Showing results: 406 - 420 of 473 items found.
-
Rotronic Measurement Solutions
A temperature transmitter is an electrical instrument that interfaces a temperature sensor (e.g. thermocouple, RTD, or thermistor) to a measurement or control device (e.g. PLC, DCS, PC, loop controller, data logger, display, recorder, etc.). Typically, temperature transmitters isolate, amplify, filter noise, linearize, and convert the input signal from the sensor then send (transmit) a standardized output signal to the control device. Common electrical output signals used in manufacturing plants are 4-20mA or 0-10V DC ranges. For example, 4mA could represent 0°C and 20mA means 100°C.
-
SHERLOG -
KoCoS Messtechnik AG
Fault recorder systems with a power quality analyser for comprehensively monitoring and assessing low, medium and high voltage networks in power plants and transformer substations. The measuring devices of the SHERLOG range make very high-resolution recordings of all the disturbances which occur in power supply systems. The behaviour of protection and switchgear devices during these system disturbances is recorded at the same time.
-
WinCAT Systems -
GHI Systems
# True fast transient recorder system.# 4, 8 or 16 channel models.# 1 MHZ aggregate 12 bit sampling, resolution equal to 0.024% of full scale.# 13 record lengths, user selected, 132 msec to 1,320 sec in typical 1-2-5x scope progression.# 6 programmable front end gains, user selected, equal to 0.4, 1, 2, 4, 10 and 20 volts full scale.# Software converts digitized voltages to Engineering units.# Digital Triggering, Amplitude and slope, in engineering units from digitized input signals.
-
AEMC Instruments
Comprehensive line of clamp-on current probes covers the entire spectrum of applications, from electrical panels to substations. AEMC Current Probes measure current without interrupting the circuit under test and extend the measuring capabilities of DMMs, recorders, power meters, and loggers. The numerous jaw sizes are designed to accommodate a wide variety of conductor diameters and ranges. Available for AC or DC measurements.
-
Compact Instruments
Electronic Stethoscope Standard Headphones are designed to help locate the source of excess bearing and machine noise easily at low cost, it is an ideal easy to use listening device for mechanically generated noise in all types of applications, the 3.5mm jack socket tape output can also be fed into an audio tape recorder to store the data for either further analysis or as a reference for future comparison.
-
PEX 8505 -
Broadcom Limited
The ExpressLane™ PEX 8505 5-lane, 5-port switch product offers PCI Express switching capability conforming to the PCI Express Specification r1.1. This device with an equal number of lanes and ports can be used in a wide variety of applications including control planes in the communications and networking markets, embedded systems, notebook and docking stations, set-top boxes, digital video recorders and multi-function printers.
-
TraNET PPC -
Elsys AG
The portable Elsys Data Acquisition Instrument and Transient Recorder TraNET PPC is a high-precision instrument suitable for harsh environments and mission critical applications. It is a very compact, all in one data acquisition solution with a high channel density. The TraNET PPC was specifically designed for flexible portable usage to capture multiple channels simultaneously in applications such as ballistics, explosive tests or acoustic emission.
-
CSP-C2 -
TEGAM Inc.
TEGAM''s Humitran-C Series offers a total temperature and humidity monitoring solution for virtually any application. Each temperature/ humidity controller includes an RH & temperature duct probe, which can be placed up to thousands of feet from the controller. The C series controllers have dual set points with recorder and relay outputs for interfacing to air temperature & humidity devices.
-
CSP-C1 -
TEGAM Inc.
TEGAM''s Humitran-C Series offers a total temperature and humidity monitoring solution for virtually any application. Each temperature/ humidity controller includes an RH & temperature duct probe, which can be placed up to thousands of feet from the controller. The C series controllers have dual set points with recorder and relay outputs for interfacing to air temperature & humidity devices.
-
CSP-F1 -
TEGAM Inc.
TEGAM''s Humitran-C Series offers a total temperature and humidity monitoring solution for virtually any application. Each temperature/ humidity controller includes an RH & temperature duct probe, which can be placed up to thousands of feet from the controller. The C series controllers have dual set points with recorder and relay outputs for interfacing to air temperature & humidity devices.
-
Qualitrol
Multi-functional fault recorder including: -- Disturbance fault record (DFR)- Dynamic disturbance recording (DDR) - Phasor measurement unit (PMU C37-118)- Power Quality (PQ Class A)- Travelling wave fault location (TWS to +/-60m) - Impedance fault location- Protocols (61850, Modbus, DNP3) - Sequence of event recording (SOE)- GPS, IRIG and NTP time sync- iQ+ masterstation software.
-
Meco Instruments Pvt. Ltd.,
Current Transducers measure AC Current and converts it to an industry standard output signal which is directly proportional to the measured input. These Transducers provide an output which is load independent and isolated from the input. The output can be connected to Controllers, Data-Loggers, PLC''''s, Analog / Digital Indicators, Recorders for display, analysis or control. They are ideal for SCADA, Energy Management, Telemetering for Remote, Local as well as Central Monitoring Systems.
-
Chroma ATE Inc.
Adivic/Chroma Group has been in the development of RF & WIreless test solutions for more than a decade. Take RF Recorder as an example, it has been adapted by all major Japanese & Korean automotive brand names such as Toyota, Mitsubishi, Honda, Hyundai, Daewoo...etc., most of the global IC design houses with DTV chips such as Broadcom, Marvell, MTK...etc., and also defense entities around the world.
-
IPM-4 -
FM SYSTEMS, INC.
The IPM-4 digital video level master is used to measure the signal quality of your IP video network. This low cost meter makes 6 different level measurements give you the assurance that your IP video system is working within specifications. It measures the output levels of both the camera and the recorder end of the system in dBm so you can check the near-end and far-end signal levels simultaneously.
-
MS 1200 -
Meltronics Systemtech
*Retrieves the Data from Magnetic / Solid State Recorders (Supports JAGUAR, AN32, IJT, ALH Platforms)*RS232/RS422/Bi-Phase/USB interface with PC AT*Presents Error Messages and Test Reports*Replay, Analysis and printout of selected parameters*Calibration facility for ADR and DAU*Portable System for Snag Analysis of Aircraft*Reports in Tabular/Graphical formats*Used to check serviceability of ADR, DAU without removing from aircraft
