Filter Results By:

Products

Applications

Manufacturers

IEEE

Institute of Electrical and Electronics Engineers

See Also: Standards, IEC


Showing recent results 271 - 285 of 380 products found.

  • Battery Capacity Tester

    BLU-C Series - IBEKO Power AB

    BLU-C is the latest solution from DV Power for conducting a comprehensive battery capacity test. This universal instrument is applicable to any battery string, such as lead-acid, Li-Ion, Ni-Cd, and others, with voltages up to 800 V DC.BLU-C tester simplifies battery testing in multiple ways. The instrument provides monitoring of discharge parameters (graphically and numerically) in real-time on a 7-inch touch screen display. The instrument also enables measurement and monitoring of cell parameters (voltage/intercell voltage/temperature), which makes it a complete stand-alone discharge test system.The capacity tester is compatible with DV-B Win software. Because of that, the user can view detailed numerical and graphical presentations of key parameters, and create reports in various formats.The capacity test is performed in a user-friendly way according to battery testing standards: IEEE 450-2010, IEEE 1188-2005, IEEE 1106-2015, IEC 60896-11/22 and other.The battery tester enables setting the discharge current up to 300 A, with 0,1 A resolution. If higher currents are required, BLU-C units can be connected in parallel, or BXL additional load units can be used.The user can select one of three discharge modes: Constant current, Constant power, Constant resistance. Additionally, different battery duty cycles can be simulated using user-selectable discharge profiles.Testing can be carried out without disconnecting the battery from the equipment it supplies.

  • 1-port RS-232/422/485 to 802.11a/b/g/n WLAN Modbus Gateway

    EKI-1361-MB-AE - B+B SmartWorx

    Link any serial device to an IEEE 802.11a/b/g/n network Support 802.11n MIMO 2T2R WLAN transmision rate up to 300 Mbps Supports secure access with WEP, WPA/WPA2-Personal, WPA/WPA2-Enterprise Provides COM port redirection, TCP, UDP, and pair connection modes Supports up to 921.6 kbps, and any baud rate setting Provides Web-based configuration and Windows utility Allows a max. of 5 hosts to access one serial port Supports Modbus TCP and Modbus RTU Support Dual band 2.4G/5G selective

  • 2-port RS-232/422/485 to 802.11a/b/g/n WLAN Modbus Gateway

    EKI-1362-MB-AE - B+B SmartWorx

    Link any serial device to an IEEE 802.11a/b/g/n network Support 802.11n MIMO 2T2R WLAN transmision rate up to 300 Mbps Supports secure access with WEP, WPA/WPA2-Personal, WPA/WPA2-Enterprise Provides COM port redirection, TCP, UDP, and pair connection modes Supports up to 921.6 kbps, and any baud rate setting Provides Web-based configuration and Windows utility Allows a max. of 5 hosts to access one serial port Supports Modbus TCP and Modbus RTU Support Dual band 2.4G/5G selective

  • 3-AXIS DIGITAL AC GAUSSMETER: 1-200 kHz

    IDR-200 - Integrity Design and Reseach Corp.

    Typical Applications include checking the frequencies and magnetic fields (BW: 1 kHz -200 kHz) produced by equipments such as computer monitors, television sets, video display terminals, induction heaters, industrial, Radar, scientific/medical equipment, walk-through/hand-held detectors and ground wave energy network; etc. For more information about VLF magnetic fields and the VLF gaussmeter , see the paper titled "Very-low-frequency electromagnetic field detector with data acquisition," IEEE Trans. Instrum. Meas.,vol. 58, no. 1, pp. 129-140, Dec. 2008. by S. Hanna.

  • 802.11a,b,g Dual RF Shielded Test Enclosure

    JRE 0814-2R-A - JRE Test, LLC

    Containing all the capability of the larger JRE enclosures, the rack mounted 0814-2R-A is ideal for testing IEEE 802.11 a,b,g devices such as; WLAN, VoIP, access points and other RF devices. Two independent 0814 series enclosures are mounted in one 19 inch rack. Two shielded vents provide excellent cooling and optional fan(s) are available for those hot products. Tough 'honeycomb' vents maintain shielding effectiveness throughout the frequency range. Featuring rugged welded aluminum construction, you can be assured of its tight RF shielding effectiveness.

  • 8GE PoE+2G Combo Managed Ethernet Switch, IEEE802.3af/at, 24~48VDC

    EKI-7710G-2CP-AE - B+B SmartWorx

    8 x IEEE 802.3 af/at PoE Gigabit ports + 2 x Gigabit Copper/SFP combo portsSFP socket for Easy and Flexible Fiber ExpansionRedundancy: Gigabit X-Ring Pro (ultra high-speed recovery time < 20 ms), RSTP/STP (802.1w/1D)IXM function enables fast deploymentSecurity: 802.1x (Port-Based, MD5/TLS/TTLS/PEAP Encryption), RADIUSManagement: SNMP v1/v2c/v3, WEB, Telnet, Standard MIB, Private MIB-40 ~ 75°C wide-range operating temperature (EKI-7710G-2CPI)Dual 24~48 V DC power input and 1 relay output

  • 8GE PoE+2G Combo Managed Ethernet Switch, IEEE802.3af/at, 24~48VDC, -40~75℃

    EKI-7710G-2CPI-AE - B+B SmartWorx

    8 x IEEE 802.3 af/at PoE Gigabit ports + 2 x Gigabit Copper/SFP combo portsSFP socket for Easy and Flexible Fiber ExpansionRedundancy: Gigabit X-Ring Pro (ultra high-speed recovery time < 20 ms), RSTP/STP (802.1w/1D)IXM function enables fast deploymentSecurity: 802.1x (Port-Based, MD5/TLS/TTLS/PEAP Encryption), RADIUSManagement: SNMP v1/v2c/v3, WEB, Telnet, Standard MIB, Private MIB-40 ~ 75°C wide-range operating temperature (EKI-7710G-2CPI)Dual 24~48 V DC power input and 1 relay output

  • Develop - Simulate - Validate JTAG / IJTAG based IP

    NEBULA - Intellitech Corp.

    You, your vendors and your customers being able to use one common interface to control and observe on-chip IP, resources and instruments. The figure below shows an example IC. The new IEEE 1149.1-2013 standard supports an init-data register for configuring the analog paramaters of I/O as well as controlling on-chip PLLs. The standard further extends this by defining in BSDL user test data registers or 'scan chains'. These registers enable the ability of generic software to control and observe mission mode IP and instruments simply by describing the register interface in BSDL.

  • ETHERNET COAXIAL EXTENDER FOR 10/100 NETWORKS UK P/S

    EIS-EXTEND-C-UK - B+B SmartWorx

    One 10/100Base TX (TX) Ethernet port with RJ-45 connectorAuto negotiation of speed and duplex mode on TX portAuto MDI/MDIX on Ethernet portIEEE 802.3 10BaseT and IEEE 802.3u 100BaseTX compliantLine port uses BNC connector or F-Type connectorLine port link is full-duplex up to 85Mbps over existing coaxial cableOne DIP switch for configuring local or remote modeStatus LED’s for monitoring and connection statusExternal AC to DC power adapter includedUsed as a stand-alone device or with a 19 inch rack chassisHot-swappable when used in 19 inch rack chassis

  • PoE Giga-McBasic/LFPT, 2TX/SFP (Req 1 IE-SFP/1250 Mod)

    852-11811 - B+B SmartWorx

    Unmanaged Gigabit Power Over Ethernet media converter; 3 ports- two 10/100/1000Mbps copper ports providing PoE and one SFP 100Mbps or 1000Mbps fiber or copperSupports Jumbo Frames (up to 10240 bytes)Rugged standalone metal enclosure with internal power supply; country-specific power cord includedFeatures configurable PoE reset on Fiber Loss of Signal (LOS)Supports LFPT, a diagnostic feature that can be enabled to assist the end user in troubleshooting a failed segmentSupports IEEE 802.3af PoE (15.4W) per fixed copper port

  • PoE Giga-McBasic/LFPT, 2TX/SX- MM850-SC

    852-11812 - B+B SmartWorx

    Unmanaged Gigabit Power Over Ethernet media converter; 3 ports- two 10/100/1000Mbps copper ports providing PoE and one fixed1000Mbps fiber port, Multi mode 850nm SC connectorsSupports Jumbo Frames (up to 10240 bytes)Supports LFPT, a diagnostic feature that can be enabled to assist the end user in troubleshooting a failed segmentSupports IEEE 802.3af PoE (15.4W); features configurable PoE reset on Fiber Loss of Signal (LOS)Rugged standalone metal enclosure with internal power supply; country-specific power cord included

  • PoE Giga-MiniMc/LFPT 2TX/LX- MM1300-SC

    857-11813 - B+B SmartWorx

    Unmanaged Gigabit Power Over Ethernet media converter; 3 ports- two 10/100/1000Mbps copper ports providing PoE and one fixed fiber port, Multi mode 1300nm, SC connectorsCompact, rugged stand-alone metal enclosure with external power supply (included)Supports Jumbo Frames (up to 10240 bytes)Supports IEEE 802.3af PoE (15.4W); features configurable PoE Reset on Fiber LOSSupports LFPT, a diagnostic feature that can be enabled to assist the end user in troubleshooting a failed segmentMultiple mounting options (Desktop, DIN Rail or Wall-mount)

  • PoE Giga-MiniMc/LFPT, 2TX/LX- SM1310/PLUS-SC

    857-11815 - B+B SmartWorx

    Unmanaged Gigabit Power Over Ethernet media converter; 3 ports- two 10/100/1000Mbps copper ports providing PoE and one fixed fiber port, Single mode/PLUS 1310nm SC connectorsCompact, rugged stand-alone metal enclosure with external power supply (included)Supports Jumbo Frames (up to 10240 bytes)Supports IEEE 802.3af PoE (15.4W); features configurable PoE Reset on Fiber LOSSupports LFPT, a diagnostic feature that can be enabled to assist the end user in troubleshooting a failed segmentMultiple mounting options (Desktop, DIN Rail or Wall-mount)

  • PoE+ Giga-MiniMc/LFPT, 2TX/LX- SM1310/PLUS-SC

    857-11915 - B+B SmartWorx

    Unmanaged Gigabit Power Over Ethernet media converter; 3 ports- two 10/100/1000Mbps copper ports providing PoE+ and one fixed fiber port, Single mode/PLUS 1310nm, SC connectorsCompact, rugged stand-alone metal enclosure with external power supply (included)Supports Jumbo Frames (up to 10240 bytes)Supports IEEE 802.3at PoE+ (25.5W) standards; features configurable PoE Reset on Fiber LOSSupports LFPT, a diagnostic feature that can be enabled to assist the end user in troubleshooting a failed segmentMultiple mounting options (Desktop, DIN Rail or Wall-mount)

  • PoE Giga-MiniMc LFPT, 2TX/LX-SM1310-SC

    857-11814 - B+B SmartWorx

    Unmanaged Gigabit Power Over Ethernet media converter; 3 ports- two 10/100/1000Mbps copper ports providing PoE and one fixed fiber port, Single mode 1310nm, SC connectorsCompact, rugged stand-alone metal enclosure with external power supply (included)Supports Jumbo Frames (up to 10240 bytes)Supports IEEE 802.3af PoE (15.4W); features configurable PoE Reset on Fiber LOSSupports LFPT, a diagnostic feature that can be enabled to assist the end user in troubleshooting a failed segmentMultiple mounting options (Desktop, DIN Rail or Wall-mount)