Showing results: 46 - 60 of 157 items found.
-
ARP5412B -
National Technical Systems
The waveforms provided in the ARP5412 are considered to be adequate for the demonstration of compliance for the protection of an aircraft and its systems against the lightning environment and should be applied in accordance with the aircraft lightning strike zones (see ARP5414) and test methods (see ARP5416), and applicable FAA and EASA advisory and interpretive material.
-
ALARM -
Vaisala Oyj
Cloud-to-ground lightning activity shown in three ranges and in directional octants when used with a Vaisala TSS 928™ sensorCloud lightning counts when used with a Vaisala TSS 928™ sensorElectric field intensity measurements when used with up to seven Vaisala EFM II sensorsDisplays data within a 30-nautical mile (56-km) radius around the location
-
Kast Eng Co. LTD.
All electric equipments & systems is required Impulse Simulation Test to the to be tested under the condition where the power source is applied to the product-under-test.At this test condition, the decoupler is needed to reduce the impulse flowing through the power line while testing. And the coupler which is inserted between tester and product, to simulate the actual condition, so the electric circuit of decoupler is prescribet by IEC rules.
-
506AX -
Shenzhen Chuangxin Instruments Co., Ltd.
Automatic lightning surge generator (or Lightning surge immunity) is used to assess the power cord and connect the internal switch stood in line to connect the internal switch to provide a common basis for switching the natural world and lightning caused by the high-energy transient interference performance. Performance fully meets the IEC 61000-4-5, EN61000-4-5 and GB/T17626.5 standards.
-
National Technical Systems
NTS’ Pittsfield, Massachusetts facility has long been involved in the wind power industry. Our participation in the IEC TC-88 PT 24 committee which is responsible for releasing the wind industry test standard IEC 61400-24 and the development of our analytical modeling capabilities enable our engineering department to provide the design evaluation and testing services your wind power products require.
-
Towers & Antennas -
LBA Group, Inc
LBA offers a wide variety of lightning air terminals in the form of lightning dissipaters. Sometimes called a static dissipater, or static dissipation array, this relatively new and advanced air terminal replaces conventional lightning rods in most applications. It functions as a streamer retarding air terminal.
-
Boltek Corp.
Long-range lightning detectors are helpful in advance planning. The LD-250 and LD-350 are suitable for both desktop and laptop computers. The LD-250 can be used mobile for storm chasing. The LD-350 can be used as a stand-alone lightning network detector. Similar to the LD-250 & LD-350, StormTracker is a long-range lightning detector helpful in advance planning and can also be used as a lightning network detector. The StormTracker PCI requires installation in a desktop PC. CLICK HERE FOR A PRODUCT COMPARISON CHART
-
-
National Technical Systems
Airworthiness authorities require that aircraft be protected and certified against the effects of lightning, but few such regulations exist for sensitive facilities on the ground. If it is possible to protect an aircraft that is highly dependent on electronics from a direct lightning strike, it is certainly possible to protect important ground-based facilities. For this purpose, professionals must re-evaluate and update lightning protection methods for advanced facilities. NTS and Lightning Technologies have been in the forefront of this technology for more than 20 years.
-
GEM-Lightning -
EDI Enterprises
GEM-Lightning is a low-cost, handheld device for monitoring and testing (BERT) of T1 and E1 interfaces present in telecom central offices and test labs. GEM-Lightning is an essential tool for switch technicians and customer service personnel attempting to identify problematic circuits in the field. The portability GEM-Lightning makes it a must for the technician on the move while its remote logging capability allows the capture of information for later analysis.
-
SG61000-5 -
Lisun Electronics Inc.
Automatic lightning surge generator (or Lightning surge immunity) SG61000-5 is used to assess the power cord and connect the internal switch stood in line to connect the internal switch to provide a common basis for switching the natural world and lightning caused by the high-energy transient interference performance. Performance fully meets the IEC 61000-4-5, EN61000-4-5 and GB/T17626.5 standards.
-
TOA Systems Inc.
From the industry innovators who first developed modern lightning detection technology, a premium-quality visual and audible warning system designed to provide unattended, automated monitoring and conspicuous outdoor alerting of approaching lightning activity.
-
GDCY -
HV Hipot Electric Co.,Ltd.
The impulse voltage generator is mainly used to the field of impulse voltage tests by lightning impulse voltage full wave, lightning impulse voltage chipped wave and operate impulse voltage wave for such test products as electrical instrument.
-
SGTEL-168 -
Com-Power Corporation
The SGTEL-168 is a versatile surge generator designed to simulate all the environmental surge transients as described in FCC TIA-968-B (formerly known as Part 68) and Industry Canada CS03 standard. It provides a single box solution Type A, Type B (metallic and longitudinal) and Powerline surges. These surges simulate the effect of lightning on telecom equipment under test. So it is also referred to as Lightning Simulator. The electromagnetic energy from the lightning couples into the equipment by powerline or telecom cable exposed to the lightning directly or indirectly. This model is an upgraded version of SG-168 with windows software control and a user friendly front panel for manual operation.
-
