Showing results: 1126 - 1140 of 3380 items found.
-
North Atlantic Industries
NAI''s Power Monitors are used to monitor voltage, frequency, phase characteristics, or phase rotation of single- and three-phase power lines. Specifically designed for rugged defense and industrial applications, these Power Monitors meet the most stringent performance and environmental requirements.
-
Keysight Technologies
Keysight dividers and splitters are used in a wide range of applications, such as: transmission line fault testing, power combining, source leveling, ratio measurements, power splitting, and critical signal processing applications that require minimal insertion loss and high port isolation.
-
CAEN S.p.A.
CAEN has developed a new line of fully independent Desktop and Rack-Mount High Voltage Power Supplies. Offered with various V/I output configurations, CAEN Desktop and Rack-Mount Power Supplies are flexible enough to bias a wide range of detector types.
-
Klein Tools, Inc.
Klein Tools' line of clamp meters is designed to give professionals increased accuracy and easy to read results regardless of what the job requires. These meters are built to stand up to tough jobsite conditions and have been designed with specific trades in mind.
-
RLMSD-2.0 -
Dynamic Load Monitoring Ltd.
The RLM/Saddleback display unit is designed for use with DLM modular equipment, specifically the Running Line Monitor’s and Saddleback’s. The display is built suitable for rugged environments and can be supplied as either a portable unit in a peli case or as fixed installation unit in a stainless steel enclosure.
-
-
VM-DBA -
W-IE-NE-R, Plein & Baus GmbH
VM-DBA is a new test and diagnostic module for VME-bus systems which visualizes activities on all VME bus lines on the set of front-panel LEDs, but also allows one to digitize individual waveforms of all these lines into 2kBit -long storage memories, for a subsequent readout via VME or USB interfaces.
-
81300-A Series -
Coaxial Dynamics
The 81300-A series of High-Power Directional RF Wattmeters are designed to measure RF power in 50-Ohm 3-1/8 inch coaxial transmission lines. To use the Wattmeter, simply connect it between the transmitter and antenna or dummy load and plug in the appropriate measuring element.
-
MSL -
Rycom Instruments, Inc.
The Magnastick™ MSL™ magnetometers seeks ferromagnetic objects by sensing their magnetic fields. Dual toroidal sensor coils are highly sensitive to the magnetic lines of flux naturally present in ferrous (iron) materials and are not affected by non-ferrous materials such as brass, aluminum, or copper.
-
VLSI Standards, Inc.
The NanoCD™ (NCD) is the first commercially available standard to provide line width accuracy calibration at the 45 nm, 65 nm, 90 nm and 130 nm nodes. Use these standards for tool matching, calibrating the width of a CD-AFM tip, or CD-SEM diagnostics.
-
LE-PC300G -
LINEEYE Co., Ltd.
LE-PC300G is Windows® software which enables a PC to control LINE EYE protocol analyzers from remote in order to use measurement data of those analyzers on a PC. It is compatible with the following analyzers: LE-3500, LE-2500, LE-1500, LE-7200, LE-3200, LE-2200 and LE-1200.
-
Laurel Electronics, Inc
Exceptionally fast response (up to 20 updates per second) and high accuracy for low frequencies, such as AC line frequency. A resolution of 1, 0.1 or 0.01 is user-selectable. Accuracy is 0.01% up to 100 Hz, 0.1% at 1 kHz, and 1% at 10 kHz.
-
CMM -
Creaform Inc.
The HandyPROBE arm-free probing system generates high-accuracy measurements (accuracy of up to 22 µm), and outperforms traditional portable CMMs on the shop floor. The HandyPROBE portable CMM is currently used on the production lines of major players from the automotive, aerospace and manufacturing industries.
-
TBM300 -
Telonic Berkeley, Inc.
The Model TBM300 Portable Opacity Meter consists of two basic units connected by a single cable. The sensor unit is installed end-of-line on the exhaust outlet of the vehicle under test and contains the light source (green led) and receiver (photo detector) modules.
-
CAL-AV Labs, Inc.
he CAL-AV Research & Electronic Test Product line includes Explosive Test Site Range Instrumentation, Illuminated Laser Warning Signs and Special Projects.. Firesets, CDU’s EDU’s, Delay generators, firing panels, and custom instruments. Fiber-optic and computer-control options.