Showing results: 46 - 60 of 112 items found.
-
Shanghai Launch Electric Co., Ltd.
Considering the demands of GIS switchgears, basin type insulators, insulated rods, and gas CT, we started to develop the Oil-Gas, SF6 Gas HV non-partial Discharge Test Equipment since 2000.
-
WIKA Alexander Wiegand SE & Co. KG
WIKA gas density indicators are hermetically sealed and temperature-compensated. Measured value fluctuations and misinterpretations caused by changes in either ambient temperature or atmospheric pressure are therefore prevented. The gas density indicators are manufactured entirely from stainless steel and are used for the on-site monitoring of the SF6 density on medium and high-voltage switchgear.
-
Crest Test Systems Pvt. Ltd.
Endurance testing involves operating – closing and opening – the circuit breaker repeatedly for a set number of cycles. This test is necessary to stabilize the circuit breaker mechanism and to identify “Early Infant Mortality” failures in the switchgear assembly.
-
Crest Test Systems Pvt. Ltd.
The Portable Point on Wave Synchronous Test Sequencer is India’s only system that helps in time synchronizing the control signals during short circuit tests performed on medium and high voltage switchgear and control gear.
-
Supreme Instrument Laboratories
Single Phase A.C. High Voltage Test set (BDV Flash Test) suitable for operation on 230 Volts, A.C. 50 Hz., designed for carrying out dielectric test on transformers, electrical switchgears, and installations. It operates on single phase A.C. and provides an output voltage zero to maximum rated voltage.
-
ASM-E -
IPEC Ltd.
The ASM-E is a permanent partial discharge monitor for cables, switchgear and other high voltage assets.The ASM-E can be configured with up to 128 PD sensor channels. If excessive discharge is detected, the ASM-E raises an alarm that can be configured either locally or by email/SMS. This enables the long-term assessment of plant conditions to be carried out quickly and easily, from any remote computer.
-
VDL-01AB -
Hachmann Innovative Elektronik
VisualDetect LCD is an easily operated voltage detector and interface-tester. Its automatic, thorough self-test ensures reliable function. The permanently enabled interface-tester warns against defect interfaces. Additionally the LC-display indicates the measured current [I/A] and frequency [f/Hz]. Thanks to the integrated configuration menu it can be adjusted to switchgears operated below nominal voltage on-site.
-
WIKA Alexander Wiegand SE & Co. KG
Leakage in switchgear can cause high maintenance costs and, depending on the size, can quickly become a safety risk. Thus, gas leaks must be pinpointed promptly and reliably and then eliminated. Our detection instruments are used for monitoring the air in enclosed rooms, locating leakage points and for integral leak testing. Even small quantities of SF6 gas can be detected in air.
-
Flexible Coil Current Sensor -
MEET International Ltd.
*Analysis of harmonics, power measurements*Very high-current monitoring*Measuring starting transients of electric motors*Sudden short circuit testing*Arc furnace currents*High-current monitoring of switch-gear and fuses*Data logging*Can be measured by popular multi-meter
-
VDb-01 -
Hachmann Innovative Elektronik
VisualDetect basic is an easily operated voltage detector and interface-tester. Its automatic, thorough self-test ensures reliable function. The permanently enabled interface-tester warns against defect interfaces, whereas a dot matrix display shows the measured current [I/A] or frequency [f/Hz]. Thanks to the integrated configuration menu it can be adjusted to switchgears operated below nominal voltage on-site.
-
JHPD-20 -
Xiamen Jiahua Electrical Technology Co.,Ltd
JHPD-20 detects and diagnoses the partial discharge inside the gas insulated switchgear (GIS). By using the UHF sensor attached on the surface of GIS or inside the GIS and the noise sensor which excludes the disturbance signal, the detector analyzes the GIS operation condition.
-
Mors Smitt Group
Arc fault protection for the fast clearance of arcing faults on BUS bars & within metal clad switchgear & associated cable boxes. The arc is detected using an optical sensor & the signal input to a protection device which alsomonitors the load current on the system.
-
Phoenix Contact GmbH & Co. KG
FAME is the innovative, modular plug-in test system for measuring and testing tasks in protection technology for medium-voltage and high-voltage switchgear. The plug-in test system combines complex switching operations for testing the function of current transformers and voltage transducers, as well as tripping and signal contacts.
-
Neutronics Manufacturing Co.
We offer Manually operated Transformer Oil Testing Kits to check the DI-electric strength of the insulating Oils as per relevant specifications via. IS 6972. It is a useful equipment for transformer / switchgear manufacturing units. Oil frittering agencies, repair shop and electrical maintenance departments.
-
VFT -
Dr. Strauss Messtechnik GmbH
The VFT-Measuring System TR-AS RC for VFT is special designed for high bandwitdth and allows measurements of very fast transients (VTF) in a frequency range from power frequency up to 100MHz directly with help of capacitive sensor, e.g PD-Sensors Installed in GAS-insulated Switchgear (GIS)