Showing results: 2686 - 2700 of 4170 items found.
-
8230 AJ -
Safran Federal Systems
The 8230AJ anti-jam antenna is a high gain (40 dB) GNSS outdoor antenna with a unique conical antenna pattern that rejects interference from the horizon. The antenna rejects signals at lower elevation angles – where most of the interference comes from – and only receives signals from higher elevation angles where the true satellites are. This way, you get all the performance and timing accuracy you would with a standard antenna plus 20 dB or more of interference rejection.It uses a three-stage low noise amplifier, a mid- section SAW, and a tight pre-filter to protect against saturation by high level sub-harmonics and L-band signals. The antenna covers GPS L1, GLONASS L1, BeiDou B1, Galileo E1, and QZSS L1.
-
SDS1000X-E Series -
SIGLENT Technologies
SIGLENT’s new SDS1000X-E Series Super Phosphor Oscilloscope is available in 100 and 200 MHz bandwidths and 2 or 4 analog channels. It has a maximum sample rate of 1 GSa/s and a standard record length of 14 Mpts. For ease-of-use, the most commonly used functions can be accessed with its user-friendly front panel design.The SDS1000X-E series employs a new generation of SPO (Super Phosphor Oscilloscope) technology that provides excellent signal fidelity and performance. The system noise is also lower than similar products in the industry. It comes with a minimum vertical input range of 500 uV/div, an innovative digital trigger system with high sensitivity and low jitter, and a waveform capture rate of 400,000 frames/ sec (sequence mode).
-
Pasternack Enterprises, Inc.
Pasternack SSMB connector category has several part numbers, most are RoHS and REACH compliant. SSMB connector series in this category will terminate to coax, PCB (printed circuit board) or terminal. Our SSMB connectors are built to precise microwave and RF industry specifications. Connectors with SSMB series are manufactured in jack or plug gender with 50 Ohm impedance. SSMB connector items are available in straight or right angle versions, as well as, bulkhead, 4 hole panel or mountless options. These SSMB connector designs include crimp/solder or solder attachment methods. As with the other over 40,000 RF, microwave and millimeter wave products at Pasternack, this SSMB connector series is in-stock. Not just in stock, but these connectors also will ship the same day as they are purchased.
-
Pasternack Enterprises, Inc.
Pasternack MHV connector category includes dozens of part numbers, most are RoHS and REACH compliant. MHV connector series in this category will terminate to coax or terminal. Our MHV connectors are built to precise microwave and RF industry specifications. Connectors in MHV series are constructed in male or female gender with 50 Ohm impedance. MHV connectors are available in straight or right angle versions, as well as, bulkhead, 4 hole panel or mountless options. These MHV connector designs include clamp/solder, crimp/solder or solder attachment methods. As with the other over 40,000 RF, microwave and millimeter wave products from Pasternack, this MHV connector series is in-stock. Not only in stock, but these coaxial connectors will also ship the same day as they are purchased.
-
Pasternack Enterprises, Inc.
Pasternack 10-32 connector category includes many part numbers, most of which are RoHS and REACH compliant. 10-32 connector series in this category will terminate to coax, PCB (printed circuit board) or terminal. Pasternack 10-32 connectors are built to precise microwave and RF industry specifications. 10/32 connector items are constructed in male or female gender with 50 Ohm impedance. Connectors in 10-32 series are available in straight or right angle versions, as well as, bulkhead or mountless options. These 10-32 connector designs include clamp/solder, crimp/solder or solder attachment methods. Like the other over 40,000 RF, microwave and millimeter wave Pasternack products, this 10-32 connector series is in-stock. Not only in stock, but will also ship the same day as purchased.
-
Pasternack Enterprises, Inc.
Pasternack QMA connector category contains dozens of part numbers, most of which are RoHS and REACH compliant. QMA connector series in this category will terminate to coax or PCB (printed circuit board). Our QMA connectors are built to precise microwave and RF industry specifications. QMA connector products are manufactured in male or female gender with 50 Ohm impedance. Connectors in the QMA category are available in straight or right angle versions, as well as, bulkhead or mountless options. These QMA connector designs include crimp/solder, solder or solder/solder attachment methods. As with our other over 40,000 RF, microwave and millimeter wave products from Pasternack, this QMA connector series is in-stock. Not only in stock, but these connectors will ship the same day as they are purchased.
-
Pasternack Enterprises, Inc.
Pasternack QN connector category includes many part numbers, most of which are RoHS and REACH compliant. QN connector series in this category will terminate to coax or terminal. Our QN connectors are built to precise microwave and RF industry specifications. Connector QN series are constructed in male or female gender with 50 Ohm impedance. QN connectors are available in straight or right angle versions, as well as, bulkhead, 4 hole panel or mountless options. These QN connector designs include crimp/solder, solder or solder/solder attachment methods. As with our other over 40,000 RF, microwave and millimeter wave products from Pasternack, this QN connector series is in-stock. Not just in stock, but these RF connectors also ship the day same they are purchased.
-
Pasternack Enterprises, Inc.
Pasternack 2.92mm connector category includes many part numbers, most of which are RoHS and REACH compliant. 2.92mm connector series in this category will terminate to coax or terminal. These 2.92mm connector products are built to precise microwave and RF industry specifications. 2.92mm connectors are manufactured in male or female gender with 50 Ohm impedance. 2.92mm connectors are available in threaded, bulkhead, 2 hole panel, 4 hole panel or mountless options. These 2.92 mm connector designs include clamp/solder, field replaceable or solder attachment methods. As with the other over 40,000 RF, microwave and millimeter wave Pasternack products, this 2.92mm connector series is in-stock. In addition to being in stock, these 2.92mm connectors will ship the same day as they are purchased.
-
ReaXus MX Class -
Teledyne LABS
The economical MX Class consists of single-headed, positive displacement piston pumps incorporating additional features for challenging applications. With pressure capability up to 5,000 psi, the MX Class can be used in both analytical and smallscale preparative HPLC separations. Further applications include demanding metering and dispensing, as well as Sample Injection, Infusion, or Cone Wash for Mass Spectrometers. Standard fluid path material is Stainless Steel.Features include available pressure monitoring with automatic pressure compensation, Pulse Dampener, integrated Prime-Purge Valve, interactive keypad control, and complete PC control and status through RS-232 and Micro USB 2.0 ports. Requiring minimal bench space for the performance, the MX Class will easily integrate into most workspaces.
-
UTS 4.3 -
Teledyne LABS
The UTS 4.3 LAB is a universal and fully automatic tablet testing system based on the long-proven UTS 4.1 - this was developed for industrial use and can be found in production worldwide. The UTS 4.3 LAB is now equipped with the database-driven, intuitive all-in-one touch software and no longer requires additional software solutions for most areas of application.The functionality of the software can be extended modularly and individually adapted to your needs and requirements. FDA regulations can be fulfilled with the optional FDA-21-CFR-Part-11 module.With UTS 4.3 LAB – as with the proven UTS 4.1 IPC – you can test round, oval, square and rectangular tablets as well as numerous special shapes. For difficult oblong tablets, the globally used Oblong Centering System (OZB) can also be integrated.
-
275 HP -
Standard Electric Works Co., Ltd
● Protection class: IP65.● 8 voltage settings: 240Vac, 2kV, 6kV, 11kV, 22kV, 33kV, 132kV, and 275kV.● High bright LED visual indication.● Sound indication.● Easy-to-prove method.● Self-test selection.● Use 3 × 1.5V “C” batteries.● High impact nylon casing.● Non-contact work by proximity.● Compatible with most link sticks.● Lightweight, robust, & compact.● Suitable for indoor and outdoor use.● Detects low voltage on any systems.● Easy access to batteries.● No special parts needed.● Meets EN 61326-1 CISPR 11 EN 61000-4-2 EN 61000-4-3● United States Design Patent : US D474, 705 S● Special ranges are available upon request.
-
DRTS 66 -
Altanova Group
DRTS 66 is the most powerful diagnostic test set designed to perform accurate tests on protection relays, transducers, energy and power quality meters. This advanced test equipment is also thought to satisfy all the needs related to commissioning and substation maintenance. 6 Current and 6 Voltage generators simultaneously available.
-
DRTS 34 -
Altanova Group
DRTS 34 is the most powerful diagnostic test set designed to perform accurate tests on protection relays, transducers, energy and power quality meters. This advanced test equipment is also thought to satisfy all the needs related to commissioning and substation maintenance. 3 Current and 4 Voltage generators simultaneously available.
-
DRTS 33 -
Altanova Group
DRTS 33 is the most powerful diagnostic test set designed to perform accurate tests on protection relays, transducers, energy and power quality meters. This advanced test equipment is also thought to satisfy all the needs related to commissioning and substation maintenance. 3 Current and 3 Voltage generators simultaneously available.
-
Innovative Testing Solutions, Inc.
We have multiple chamber capabilities of simulation most environmental conditions. Our chamber range in capacity from 1 ft3 to 64 ft3 volume. Specialty chambers include air-to-air thermal shock, inert gas injection oven, high/low pressure water spray and direct-injection LN2 chambers.
