Showing recent results 1561 - 1575 of 4367 products found.
-
Ohmcorr Test System™ - James Instruments Inc.
OhmCorr has two probes spaced 1.97" (5cm) apart which are placed in holes drilled to a depth of 3/8th" (8mm) and filled with conductive gel. The direct digital read-out of resistivity is displayed on the LCD when the control switch is activated. OhmCorr and CorMap, when used together, provide an economical and sound diagnostic system of corrosion in reinforced concrete.
-
POLARES - PASI srl
Till this moment the use of Electrical Resistivity Tomography (ERT) for geology has always been basically the same since its debut, based on the original vertical Electrical Soundings (VES) principles: applying a continuous current to two stakes inserted into the ground and measuring the corresponding voltage between other two. The applied current and thus the relative tension have always been continuous, with an inversion in polarity for each measure. The new tool POLARES uses an alternate current, instead, sinusoidal type, with an adjustable frequency.
-
MFJ-805 - MFJ Enterprises, Inc.
Use this ultra-sensitive pocket-sized RFI Detector to track down and eliminates RFI caused by radiating cables and wires. Usable from VLF to VHF. Gain adjustable over 50dB range.
-
KT-2819 - KILTER ELECTRONIC CO.,LTD
320*240 dot-matrix large graphics LCD display. Dendriform operation structure with softkeys. Test speed up to 200kHz can be programmed with 0.01Hz steps. 0.05 test accuracies. Measuring with 9 ranges,ensuring high accuracy,stability and identity. 2 different signal source output impedances with 30¦¸¡¢100¦¸ Open/Short/Load correction functions
-
Micro Junior 2 - Raytech GmbH
Measuring and recording of contact resistance. Range 1mADC: 40 kOhm ... 400 kOhm Resolution: 5 Digits
-
VA 6502 - Shanghai Yi Hua V&A Instrument Co., Ltd. CO.,LTD
Specifications ·measurement range: -50℃~270℃; -58℉~518℉ ·Resolution: 0.1℃(-50℃~200℃) ; 1℃(200℃~270℃) ·Accuracy: -50℃~ -20℃: ±(reading×1.5%+1℃) -20℃~200℃: ±(reading×1.0%+1℃) 200℃~270℃: ±(reading×2.0%+4℃) ·Auto power off: 8min ·Low battery indication ·℃/℉ display selection
-
KUSAM-MECO
• Measurement Range : -50°C ~ 270°C; -58°F ~ 518°F• Resolution : 0.1°C (-50°C ~ 200°C) ; 1°C (200°C ~ 270°C)• Accuracy : -50°C ~ -20°C : ± (reading x 1.5% + 1°C), -20°C ~ 200°C : ± (reading x 1.0% + 1°C), 200°C ~ 270°C : ± (reading x 2.0% + 4°C)• Auto Power Off : 8min• Low Battery indication• °C / °F display selection
-
DOT600 - Campbell Scientific, Inc.
The DOT600 is a stand-alone product that measures volumetric and gravimetric water content of samples of earthen material in roadbeds and foundations. Portability, along with quick and accurate measurements, make it a valuable tool for evaluating roadbed material both at the construction site and in the soil-test lab.
-
MR 1012 S - Schuetz Messtechnik GmbH
Owing to its high measuring rate, its compact and robust design, ist accuracy and long-term stability, the digital ohmmeter MR1012S can be used in applications with high requirements concerning the measuring stability and reliability. This is guaranteed by the integrating measuring method according to the quotient principle, the compensation of all thermoelectric forces and other offset voltages, as well as the suppression of interference voltages in the measuring and data lines induced e.g. by HF.
-
SKZ134 - SKZ Industrial Co., Ltd
Used to test plastic value and restoration value of raw rubber, plastic rubber and rubber. It takes high accurate temperature control and time instrument with digital setting, temperature and time display.
-
STC-0101 - Red Lemon Incorporation
For analogue and digital signals. The satfinder is connected between the LNB and the satelite receiver for quick and easy adjustment of the satelite dish. dB-gain control.
-
SSM-22 - Pro Brand International, Inc.
The SSM-22 is used in the alignment of a satellite antenna (dish) and for checking the signaling from a satellite receiver (IRD) to an LNB. It can supply LNB voltages of 13V, 13V/22KHz, 18V, 18V/22KHz to an LNB from its internal rechargeable nicad battery. It will also check for those signals from an IRD.
-
ST-6000 - Wuhan Sunma Technologies Co., Ltd.
he Digital satellite finder ST6000 is a professional, quality made instrument for setting and aligning a satellite dish to any satellite. According to parameters of the satellite, you can set and align a satellite dish very accurately, quickly and conveniently.
-
SLAM96/96s - Swires Research
Swires Research presents the SLAM96 range of Signal Level Analyser Meters, to offer even better user convenience when taking measurements. Similar to the SL93, the SLAM96 range additionally provides a spectrum display of up to 64 channels, to show at a glance variations in the base line, while the Signal Level display gives the actual reading in decibels.
-
ST-200Q - Wuhan Sunma Technologies Co., Ltd.
A test instrument applicable for the maintenance of CATV (Analog, Digital measurement,TILT)system; 2. Compact, light-weight, easy to carry; 3. With dual-channel measurement display, it is convenient and pragmatic; 4. Able to measure MER, BER Signal Level,Channel Power,V/A,C/N,FM,Trunk Voltage
