Showing recent results 421 - 435 of 518 products found.
-
I-SITE - Optikos Corporation
The I-SITE system is designed to provide measurements at multiple points in the signal processing chain for many types of camera systems. I-SITE can be expanded to accommodate multiple measurements and can be upgraded to incorporate additional modules as the user's system requirements change. There are many options that may be employed; thus there is no single I-SITE setup. Sources, detectors, and intermediate optics may all be configured to your requirements, and several different analysis options are offered.
-
A1 / C1 / C2 - Becker & Hickl GmbH
*bh FLIM Embedded in Nikon NIS-Elements Software*Two Fully Parallel TCSPC FLIM Channels*Compact bh Simple-Tau or Power-Tau System*Two HPM-100-40 GaAsP Hybrid Detectors*Excitation by bh ps Diode Lasers*Excellent Time Resolution: Electrical IRF Width 6.5 ps FWHM*Excellent Timing Stability*Time Channel Width Down to 813 fs*Megapixel FLIM, Up to 2048 x 2048 Pixels at 256 Time Channels*Detection Wavelength Range from 360 nm to 700 nm
-
Santa Barbara Infrared, Inc.
The FPA Test Set (FPATS) interface to the detectors under test (DUT’s) is via a custom pedestal plate which provides both a conductive heat path to both the individual DUT’s as well as the field of view limiting aperture plate. This custom pedestal plate protrudes through the customer provided DUT interface printed circuit board (PCB) and makes physical contact with the rear of the DUT packages and the aperture plate when the FPATS is in the closed position. The pedestal plate is mounted to the ambient source plate and its temperature is actively driven by this subsystem.
-
Hamamatsu Photonics K.K.
Electron multipliers are mainly used as positive/negative ion detectors. They are also useful for detecting and measuring vacuum UV rays and soft X-rays. Hamamatsu electron multipliers have a high gain (multiplication factor) yet low dark current, allowingoperation in photon counting mode to detect and measure extremely small incoming particles and their energy. This means our Hamamatsu electron multipliers are ideal for electron spectroscopy and vacuum UV spectroscopy such as ESCA (electron spectroscopy for chemical analysis) and Auger electron spectroscopy as well as mass spectroscopy and field-ion microscopy.
-
QuantaMaster™ 8000 Series - HORIBA, Ltd.
Highest guaranteed sensitivity specification at 30,000:1 Water Raman RMS. World class software for all steady state and lifetimes needs. Extended wavelength range with triple grating monochromators. Ultimate flexibility with up to four light sources and six detectors that can be selected. Fully automated system. Best in class stray light rejection with large single or double additive, coma corrected, monochromators.
-
VisualPhase - Hachmann Innovative Elektronik
With the VisualPhase line you get a type series of handy, exact and easily operated multi-functional devices with integrated voltage detectors, phase comparator and maintenance testers. Equipped with a thorough self test to ensure reliable function, a permanently enabled interface-tester to warn against defect interfaces and the connectability to HR, MR, LR, LRM or LRP string parts every VisualPhase delivers uncompromising safety.
-
AMS Technologies AG
The large active area high speed detectors can be fully depleted to achieve the lowest possible junction capacitance for fast response times. They may be operated at a higher reverse voltage, up to the maximum allowable value, for achieving even faster response times in nano seconds. The high reverse bias at this point, increases the effective electric field across the junction, hence increasing the charge collection time in the depleted region. Note that this is achieved without the sacrifice for the high responsivity as well as active area.
-
OEM Solutions - Amptek Inc.
Amptek offers a complete line of OEM detectors, preamplifiers, digital processors, and power supplies, and can work with you to help develop custom solutions unique to your needs. We provide established and emerging OEM customers a fast track to the market with our modular systems that will meet current needs, while being flexible enough to adapt to your product roadmap. The below options are typical configurations. Please contact us for custom solutions.
-
Techimp HQ S.r.L
PPS2 provides power supply to the PD detectors installed on HV cable when low voltage AC power is not available. The PPS2 takes the required power directly from the High Voltage power line under monitoring by means of units clamped on the HV power cable(s).PPS2 is designed to withstand High Voltage line failure events such as temporary overload and short circuit conditions. An internal detection and self limiting circuitry guarantees that PPS2 and the connected equipment survives in case of such events.
-
USB-S - Applied Electromagnetic Technology
The USB SOURCE (USB-S) consists of a family of pocket-sized highly stable comb generator with a single comb frequency. Powered by an external standard USB connector. Individual units available with frequencies of 1.8 MHz, 10 MHz, 64 MHz, 100 MHz, 133 MHz and 200 MHz. Custom frequencies are available, consult AET Sales for this option. An option is available to pulse the comb signal on/off at a slow rate to allow testing of receiver quasi-static detectors. The pulsed mode works for any comb frequency selected.
-
ViscoStar III - Wyatt Technology
A highly sensitive, on-line differential viscometer used in conjunction with SEC-MALS to determine the size and conformation of all types of biopolymers, synthetic polymers and even proteins and peptides. The ViscoStar III incorporates multiple novel technologies to provide the highest sensitivity, stability and solvent compatibility of any available viscometer for GPC. Its ease-of-use and serviceability make it the perfect companion for Wyatt's DAWN HELEOS II light scattering and Optilab T-rEX refractive index detectors.
-
UI-G60 - Unuo Instruments
Hand held needle detector, using the principle of magnetic field, can accurately detect the specific location of ferromagnetic metal impurities such as broken needles, which is very suitable for the inspection of thin and small items. It is also suitable for the detection of large needle detectors. It can accurately find the position of steel needles or ferromagnetic metals in a small range with this hand-held needle detector, avoiding the damage of metal impurities to consumers and manufacturers, and improving the quality of enterprise products.
-
VERDI - XGLab S.R.L.
The detectors can have an output capacitance from 0.1pF to 39pF, while the energy range spreads from 300eV to 3MeV with both signal polarities, positive and negative. The readout scheme can be pulsed-reset or continuous-reset with an optional external zero-network. The circuit includes 8 channels, each one composed by a hybrid charge preamplifier, a shaping amplifier, a baseline holder, a peak stretcher, an output power buffer and an RC integrator for external digital processing. The output of each channel may alternatively be multiplexed on a single output for low-speed, low-power random readout.
-
Teledyne DALSA
Teledyne DALSA's vanadium oxide (VOx) based microbolometer long-wave infrared detectors cover wavelengths from 8-14 µm and provide performance consistent with the best in the industry--they power our own Calibir IR cameras. Our novel wafer-level packaging (WLP) approach to microbolometer manufacturing in an optimized MEMS infrastructure gives us the ability to dramatically alter the traditional price-performance tradeoff.
-
D3S NET - Kromek Group plc
The D3S NET radiation detector is a fast and accurate radioisotope identification device (RIID) for gamma isotope identification and neutron detection. The data collected by this radiation detector is not only shown to the user via the mobile phone app but also sent to a central control screen showing data from every other SIGMA enabled detector on the network. The D3S NET detector unit houses larger detectors that provide identification of isotopes in seconds, alerting the user and your command centre of gamma isotope source, dose and any neutron detection.
