Showing results 1291 - 1305 of 4388 products found.
-
Finna Group
Since water has a dielectric constant considerable higher than any other material, even a small amount of water in a product will cause the combination dielectric constant to increase substantially. Finna Group’s capacitance meters can easily recognize this increase in water content and are programmed to display the result in direct reading percent moisture content.
-
Versaperm Ltd.
Our Respiration Rate Meter Mk VI is a measuring device that has been designed for the fruit and vegetable produce markets. It is used primarily to optimise packaging to extend shelf life in chilled and ambient conditions, both during shipping and display stages.
-
Type NDB-2 and NDB-3 - National RF, Inc
Type NDB-2 and NDB-3 RF Milliwatt Meters are affordable pieces of test equipment for both the RF laboratory and the home experimenter. Both provide a digital reading of RF power in dB reference 1 milliwatt of power into a 50 ohm load (i.e. 0 dBm). Approx. 15 KHz to 500 MHz
-
470 - Jenway
The 470 hand held conductivity/TDS meter allows calibration by direct cell constant entry or through the use of standard solutions. The display simultaneously shows temperature compensatedconductivity or TDS and temperature. For optimum resolution the best conductivity/TDS range is automatically selected, whilst temperature compensation is achieved using an adjustable temperature coefficient.
-
SonicSniffer - ATCP Physical Engineering
SonicSniffer is a portable frequency meter for preventive maintenance of ultrasonic transducers and power ultrasonic stacks, primarily in cutting and ultrasonic welding fields. The SonicSniffer determines the work frequency of the ultrasonic stack analyzing the sound emitted by the equipment during operation. See in the back side of this sheet how to use this information.
-
TBM300 - Telonic Berkeley, Inc.
The Model TBM300 Portable Opacity Meter consists of two basic units connected by a single cable. The sensor unit is installed end-of-line on the exhaust outlet of the vehicle under test and contains the light source (green led) and receiver (photo detector) modules.
-
KL-012 - Kelilong Electron Co.Ltd,
KL-012 Portable pH Meter Technical SpecificationRange 0.00~14.00pH Accuracy ±0.05PH Resolution 0.01PH Operating temperature 0~50.C Automatic Temperature Compensation 0~50.C Power Supply DC 9V Dimensions 150mmX70mmX25mm Weight 238g
-
262 - Walter G. LEGGE Co., Inc.
LEGGE?s 262 Surface Resisitivity Meter is a simple to use, highly repeatable measuring device, for determining the surface resistivity of materials. The 262 incorporates a revolutionary 3 - point probe measuring technique, enabling accurate, consistent and repeatable surface resistivity measurements. Provided with fully rechargeable nickel cadmium battery installed
-
AEMC Instruments
Full line of power and power quality analyzers, loggers and meters including for extending measurement ranges. The wide range of applications include electrical monitoring, harmonic detection & analysis, utility testing, energy management, power factor analysis and correction, power demand and consumption, kW measurement, industrial power systems, and commercial maintenance.
-
ST-1181F - Wuhan Sunma Technologies Co., Ltd.
Signal level meter ST-1181F is specially designed and manufactured for CATV system installation and testing. It‘s a portable instrument, easy to carry with many functions.It can test CATV signal level both at channel and frequency mode. Also it can measure CATV TILT,C/N, trunk cable Voltage, ect
-
180 DSP - Trilithic Inc.
The 180 DSP is a basic installer meter specifically tailored for installation and troubleshooting. Featuring fast measurements and powerful troubleshooting tools the 180 DSP comes equipped with all the tests an installer needs to measure both Analog and Digital signals and ensure the highest quality installation.
-
Horizon MiniSAT - Horizon Global Electronics Ltd
The "MiniSAT" is a simple to use, low cost signal strength meter for digital satellite installation. Features include a large easy to read backlit LCD, integral Ni-Mhbattery pack, dual inputs, audible signal indicator, 22KHz tone and DiSEqC switch command generation and a receiver loop through.
-
DS2400 Series - Deviser Instruments
The DS2400 series QAM analysis meter is mainly used for construction, installation and maintenance of HFC plants. This compact device offers QAM and analog measurements with a simple user interface. The long battery life allows the user to turn up networks all day and get their job done efficiently.
-
Global Digital Instruments, LLC
The SenDEC Motortach performs Tachometer, Hour meter, and Flash Alert functions on ANY rotating shaft, rotating gear, or pulley.?? The MotorTACH does NOT require any external power and can be used on Diesel engines, Compressors, Heating motors,? Process equipment, Power equipment, Generators, or a host of other equipment.?
-
OROS sa
OROS Sound Quality Meter is a dedicated solution for calculating psycho-acoustics metrics for Sound Quality studies. A signal file can be simply loaded. The first initial step is to listen to the signal that has been recorded. The second stage is to select the required parameters and to compute them
