Filter Results By:
Products
Applications
Manufacturers
-
product
Single-Zone Refrigerant Monitor
Bacharach’s Single-Zone Refrigerant Monitor delivers the best refrigerant leak detection available, with industry-leading MDL of 1ppm for halogenated gases, the fastest sampling frequency and the widest range of refrigerants accurately detected. The Single-Zone is the ideal tool for early detection of leaks from specific target areas such as chiller rooms and mechanical rooms. The low MDL enables detection of leaks that other instruments can’t find; enhances effective refrigerant management and compliance with refrigeration standards and regulations that require refrigerant emissions reduction such as EPA Section 608, CARB, and European F-Gas compliance. The Single-Zone Refrigerant Monitor delivers cost savings through reduced refrigerant recharge and enhanced energy efficiency.
-
product
Impulsive Sound Source
BAS006
The BAS006 is an innovative device used to create impulsive noise that includes low frequency energy and avoids problems like secondary bounce. These characteristics make it a great choice for quickly measuring reverberation time when the complexity and weight of a speaker and amplifier is not needed.
-
product
Frequency Doubling Comb Generator
COMBGEN6DIFF
*Differential output - can also provide two separate single ended complementary outputs.*Pulse height of up to +4V peak into 50 ohms, on positive output*Pulse height of up to -4V peak into 50 ohms, on negative output*Rise time < 80pS, FWHM of approximately 120pS*Produces pulse on both edges of input clock, thereby doubling frequency.*Input clock may be sinewave from 50MHz to 2GHz or square wave from 5MHz to 2GHz, producing fundamental comb tooth energy from 10MHz to 4GHz.*Usable energy to >10GHz.*Can drive any load, including short, without damage.*Power Requirements: -12V @ 120mA and +24V @ 80mA
-
product
Power Transmitter
ITL-101
Power Transmitters measure precise power of any waveform generated by electronic circuits. The ITL-101 cannot only be used for stationary power measurements, but also for power control on machines using fast response option and bi-polar output option. For frequency inverter applications minimal use of energy is and issue and here the ITL-101 finds its place.
-
product
Elastomer Socket
As a structure made of silicon and conductive powder, elastomer is a good solution for high speed, no ball damage, stable CRES, low force and high frequency testing.
-
product
Electrosurgical Analyzer
Rigel 377
igel Medical has introduced a new high performance Electrosurgical Analyser with the emphasis on speed and ease of testing all modern day Electrosurgical devices. The new Rigel 377 utilises a new approach to measuring the high frequency leakage, power distribution and remote plate security testing, ensuring high accuracy and the widest range of built-in resistors.
-
product
EMC Test Automation Software
The nature of executing EMC testing, with repetitive procedures diligently searching for unwanted emissions step-by-step through wide frequency and power level ranges, demands automation.
-
product
DFS Testing and Certification Services
Dynamic frequency selection is a technology that is designed to ensure that wireless devices operating in the unlicensed WLAN 5 GHz bands are able to detect when they may be interfering with military and weather radar systems and automatically switch over to another frequency where they will not cause any disturbance. These formal requirements are in effect in the USA, Canada, Europe, Japan, Australia, Korea and other markets around the world.
-
product
Downconverter
DOWNCONVERTER 10 GHz VXI
The DOWNCONVERTER 10 GHz design assumes its use in closed mobile complexes for field testing of communications equipment. To do this, the device has applied advanced solutions to reduce the phase noise of the output signal in conditions of increased vibration and temperature. The device has a temperature-stabilized reference frequency generator with the ability to output a reference frequency signal. Also, it is possible to operate from an external reference generator.
-
product
Partial-discharge Detection System
GDYT Series
GDYT series include partial discharge power frequency testing transformer(YDTW),partial discharge detector(GDJF2008),Isolation filter frequency doubling power device(GDSF-81G) and power frequency withstand voltage control table(GDYD table).It widely used in electrical manufacturing,power operation departments, research institutes and universities.
-
product
Partial Discharge Surveyor
PDS100
The Doble PDS100 Partial Discharge Surveyor is a radio frequency interference (RFI) surveying tool that is designed for use in a live substation.Without the need for outages, the PDS100 can detect partial discharge (PD) in just a few seconds making it an ideal tool for a condition based maintenance program.
-
product
Digital Microwave Monitor
TX2000
This instrument is designed specifically for the field service engineer engaged in the repair and maintenance of domestic and commercial microwave heating equipment working at a nominal frequency of 2.45 GHz. Its purpose is the detection of potentially harmful microwave energy leakage from these heating sources.
-
product
SF6 Gas Leak Detector
Weshine Electric Manufacturing Co., Ltd
1. SF6 quantitative leak detector is an ideal tool and method for sf6 gas trace leakage inspection. It has the advantages of fast, convenient, reliable, and low maintenance cost.2. Especially suitable for occasions with high frequency of use such as factory workshops.3. It is recommended to purchase model LF-200 products during after-sales or inspection, with a total product weight of 7.5Kg, equipped with a portable aluminum alloy crash box.
-
product
MDS Spectrum Analyser
Display and storage of real time radio spectrum in four different time domains.Display and storage of real time spectrum occupation and signal activity of the specified frequency ranges, communication channels.Real time signal finding in specified frequency ranges and listening to the found signals by additional "drop frequency" receiver.Long lasting radio spectrum monitoring and data registration for the post-time analysis.
-
product
Handheld Radio Frequency Counter
FC1000 Series
A superb value low cost frequency counter Frequency range: 10 MHz - 3 GHz Weight: 210g Case: 80 mm * 68 mm * 31 mm stamped aluminum with black anodized finish Battery: Internal 4 * AA 600 mAH NiCd pack 8 digit liquid Crystal Display with 100 Hz resolution Low power consumption (Average 6 hour battery life)
-
product
RF Signal Detector
H-055DRV / 01019
The RF Signal Detector / 2G Cellular Phone Detector / Wireless Camera Detector / Bug Detector applies with fuzzy scanning technology to detect peeping cameras, tapping, cellular phones and other radio frequency devices.
-
product
Frequency Multipliers for Radio Amateurs
First approach is to generate the high frequency directly, at the fundamental, using an oscillatortuned on the desired frequency. Few sensitive issues appears here due to high working frequency as, stability, jitter, phase noise, pulling, pushing, low output power, and cost of the active component to meet the performances
-
product
I/Q Upconverters/Transmitters
In-phase quadrature (I/Q) upconverters integrate an I/Q mixer, RF amplifier, 90° hybrid, and an LO buffer in one package. These devices are used in transmitter applications to upconvert intermediate frequency (IF) to a desired radio frequency (RF) while reducing the need for filtering unwanted sideband.
-
product
RF Test
RF is short for radio frequency. RF is any frequency within the electromagnetic spectrum associated with radio wave propagation. When an RF current is supplied to an antenna, an electromagnetic field is created that then is able to propagate through space. Many wireless technologies are based on RF field propagation. These frequencies make up part of the electromagnetic radiation spectrum.
-
product
RFSoC Board
VP431
VP431, the next generation of our highly successful VP430, is a 3U VPX commercial off-the-shelf direct RF processing system that features the 3rd-generation Xilinx Radio Frequency System-On-Chip (RFSoC). The VP431 maximizes I/O channel density, reduces the radio frequency signal chain complexity, and allows for heterogeneous processing capability.
-
product
High Frequency
High- frequency loads come from the transmission systems of telephone companies (GSM, UMTS, LTE), cordless telephones (DECT telephones), wireless computer networks (WLAN, Bluetooth,...), and radar, radio, TV (DVB), etc. The blood is acidified by this influence and Cell membrane tensions change.
-
product
Radio Frequency (RF) Recording and Playback Instruments
Adivic Radio Frequency (RF) Recording and Playback Instruments
-
product
Radio / Conformity Tests
The safe and effective use of radio frequencies (HF), referred to in English as radio frequencies (RF), must be checked for every device with integrated radio technology. The legal requirements for radio frequency (HF) tests vary depending on the use of the device (medical devices, automotive and telematics devices, cellular devices, etc.).
-
product
NRPxxA/AN
In EMC applications, usually only the average power is of interest. This is where the R&S®NRPxxA/AN average power sensors are the perfect fit. They cover measurement ranges that are used in radio telecommunications as well as the important lower frequency bands down to 8 kHz
-
product
I/Q Downconverters/Receivers
In-phase quadrature (I/Q) downconverters integrate an image reject mixer, a low noise amplifier, a 90° hybrid, and an LO buffer amplifier in one package. These devices are used in receiver applications to downconvert radio frequency (RF) signals to the desired intermediate frequency (IF) while ensuring low noise and high image rejection performance.
-
product
Maritime Navigation and Communications Antennas
LBA provides equipment and services to support shore station requirements for modern maritime communications in the low frequency, medium frequency, and high frequency radio bands
-
product
Electromechanical Relay Switches
SMA SPDT electro mechanical RF relay switch features Indicators, Failsafe, Normally Open with an isolation minimum of 60 dB. SPDT electromechanical relay radio frequency switch PE71S6052 is part of over 40,000 RF, microwave and millimeter wave components available from Pasternack. Our SPDT SMA coaxial RF relay electromechanical switch can ship worldwide the same day that it is bought as with our other available RF parts.
-
product
Radio Frequency (RF) Generators
Find and fix design problems during developmental testing. Viasat’s RF signal environment generation surpasses ordinary simulation and computer modeling techniques to deliver a true-to-life, dense avionics environment for the most accurate analysis of RF communication system performance.
-
product
Universal Test Set
UTS
The Universal Test Set (UTS) is a portable, battery-powered, programmable, ruggedized radio frequency test set designed to validate improvised explosive device (IED) jamming equipment. Our unit is intended to provide an in-field confidence testing for warfighters employing IED jammers prior to departure.
-
product
Frequency Dividers
SMA SPDT electro mechanical RF relay switch features Indicators, Failsafe, Normally Open with an isolation minimum of 60 dB. SPDT electromechanical relay radio frequency switch PE71S6052 is part of over 40,000 RF, microwave and millimeter wave components available from Pasternack. Our SPDT SMA coaxial RF relay electromechanical switch can ship worldwide the same day that it is bought as with our other available RF parts.