Filter Results By:

Products

Applications

Manufacturers

IEEE

Institute of Electrical and Electronics Engineers

See Also: Standards, IEC


Showing recent results 316 - 330 of 380 products found.

  • CoreCommander

    JTAG Technologies Inc.

    While many ICs are equipped with a JTAG (IEEE Std. 1149.1) boundary-scan register (BSR), a significant number of microprocessors and DSPs can be found with deficient or even non-existent BSRs. CoreCommander Micro uses the on-chip debug mode of processors to access ports and embedded peripheral controllers to promote ''kernel-centric'' testing. Similarly, in the case of today's Field Programmable Gate Arrays (FPGAs) test engineers can ''bridge'' from the JTAG interface to the resources of the gate array itself. Our CoreCommander FPGA product implements a translatorinterface that allows our JTAG hardware to control embedded IP cores via a variety of bus interfaces (e.g. Wishbone Avalon etc.).

  • EMC/EMI

    Schaffner

    Harmonic filters help to obtain compliance withinternational standards like e.g. IEEE 519-1992 or EN 61000-3-12, and with local utility codes. They reduce electrical andthermal stress upon the electrical infrastructure, eliminate the risk of harmonics-related reliability problems, and supportlong-term energy efficiency and cost savings. Ecosine passive filters are the industry standard for 6-pulse rectifiers andnon-regenerative motor drives to achieve the often specified level of < 5% THID. Ecosine active harmonic filters providelatest generation digital technology. With a response time of less than 300 µs an efficient harmonics mitigation, powerfactor correction, and load balancing is achieved in real time.

  • ETHERNET COPPER EXTENDER FOR 10/100 NETWORKS, VDSL2

    EIR2-EXTEND - B+B SmartWorx

    Hardened 10/100BSE-TX Ethernet ExtenderExtend Ethernet Copper up to 2200 meters (7218 feet) over existing copper wire (common copper, telephone, Cat5e)VDSL2 technology with transmission rate of 100Mbps at 400meters-40°C to 75°C (-40°F to 167°F) operating temperature rangeAuto -detection of Local/Remote function to reduce installation timeLocal/Remote function to reduce installation timeLink-Down-Relay (LDR) function to inform link loss to other sideOne 10/100Base TX (TX) Ethernet port with RJ-45 connectorIEEE 802.3 10BaseT and IEEE 802.3u 100BaseTX compliantLine port uses common RJ-11 connector

  • Handset Test Systems

    Microtronix Systems Ltd.

    ITU-T, IEEE and OREM standards compliant Acoustic measurements correlate directly to your R&D LabProgrammable DC biasing voltage in either polarity for microphone transducerProgrammable plug-in transmitter / receiver termination impedance modulesDetailed test reports and graphs can be displayed on the monitor, printed or save as to hard drive or network.Up to 48 different Test Programs containing limits and testing sequences can be stored in non-volatile CMOS RAM.A typical handset can be tested in 5 to 10 seconds, depending on the test program.Test Program Limits, frequency points, testing sequences, and operator messages are easily modified using the Microtronix Test Program Editor (TPE) for Windows.

  • Stand Alone BERTS & SSG

    ML4079D - multiLane SAL

    The ML4079D is a fully featured 400G BERT that can be configured as an 8-channel PAM4 30 GBaud or 8-channel NRZ 30 Gbps lanes.  The receivers support FEC decoding (802.3bj KR4/scaled KP4) and will return the frame loss ratio for FEC scenarios and BER for unframed data. The receivers also show the eye’s Histogram and the channel’s SNR over time.  The transmitters Support all standard test patterns mandated by IEEE and OIF such as PRBSQ13, SSPRQ, PRBSQ31, QPRBS13CEI, etc… The user may also program the TX to output a user-defined pattern up to 32 kb long. The transmit power is adequate for testing up to 10 Km SMF links.

  • 5-P,4-10/100TXPOE,1-100BASEFXU,DIN,MM,SC

    105FX-SC-POE - B+B SmartWorx

    Compact, Space Saving PackageFull IEEE 802.3 and 802.3af ComplianceAmerican Bureau of Shipping (ABS) Type ApprovalEN50155 for Railway applicationsFour 10/100BaseTX RJ-45 Ports (4 PoE Ports)One 100BaseFX Port with ST or SC ConnectorsUnmanaged OperationExtended Environmental Specifi cations-40ºC to 85º Operating TemperatureAutomatic Detection of Connected PoE DevicesSupport for Full/Half Duplex OperationAuto-sensing Duplex, Speed, and MDIX (RJ-45)Up to 1.0 Gb/s Maximum ThroughputFull Wire Speed CommunicationsSupports 15.4 Watts per port (13 Watts at the PD)Redundant Power Inputs (46-49 VDC)Power Fault Status LED''sLED Link/Activity Status IndicationLED PoE Status IndicationHardened Metal DIN-Rail Enclosure

  • Current Transformers

    Osborne Transformer Corp.

    The Institute of Electrical and Electronic Engineers defines a current transformer (IEEE Std C57.13) as “a transformer intended to reproduce in its secondary circuit, in a definite and known proportion, the current of its primary circuit with the phase relations substantially preserved”. Its primary winding is connected in series with the conductor carrying the current to be measured or to be controlled and its secondary winding is connected to the measuring, protection or control devices. Osborne designs and manufactures current transformers which are used for instrumentation applications, others which are used for power system synchronizing applications and others which are used in protection circuit application. They have been designed to meet specified current ratios, burden impedance and transformation errors.

  • IP Surveillance Camera

    ENVIROMUX-IPCAM - Network Technologies Inc

    View and control the camera from the ENVIROMUX web interface, the camera web interface, included software, or with a compatible cell phone. With the ENVIROMUX-2D/5D/16D, a triggered snapshot can be forwarded in alert e-mails. A snapshot can be triggered by any programmed event (motion detection, door open/close, glass break, smoke, liquid detection, etc.). Image sensor: 1/4" progressive scan CMOS sensor. Video Streaming: simultaneous Motion JPEG and MPEG-4. Frame rate: 30fps at 640x480 (VGA) resolution. Lens: F2.0, 4.0 mm (0.16 in). RJ45 connector. Wireless models: wireless IEEE 802.11 b/g up to 54 Mbps. Regulatory approvals: CE, FCC, RoHS.

  • Regenerative Grid Simulator

    61800 series - Chroma ATE Inc.

    Market demand for Distributed Resource (DR) products such as PV inverters and wind energy systems is steadily growing as the world strives for clean renewable energy sources. This demand has created a need for rigorous regulation testing to standards such IEEE 1547 / IEC 61000-3-15 / IEC 62116 ensuring proper and safe operation of on-grid products. It has become critical to manufacturers to conduct these tests to prove compliance and to relieve product liability concerns. Chroma’s new 61800 family of Grid Simulators has been designed to fulfill these test requirements by providing a full 4 quadrant, fully regenerative, grid simulator with advanced features for compliance, safety and product verification testing.

  • Wireless IP Surveillance Camera

    ENVIROMUX-IPCAM-W - Network Technologies Inc

    View and control the camera from the ENVIROMUX web interface, the camera web interface, included software, or with a compatible cell phone. With the ENVIROMUX-2D/5D/16D, a triggered snapshot can be forwarded in alert e-mails. A snapshot can be triggered by any programmed event (motion detection, door open/close, glass break, smoke, liquid detection, etc.). Image sensor: 1/4" progressive scan CMOS sensor. Video Streaming: simultaneous Motion JPEG and MPEG-4. Frame rate: 30fps at 640x480 (VGA) resolution. Lens: F2.0, 4.0 mm (0.16 in). RJ45 connector. Wireless models: wireless IEEE 802.11 b/g up to 54 Mbps. Regulatory approvals: CE, FCC, RoHS.

  • PSE Conformance Test Suite for 2-Pair 802.3bt / 802.3at PSE's

    PSA-CT2P - Sifos Technologies, Inc.

    Whether testing single port injectors or 48 port PSE’s, Sifos offers the ultimate solution to assess PSE conformance to all applicable IEEE specifications. With the click of a button, fully automated testing and reporting delivers comprehensive and informative results including difficult-to-spot intermittent conformance behaviors. • Robust 2-Pair 802.3at (Type-1, 2) / 802.3bt (Type-3) PSE Conformance Testing• Fully Automated Port Sequencing and Statistics• Greater than 95% 802.3at PICS Coverage from 23 Fully Automated Tests• Pop-Up Excel Reports Covering 1 to 24 Ports• Widely Used by PSE System and Silicon Manufacturers World Wide

  • 16-port 10/100Mbps + 4-port GbE SFP Full L2 Industrial Managed Ethernet Switch, -40~75C

    SE520-4SFP-T - B+B SmartWorx

    8-port 10/100 Mbps + 2-port Gigabit Combo (RJ45 or SFP) Uplink8-port or 16-port 10/100Mbps + 4-port Gigabit SFP UplinkFull suite of Layer 2 functionality and advanced diagnostic toolsEnergy Efficient Ethernet (EEE), IEEE 802.3az for low energy consumptionJumbo Frame support, up to 9,216 bytesIXM™ function enables the cross management for fast deploymentX-Ring™ function offers self-healing recovery time less than 20 msRedundant Power Inputs (8.4 - 57.6 VDC)Wide Temperature Range -40 to 75°CEMS Level 3 Radiated/Conducted noise protectionDesigned for UL508 (Industrial Control Panel), NEMA TS2 (Traffic Control), EN50121-4 (Rail Signal Control)

  • 16-port 10/100Mbps EtherNet/IP Managed Ethernet Switch, -40~75C

    SE416-EI-T - B+B SmartWorx

    8-port or 16-port 10/100 Mbps8-port or 16-port 10/100 Mbps + 2-port Gigabit Combo (RJ45 or SFP) UplinkLayer 2 Managed functionality and advanced diagnostic toolsSupport IGMP snooping to forward and filter multicast traffic intelligentlySupport RSTP standard redundancy protocol to integrate into standard systemEnergy Efficient Ethernet (EEE), IEEE 802.3az for low energy consumptionIXM™ function enables the cross management for fast deploymentX-Ring Elite™ function offers self-healing recovery time less than 20 msRedundant Power Inputs (8.4 - 57.6 VDC)Operating temperature range -10 to +60°CUL508 certified for Industrial Control PanelUL C1D2, ATEX Zone 2 and IECEx certified for Hazardous Environments

  • 16-port 10/100Mbps Industrial Managed Ethernet Switch, -10~60C

    SE416 - B+B SmartWorx

    8-port or 16-port 10/100 Mbps8-port or 16-port 10/100 Mbps + 2-port Gigabit Combo (RJ45 or SFP) UplinkLayer 2 Managed functionality and advanced diagnostic toolsSupport IGMP snooping to forward and filter multicast traffic intelligentlySupport RSTP standard redundancy protocol to integrate into standard systemEnergy Efficient Ethernet (EEE), IEEE 802.3az for low energy consumptionIXM™ function enables the cross management for fast deploymentX-Ring Elite™ function offers self-healing recovery time less than 20 msRedundant Power Inputs (8.4 - 57.6 VDC)Operating temperature range -10 to +60°CUL508 certified for Industrial Control PanelUL C1D2, ATEX Zone 2 and IECEx certified for Hazardous Environments

  • 16-port 10/100Mbps Industrial Managed Ethernet Switch, -40~75C

    SE416-T - B+B SmartWorx

    8-port or 16-port 10/100 Mbps8-port or 16-port 10/100 Mbps + 2-port Gigabit Combo (RJ45 or SFP) UplinkLayer 2 Managed functionality and advanced diagnostic toolsSupport IGMP snooping to forward and filter multicast traffic intelligentlySupport RSTP standard redundancy protocol to integrate into standard systemEnergy Efficient Ethernet (EEE), IEEE 802.3az for low energy consumptionIXM™ function enables the cross management for fast deploymentX-Ring Elite™ function offers self-healing recovery time less than 20 msRedundant Power Inputs (8.4 - 57.6 VDC)Operating temperature range -10 to +60°CUL508 certified for Industrial Control PanelUL C1D2, ATEX Zone 2 and IECEx certified for Hazardous Environments