Showing results: 871 - 885 of 2826 items found.
-
8713 -
TEGAM Inc.
For fast response measurement of liquids, gases, or small area surfaces. Sheaths are 5" in length and are constructed with 304 stainless steel. The thermal junction is physically located at the tip of the probe. 3-ft vinyl-clad straight cord. Model 8713 is a Type-K thermocouple probe and Model 8723 is a Type-J thermocouple probe.
-
Testing House, Inc.
Testing House offers full Flying Probe Programming and Test Development using its very own Seica Pilot LX Flying Probe Test Stations.
-
D-COAX, Inc.
D-COAX offers four analytical probe models: HyPac model for package characterization, and two models, Omni and OmniJet, for board level characterization, and DP1.4mm differential, single-ended probe.
-
VC Series -
Japan Electronic Materials Corp.
*Vertical contact Probe Card*No limitation by Pad layout*Large probe area (Suitable for 200mm wafer 1-shot)*Small scrub mark*Suitable for High/Low Temperature Test
-
-
-
-
-
-
-
CSP-30TS-011 -
ECT
high frequency probes for the PCBA test market. This next generation coaxial probe provides instrumentation-quality interface for broadband RF measurements exceeding 20GHz, delivering superior performance while seamlessly mating with pads, vias, and other board features. The CSP-30TS-011 RF probe combines several innovative features to provide a truly reliable and cost-effective testing solution.
-
-
TGP-4204 -
Gemini Data Loggers Ltd.
PT1000 probes are available with this logger that will record down to -200C, making them suitable for cryogenic applications. The probes are of 3-wire construction and use class A elements, making them more accurate than their 2-wire predecessors.
-
Extech 382098 -
Extech Instruments Corporation
Extech's 382098 is a set of 3000 A Flexible Current Clamp Probes for the model 382095 and 382096 power analyzers. Comes with three flexible AC probes that are 610 mm (24 in) long for wrapping around busbars.
-
N2805A -
Keysight Technologies
The N2805A is a 200-MHz differential probe designed to provide superior differential signal measurements with long cable length (5 m), making it ideal in an environment where extended cable length is required. The probe offers 50:1 attenuation ratio, allowing it to be used adequately for up to ±100V DC+peakAC of high voltage differential measurements with high CMRR. The differential probe has a differential input resistance of 4 MΩ and low input capacitance of 4 pF to minimize circuit loading. The probe is powered by Keysight’s oscilloscope AutoProbe interface.