots
-
product
13-slot ATX-supported PICMG 1.3 Bus Passive Backplane
FAB119
*Designed for PICMG 1.3 SBC*Compatible with AX6145, AX61400, and AX6156LE chassis*Supports one PICMG 1.3 CPU card slot, one PCIe x4 slots, one PCIe x16 slot, and ten 32bit/33MHz PCI slots
-
product
13-slot ATX-supported PICMG 1.3 Bus Passive Backplane
FAB112
*Designed for PICMG 1.3 SBC*Compatible with the AX61400, AX6145, and AX6156LE chassis*Supports one PICMG 1.3 CPU card slot, one PCIe x4 slot, one PCIe x16 slot, and ten 32bit/33MHz PCI slots
-
product
11-slot ATX-supported PICMG 1.3 Bus Passive Backplane
FAB121
*Designed for PICMG 1.3 SBC*Compatible with AX61410, AX6145, AX6156 chassis*Supports one PICMG 1.3 CPU card slot, seven PCIe x4 slots, one PCIe x8 slot, and two 32bit/33MHz PCI slots
-
product
PICMG 1.3 Full-size SBC
Axiomtek's PICMG 1.3 full-size CPU cards (338 x 126 mm) offer high performance PCI Express slot as interface to the backplane, and improve I/O bandwidth and graphic performance from the original PICMG 1.0 specification.
-
product
MIL-STD-1553 Eight-Channel PMC Board
BRD1553PMC-STD-8
The PMC HyperBoard is a multi-standard PCI Mezzanine Card that contains eight channels of MIL-STD-1553 communication. The board is compatible with MIL-STD-1553B and MIL-STD-1760. Each channel can be configured independently to work with H009 and WB-194 in conjunction with MIL-STD-1553.
-
product
MIL-STD-1553 Two-Channel PMC Board
BRD1553PMC-STD-2
The PMC HyperBoard is a multi-standard PCI Mezzanine Card that contains two channels of MIL-STD-1553 communication. The board is compatible with MIL-STD-1553B and MIL-STD-1760. Each channel can be configured independently to work with H009 and WB-194 in conjunction with MIL-STD-1553.
-
product
RS232 9 Way D-Type lead
1081-001
Pickering Interfaces Series 1000 SIM Reed Relay Cards offer a choice of switching configurations using low cost industry standard SIM connectors. They are ideal for placing switching systems in fixtures close to the unit under test.
-
product
Interface Board, 16:1 USB
40-965-909
Converter card for 40-737-001 Data Communications Multiplexer. Adapts the 78-Pin D-type connector on the front of the module to 16 USB type A and 1 USB type B connectors. Allows the multiplexing of up to 16 USB1 or USB2 signals.
-
product
SIMRC - RS232 to I2C Converter PCB
1080-001
Pickering Interfaces Series 1000 SIM Reed Relay Cards offer a choice of switching configurations using low cost industry standard SIM connectors. They are ideal for placing switching systems in fixtures close to the unit under test.
-
product
3U 2-slot OpenVPX Backplane Aligned To SOSA™ - VITA 67.3c Aperture In Slot 2
1SVX302AMP-1X31
Designed in alignment with SOSA, this 3U backplane offers 2 Plug-in Card (PIC) slots to support the DoD’s MOSA and CMOSS initiatives. The backplane supports high-speed signals on all data paths and VITA 67.3c aperture in slot 2.
-
product
4U Rackmount Industrial Chassis with 14-slot Backplane
RK-410FS
*EIA RS-310C 19" rackmount standard*17.8 inch (451 mm) short depth*Three 5.25" and one 3.5" shock-resistant drive bays*Two front accessible USB connectors*Adjustable hold down bar for cards
-
product
ARINC 429
PXI Bus Expanders and PXI Interface Cards for both PXI and PXI Express interfaces.
-
product
12G-SDI Input+output With HDMI 2.0 For PCIe
DTA-2195
The ultimate 4K-UHD I/O card for PC! Output 12G-SDI and/or HDMI 2.0 signals from your application, add HDR and Dolby Atmos® if needed. Then again, capture 12G-SDI or configure a port for DVB-ASI to work with transport streams.
-
product
15" Ribbon Cable
CONM50-D37
A 15" ribbon cable transitions from individual IP modules on various carrier boards to a 37 pin D-sub female connector mounted on a PC expansion card end-panel. This allows external connection to pins 1-37 on an individual IP Module.
-
product
30" Ribbon Cable
CONM50-D37-30
A 30" ribbon cable transitions from individual IP modules on various carrier boards to a 37 pin D-sub female connector mounted on a PC expansion card end-panel. This allows external connection to pins 1-37 on an individual IP Module.
-
product
8" Cable
CONW1553-1
Transitions from a card end connector (with IRIG) on the QVME-1553 or QVXI-1553X into two 8" cables with CJ70 Twinax, 3 lug, 1553 cable jack ends, and four 8" cables with BNC cable jacks for I/O triggers and IRIG Rec/Gen.
-
product
Bench Meters
Both CyberScan Economy and Deluxe Bench Meters feature custom dual-display LCD for optimised data viewing, convenient detachable electrode stand, built-in memory, quick reference slide-out instruction card, HOLD function and other intelligent features.
-
product
Mixed Signal Automated Tester
MSAT
Whether you are testing radar systems for the Department of Defense (DoD), or the next actuator circuit card for aircraft landing systems, ARC’s Mixed Signal Automated Tester (MSAT) offers flexible automated testing capabilities for nearly every budget.
-
product
Interface
RXMC2-1553
Abaco Systems ’ RXMC2-1553 is the latest generation of performance and flexibility for MIL-STD-1553A/B Notice II on a XMC.0 Mezzanine Card. The 4 channel RXMC2-1553 includes advanced API (Application Programming Interface) software that reduces application development time.
-
product
Application Specific Board Bundles
AppliPaks
AppliPaks are fully integrated, custom configured board level embedded computing board sets combining an OpenVPX, VME, VME64x or CompactPCI single board computer with your choice of storage and / or I/O mezzanine cards, operating systems and device drivers.
-
product
Type 39 CompacFrame Development Platform, 6 And 8 Slot 3U OpenVPX Aligned To SOSA
39S0xBWX94Y3VCC0
Elma’s SOSA aligned CompacFrame is the next generation portable test platform designed to accelerate development and test of plug-in cards (PICs) aligned to the Open Group® SOSA™ Technical Standard. Accommodates up to 8-slot OpenVPX backplane.
-
product
FMC SpaceWire/SpaceFibre Board
316
The FMC-SpaceWire/SpaceFibre board is an FPGA Mezzanine Card which is designed to extend the capabilities of an FPGA development board by adding support for SpaceWire and SpaceFibre interfaces. The board has four SpaceWire ports with accompanying status LEDs, and two SpaceFibre ports.
-
product
6U And 7U VPX 1 To 15 Slot Power & Ground Only Backplanes
101VPX6xxP-xxxx
Elma’s 6U / 7U VPX power and ground only backplanes provide a cost-effective way to design and test cards using the VPX architecture. The only assigned pins are for 3.3V, 5V and 12V power, and both ground and utility planes are defined.
-
product
Type 12, CompactPCI Serial, 9 Slots, SSL, 4U, 84HP, 292mm
484V0-E09L-30PA1-100
CompactPCI Serial System Type 12 with 9 Slots, Slot on the left side of the system platform. 1x 300W pluggable, air-cooled with fan fix-mounted and colorless chromated. Vertical backplanes and have a 160mm card cage in the front and no rear I/O.