Filter Results By:

Products

Applications

Manufacturers

Level

high or low along a bead it's a measure referenced.

See Also: Liquid Level, Signal Level Meters, Level Transmitters, Depot Level Test


Showing results: 1561 - 1575 of 3723 items found.

  • Filters & Attenuators

    ROM-Elektronik GmbH

    Attenuators are used to extend the measuring ranges of our high-frequency measuring devices HFA-3, HFR-4 and Frequency Master IV. They are suitable for measuring higher levels.The measuring range of our high-frequency measuring devices HFA-3, HFR-4 and Frequency Master IV can be adjusted upwards using external attenuators. Available attenuators are 10 dB and 20 dB. The 10 dB attenuator extends the measurement range upwards by a factor of 10 (10x higher radiation level) and the 20 dB attenuator extends the measurement range upwards by a factor of 100 (100x higher radiation level). The attenuators are simply screwed between the antenna and the measuring device.In addition to our high-frequency filter MFF-1, there are also special filters that cover frequency ranges that the MFF-1 does not. Please ask us about your special requirements.

  • Photon Counting PMT Detection System

    HORIBA, Ltd.

    For spectroscopy and microscopy experiments in the UV/Vis/NIR region of the spectrum, a photomultiplier tube (PMT) is the ideal detector for quantitative low light level measurements. A PMT is extremely sensitive, with very wide dynamic range so it can also measure high levels of light. PMT’s are also very fast so rapid changes in optical signals can be reliably monitored. As a practical matter, PMTs are durable, long-lived, and economical.HORIBA provides a simple, self contained PMT housing that operates in either analog or photon counting modes with the flick of a switch. This ambient PMT housing is ideal for standard side-on PMTs that are used from 185 to 900 nanometers. It has a very low dark count for a non-cooled PMT housing providing a dark count of only ~ 50 to 500 counts per second (cps) depending on the PMT selected.

  • Fixed Gas Detectors

    DG7 Series - Teledyne Gas & Flame Detection

    All DGi-TT7 are constructed from a common housing and electronics with the detection properties being determined by the type of sensor (cartridge) used. A wide range of cells are available, these cells are intrisically safe protected, and may be replaced with the detector powered which minimises the system down time. The intelligent, microprocessor driven unit is fully configurable using a wireless hand-held terminal (TLU) or by using the hard wired HART option giving true flexibility to the installer and reduced service costs.Elements such as relay operation and alarm levels are all set via the TLU, a hazardous area approved hand-held unit. The unit may be interfaced directly with a wide range of panels, controllers and PLC’s etc. Its integral daylight readable alphanumeric display indicates local status and alarm level.

  • IP X1, X2 Chamber - Drip/IP Test Chamber

    ACMAS Technologies Pvt. Ltd.

    The drip box testing chambers from Weiber are rain test machines used for testing the outer protection of signal devices, external lighting equipments and car lamps etc. The equipment finds widespread usage in electronics industry and automotive and aerospace industries and is commonly employed for quality testing of products. The test chamber comprises of the guiding upright column, a drip mold, a rotating sample table with adjustable speed and a level meter to allow observation of the level in the drip mold. The equipment uses high quality construction materials for a sturdy construction and is designed for safe and reliable operation. The guiding upright column is made up of high-quality, plastic coated square steel pipe, whereas the drip mold is made up of high-quality stainless steel finish plate undergoing knurling.

  • Dissolution Media Prep System

    Media-Mate Plus - Teledyne LABS

    The Media-Mate Plus™ is the perfect media-prep system for a busy dissolution lab that demands both speed and accuracy. It delivers pre-heated, filtered, deaerated, and volumetrically dispensed media to 6 or 7 dissolution vessels simultaneously in less than five minutes. Built on a unique ergonomic cart, the Media-Mate Plus offers maximum portability for easy servicing of many dissolution test stations.The Media-Mate Plus exceeds USP / US FDA recommended media deaeration specifications making it one of the most effective tools in ensuring successful Performance Verification Tests (PVT). By significantly reducing dissolved oxygen levels and dispensing media simultaneously into 6 or 7 vessels, the MediaMate Plus eliminates the variable caused by Prednisone tablets that are highly sensitive to dissolved oxygen levels, thus facilitating successful passage of PVT tests.

  • FTTB Out-door AGC Optical Receiver

    BG9244x-LE - Hangzhou Huatai Optic Tech. Co., Ltd.

    Huatai BG9244 is a type of out-door optical receiver . The product builds-in RF interstage gain adjustment and equalization. Users can choose one-way or two-way high output level with the insert. The product is used in FTTB, FTTN, FTTC and used as a Rx unit of CATV. It is a type of receiver with high flexibility, excellent performance and P/P ratio.

  • Gas Monitor

    Toxgard® II - MSA

    Simply connect the convenient ToxGard II Gas Monitor to a power source and a remote sensor, and it's ready to detect toxic gases, combustible gases and oxygen deficiency. The indoor/outdoor unit is housed in a rugged NEMA 4X enclosure and features a large LED screen, three levels of alarm and a failsafe fault relay output.

  • Industrial Ethernet Network

    CC Link IE Field - Anybus

    CC-Link IE Field network is the first gigabit industrial Ethernet network extended down to the field device level. It combines the best of existing technologies and applies them in a highly reliable architecture that provides exceptional data bandwidth and transaction rates. The new network uses commercially available Cat5E cable and RJ45 connectors.

  • Low Noise Amplifier

    R&K Company Ltd.

    R&K’s Low Noise Amplifier (LNA) series products are a type of small signal amplifiers but with excellent noise figure. LNA is designed to significantly minimize additional noise to be introduced inside the product, and capable to amplify the input RF signal to the required level with minimal impact from noise on output RF signal.

  • MPEG & DVB Analyzer

    GkWare e.K.

    The analyzer combines the most important MPEG analyzer features into one single product: Decode all MPEG and DVB service information down to the descriptor level. Current/Next table versions are listed separately. SI information for "other" transport streams is decoded as well. The full range of descriptors defined in MPEG2 and DVB are supported.

  • Multisite Probe Card

    T300 ButtonTile™  - Celadon

    The Celadon T300™ probe cards are designed for long-term, multi-site, high-density wafer level reliability or burn-in tests up to 400°C. In today’s economic environment, conventional reliability data is needed quickly while eliminating the cost, electrical stress, and delay of parts packaging while maintaining a wafer performance map.

  • Noise and Vibrations Meters

    Ga113 - PASI srl

    Noise e vibrations metersGa113category: Monitoring / Noise e vibrations metersbrand: CASTLEitem: Ga113 The Castle SONUS is a new range of pocket meters designed for ease of use with the power the cover the work you need, from Noise at Work measurements to Environmental monitoring. The SONUS sound level meters are split into a range of meters to suit specific needs.

  • Open Path Infrared Gas Detector

    IR5500 - MSA

    The IR5500 is an open path infrared (IR) gas detector that continuously monitors for flammable gas leaks over large open areas. It monitors in both the LEL-m and ppm-m ranges to detect both small and large leaks. The IR5500 offers the benefits of early detection with its high sensitivity to gas concentrations at the ppm levels.

  • Optical Sensors

    Analog Devices Inc.

    Analog Devices optical sensors are optical sensing front ends that include integrated ultra-low noise amplification and high performance photodiodes. These solutions are used to achieve the highest performance for instrumentation, industrial, or clinical applications; or to optimize a solution to achieve the lowest power dissipation at a given performance level for battery powered and portable applications.

  • Pressure Data Logger with LCD

    PR2000 - MadgeTech, Inc

    The PR2000 is a battery powered pressure data logger, with an LCD. It is perfect for applications requiring displayed pressure readings and a logger. The 8-button keypad and large LCD provide convenient access to current data and data logger setup. Additionally, memory and battery levels, external power status, and sampling and recording status are shown on the LCD.

Get Help