Showing results: 196 - 210 of 3723 items found.
-
AMETEK Drexelbrook
The Universal II is a two wire level transmitter that eliminates the need for line power in the field and saves costs for additional hardware. It provides reliable level measurements in all kinds of process liquids, slurries, granulars and interfaces.
-
HR3051-LT -
HighReach Measuring & Controlling System Co.,Ltd
t The diaphragm of at The Differential pressure Level Transmitter IS Used to Prevent at The Medium in at The Pipeline from Directly Entering at The pressure the Sensor the Component of at The Differential pressure Transmitter. It uses A filling Fluid SUCH AS Silicone Oil to The TRANSMIT pressure the BETWEEN at The Transmitter and at The Transmitter. At The HR3051-LT differential pressure level transmitter measures the level, density, pressure, and flow of liquids, gases, or vapors and converts them into 4-20mADC HART current signal outputs. The RP2001 can also communicate with the RST375 handheld terminal or the RSM100 Modem For parameter setting, process monitoring, and more.The measuring range of the HR3051-LT differential pressure level transmitter (when not moved) is 0-1kPa~2MPa, and the rated pressure of the liquid level flange is: 1.6/4MPa, 6.4MPa, 10MPa, 150psi, 300psi or 600psi.
-
GAO Tek Inc.
A sound level meter, also known as sound pressure level (SPL), decibel (DB) meter, noise meter or noise dosimeter is mainly used for measuring sounds travelling through air. It is used to test noise or sound levels by evaluating sound pressure. It uses a microphone to capture sound and the sound is then evaluated in the device. It is commonly used to prevent loud noises to create a better work environment.
-
Model KM 926 -
Kusam Electrical Industries Limited
• KM 926 designed according to the IEC 651 TYPE 2 & ANSIS1.4 TYPE 2 for sound level meter.• Instantaneous sound measure function.• Measurement Range : 30 ~ 130decibel• With two equivalent weighed sound pressure levels, A & C.• Fast & Slow dynamic characteristic modes.• AC & DC signed output for frequency analyzer level recorder, FFT analyzer, graphic recorder etc.
-
Kronos -
Afore
Wafer level test handler for 6/9DOF sensors with real stimulus. Very high UPH capacity and the lowest cost of test (COT). KRONOS is one of the only wafer level test solutions for motion sensors with real stimulus.
-
CT-DLM870D -
Cabletronix
The CT-DLM870D is a hand held signal level meter capable of reading analog, digital QAM and digital off air signal levels as well as Carrier to Noise, Bit Error Rate (BER), Modulation Error Rate (MER) and tilt.
-
LTR600 Series -
Smartech Inc.
Level Test & Calibration Rig – a boon to Petrochemical Refineries & other process Industries – relies on state of the art simple design for Primary & Interface liquid level testing & calibration of various types / models of Level Measurement (& control) devices including Float / Displacer / Radar / Capacitance / Ultrasonic / Magnetic – for both In-built & External Chamber types. Available Ranges / Span are 1000mm / 1500mm & 2000mm (1 / 1.5 & 2 Meters).
-
Extech SL130W -
Extech Instruments Corporation
The SL130W is a sound level alert with alarm for continuous monitoring of sound levels. Ideal for industrial, hospital, auditoriums, schools and other areas where there is a need for being alerted when sound level reaches set points. Bright LEDs (red flashing or green) alert user when sound level is too high or too low - LEDs can be read from 30m (100ft). You can set the SL130 so the RED LEDs flash when the sound level is below the"LO" set point where people in the audience may not be able to hear. When the sound level is above the "LO" set point, the GREEN LEDs indicate the sound level is acceptable. You can reverse the Red and Green LEDs activation per user color preference. Wall, desk or tripod mount with optional 15ft (5m) microphone extension cable for remote monitoring. User settable high or low limit (30 to 130dB) with output to drive external relay module. Meets ANSI Type 2 and EN 60651 accuracy specs - compliant to OSHA. Complete with 100-240V AC 50/60Hz adapter and microphone wind cover. 8 x AA batteries (not included) can be used for monitoring function only without LED alert.
-
HR7311 -
HighReach Measuring & Controlling System Co.,Ltd
The HR7311 radar water level gauge is a high-precision, low-power non-contact radar level gauge designed by our company. It can be used for surface (or pipe network) water level measurement; due to its pulse coherent radar (PCR) Having with the traditional pulse radar level gauge, the technology has higher measurement accuracy and lower power consumption, as well as ultra-small volume. At the same time, it uses 60G sub-millimeter radar wave as carrier signal, so it has high precision And small size. The volume and energy saving features make it independent of temperature gradients, water vapor, water contaminants and sediments. The optimized algorithm makes the measurement results more accurate.
-
SoundMeter -
Faber Acoustical, LLC
SoundMeter turns your iOS device into a handheld sound level meter (SLM) with support for exponential-time-weighted sound level (Lp) and equivalent sound level (Leq) measurements with various time and frequency weightings. The built-in signal generator tool can be used for generating calibration test tones, noise, chirps, or other periodic signals. SoundMeter also offers additional tools via in-app purchase, including a Noise Dosimeter and a whole or 1/3-octave real-time analyzer.
-
PCA9306 -
SparkFun Electronics
There are a couple must-have boards that every engineer and hobbyist should have on their desk, and this PCA9306 dual, bidirectional voltage-level translator breakout is one of them! Because different parts sometimes use different voltage levels to communicate, voltage level translators can be the key to making different parts play nice.
-
AMETEK Drexelbrook
The Total Tank Level System is an intrinsically safe and explosion proof level sensor with several communication options. Outputs include Modbus RTU digital, dual 4-20mA and HART. The Modbus version is offered in a single housing and the 4-20mA and HART output product features a dual compartment housing and display.
-
DCX-22 AA -
KELLER AG für Druckmesstechnik
The data collector DCX-22 AA measures and records ground water levels using KELLER's two sensor AA-technology (absolute-absolute). The submersible depth sensor measures the water level. Barometric pressure variations are measured and compensated with the built-in waterproof air pressure sensor which is mounted in the electronics housing at the top of the borehole.
-
28090 -
Parallax Inc.
The Mini Liquid Level Sensor is made to be inserted vertically into wet environments to detect liquid level from 0 to 1.88” (48 mm) or as an alarm. This sensor has a single analog output which may be directly connected to the Propeller Activity Board 4-channel A/D converter or easily interfaced with the MCP3002 A/D with a FLiP Multicore Microcontroller.
-
"Eddy" -
Anfatec Instruments AG
„Eddy“ is an Atomic Force Microscopy system for student's education. It bases on the approved Level AFM setup and includes a full sample set and a large cantilever set.