Showing results: 2221 - 2235 of 5951 items found.
-
P5085C -
Carl E. Holmes Company
Shown below is an AC to DC power supply with 4/20 ma interface. Input is 240 VAC, 1 PH, 60 Hz. Output is 0 to 10.5 DC, 130 Amps. This power supply can be interfaced to a PLC system. These units are customized units, built to order.
-
STMicroelectronics
ST offers a series of intelligent power switches (IPS) for high-side and low-side configurations. These devices integrate the control section (logic interface, drivers, diagnostic and protection features) and the power stage on the same chip, with benefits in terms of compactness, increased system reliability and cost effectiveness.
-
GX6384 -
Marvin Test Solutions, Inc.
The GX6384 3U PXI multiplexer switch card provides users with the ability to switch and interface tester resources to multiple UUT connections. The card is available in three different configurations, supporting 32 x 2, 32 x 4, and 32 x6 switch configurations.
-
cPCI-7248/7249R -
ADLINK Technology Inc.
*PICMG 2.0 Rev 2.1*48-CH digital TTL/DTL input/output*Emulates 4/2/1 industry standard 8255 PPI (mode 0)*Direct interface with OPTO-22 compatible I/O modules Output port status read back*On board 8254 timer/counter chip
-
JRT Photovoltaics GmbH & Co. KG
The JRT Cell Test Line sorts the solar cells according to efficiency and optical criteria. The results allow each cell to be assigned a specific performance level and quality category. Firing furnace interface / unloading. Cell inspection. IV curve measurement. Dynamic sorter.
-
Meco Instruments Pvt. Ltd.,
Memory & Read FunctionRight Device to know the TRUE -LIFE of Battery Capacity (Resistive / Voltage) Simultaneously MeasureOn - Line Testing without shutting down batteryBuilt - in Comparator FunctionRates Conditions as PASS, WARNING or FAILDatalogging Memory FunctionCompact and lightweightRS-232 Interface & SoftwareAuto Power Off
-
PGY-SPMI-EX-PD -
Prodigy Technovations Pvt. Ltd.
SPMI Protocol Analyzer (PGY-SPMI-EX-PD) is the Protocol Analyzer with multiple features to capture and debug communication between host and design under test. SPMI (System Power Management Interface) is a MIPI (Mobile Industry Processor Interface) standard with 2-wire synchronous serial, bidirectional interface that connects the integrated Power Controller(PC) of a System on- Chip (SoC) processor system with one or more Power Management Integrated Circuits (PMIC) voltage regulation systems.
-
BCO, Inc.
• Developed for DRS Codem Systems, Inc. to test the CTM-IP product line of the Multi-Interface Protocol Converter.• Manufacturing Test support for the CTM-IP chassis and Interface Modules. Functional test of signaling, protocol and software configurations for various communication interface configurations.• Regression Test support for Engineering Product Development. Configurable test sequencing allows engineer to select specific tests for execution, with the ability to exercise all combinations of data rates and interface configurations.
-
Model 5586 -
Pentek, Inc.
- Jade 5585 and 5586 FAQ- Co-processor for distributed FPGA processing tasks- High-Bandwidth Memory (HBM) delivers 20x more memory bandwidth than traditional DDR4 solutions- Board interfaces: 1 GigE, 10 GigE, 40 GigE, dual 100 GigE and PCIe- High-bandwidth memory, FPGA logic and DSP density make this board a single-slot 3U VPX proessing powerhouse- Features Xilinx Virtex UltraScale+ HBM FPGAs- 10 GigE Interface and 40 GigE Interface- Optional VITA 67.3C optical interface for backplane gigabit serial communication- Dual 100 GigE UDP interface- Compatible with several VITA standards including: VITA 46, VITA 48.11, VITA 67.3C and VITA 65 (OpenVPX™ System Specification)- Ruggedized and conduction-cooled- Navigation Design Suite for software and custom IP development
-
DP-cPCI-5211 -
Data Patterns Pvt. Ltd.
DP-cPCI-5211 IP carrier board provides electrical and mechanical interface for four industry standard IP modules. The board provides full data access to the IP modules I/O, ID and memory spaces. The programmable registers are used for configuring and controlling the operation of IP modules.
-
MikroElektronika D.O.O.
Environment click measures temperature, relative humidity, pressure and VOC (Volatile Organic compounds gases). The click carries the BME680 environmental sensor from Bosch. Environment click is designed to run on a 3.3V power supply. It communicates with the target microcontroller over SPI or I2C interface.
-
JOHO640CM_A00 -
Wuhan JOHO Technology Co., Ltd
OHO640CM_A00 is a high resolution 640x480 uncooled long-wave thermal imaging core. It is especially designed for OEMs. With lightweight and compact design, low power consumption and standard interface, it is very easy to be integrated into end-user products, such as portable surveillance thermal camera, UAV, thermal sight etc.
-
60-200-001 -
Pickering Interfaces Ltd.
If you have ever read the term “programmable except for the supply on/off switch” the 60-200 can provide this capability in a system with the added benefit of an easy to use LXI interface. The 60-200 is a power management switch that provides a means of remotely controlling the power status of up to 8 instruments.
-
MPD-100 -
R&J Measurement
Mobile meter designed to continuous measurement of ferrite contain during displacement of the sensor along the tested object. The meter contain the measurements memory and all obtained date could be display on LCD.The meter contain also RS232 interface which allow the data transmittion to PC.
-
Alto Inspection Corp.
THANKS TO OUR ADVANCED DATA ANALYSIS FUNCTION AND EASY-TO-VIEW USER INTERFACE, YOU CAN IMPLEMENT SPC WITH VERY LITTLE EXTRA WORK. OUR MONITORING SOLUTION IS DESIGNED TO IMPROVE THE TRACKING THE DEFECT AND CAN BE EASILY CORRELATED WITH YOUR MANUFACTURING PARAMETERS FOR ROOT-CAUSE ANALYSIS.