Showing results: 106 - 120 of 789 items found.
-
P5573A -
Keysight Technologies
Keysight P5573A PCIe 6.0 Protocol Exerciser gives the flexibility in providing realistic traffic to devices under test and also able to emulate as a complex host system
-
Güralp Systems Ltd
The diminutive Güralp Minimus is an advanced 'smart' 24-bit seismic digitiser, packed with a host of features that make it the ideal 'plug-and-play' solution for rapid deployments and multi-scale networked arrays.
-
SKU-068-0X -
Amfeltec Corp.
Flexible MiniPCI Riser (Riser) was designed to extend motherboard MiniPCI bus. The Riser includes a MiniPCI Host board, MiniPCI Adapter board and a PCI Express flat cable.
-
Holland Shielding Systems B.V.
A freestanding (independent of the host building) prefabricated modular Faraday cage provides a superior screening of RF-signals and is applicable in a wide range of situations for a wide range of purposes as described below.
-
Silex Technology
The SX Virtual USB SDK for Linux allows manufacturers to implement Silex “Virtual Link” functionality into any embedded network device which has a USB Host port.
-
CAML-MOD3 -
Curtiss-Wright Defense Solutions
Even for simple applications, getting data into an FPGA structure can be critical. CAML-MOD3 simplifies CameraLink interfaces through a simple adaptor directly into and under control of a host FPGA, such as an XMC-FPGA05D.
-
SCHILLER AUTOMATION GmbH & Co. KG
The Gen4 Mini-SAS HD adapter kit will facilitate compliance testing for SAS-4 host, device, and cable. The left and right-hand version plug adapters are designed to test side-by-side.
-
SD3-GLISS -
ELMA Electronic, Inc.
SD3-GLISS fits into any CompactPCI® Serial peripheral slot that is PCIe enabled. Hardware RAID operation is supported, running with an enhanced ARM-based processor to offload the host CPU.
-
SD4-SWEEP -
ELMA Electronic, Inc.
SD4-SWEEP fits into any CompactPCI® Serial peripheral slot that is PCIe enabled. Hardware RAID operation is supported, running with an enhanced ARM-based processor to offload the host CPU.
-
Arasan Chip Systems, Inc.
A typical mobile device has many low-speed/bandwidth peripherals connected to the host processor, which include microphones, speakers, sensors and many others. There is a need for a standard bus that enables multiple audio channels, peer-peer communications and lower pin count on the host processor. The MIPI alliance has defined the SLIMbus specification which provides a standard, robust, scalable, low-power, high-speed, cost-effective, two wire multipurpose interface that supports a wide range of digital audio and control solutions for mobile terminals.
-
MODEL SS1 -
Paralan Corp.
The SS1 SCSI Bus Switch allows two hosts to share peripherals or one host to access either of two sets of peripherals. Each port may be SE, HVD or LVD. Switching from one port to the other may be accomplished: a. locally with the front panel switch, b. remotely with a momentary dry contact closure, or c. remotely via the RS-232 port. A software template for the RS-232 port is included in the User Manual. In all cases switching does not occur until "bus free."
-
5251 -
Technobox, Inc.
The IDE Controller PMC, when mated to a host or carrier card, provides an interface between the PCI bus and as many as four IDE/ ATA devices, via two independent channels.
-
OPT-2 -
Physitemp Instruments
The OPT-2 Optical Link allows the THERMES-USB to be operated with total optical isolation between THERMES and the host computer. USB Isolation device offers up to 4500 volts DC isolation.
-
SMT105-FMC -
Sundance Multiprocessor Technology Ltd.
The SMT105-FMC can be used either as an I/O-Blade for a Single Board Computer with either the OneBank or Three-Bank PCIe/104™ Connector solution or used as a “Head-Less” solution, ie. Remote Host Controlled.
-
3954 -
Technobox, Inc.
The extender/analysis probe permits extension of a PMC card beyong the edge of a host processor front panel, providing access to both Side 1 and Side 2 of a PMC under test.