Showing results: 1186 - 1200 of 4403 items found.
-
Doppler Systems Inc.
Doppler Systems offers mobile direction finders for frequencies from 100 to 1000 MHz. The mobile system uses the same DF processor fixed site systems. The mobile antenna utilizes roof mounted summing units and four vertical antennas. Band switching is achieved either by removing one set of antennas and installing another set or we also offer multiple summing unit options that facilitate band switching from within the vehicle.
-
The Rotation Link SAS
Waveguide switches enable switching between two RF channels. The latching type is stable in both positions without holding current. Manual and automatic (electromagnetic) actuators are available.
-
RM984RC -
Abaco Systems Inc
The RM984RC delivers full wire-speed 10/100BaseTX Ethernet Layer-2 switching on all ports. It is available in three models including air-cooled commercial temperature; air-cooled industrial temperature, and conduction-cooled.
-
iEH Series -
TDK-Lambda Corp.
*Standard Eighth Brick Footprint*36-75 Vdc Input*10.8, 11.6 and 12 Vdc Outputs*2250 Vdc Isolation*Digital adaptive control*Constant Switching Frequency
-
60-901-001 -
Pickering Interfaces Ltd.
This tool will simulate all of our PXI & LXI switching products and most of our PXI simulation products allowing for code development independent from your application hardware
-
40-665A-001 -
Pickering Interfaces Ltd.
Model 40-665A-001 is a 18-Channel 1-Pole Power Multiplexer, suitable for switching inductive/capacitive loads up to 10A at 250VAC. It is available with a choice of 1-pole (10A) or 2-pole (8A versions).
-
YAV90063 -
6TL Engineering
The YAV90063 module is suitable for switching inductive/capacitive loads up to 5A at 250VAC. It uses high quality electro-mechanical relays allowing each channel to switch voltage up to 220VDC/250VAC.
-
YAV90076 -
6TL Engineering
48 channels 2A 250V 2 Fault Insertion Buses Switching up to 60W CAN Control (or Ethernet with Ethernet to CAN Gateway) Drivers dll & VIs available
-
YAV90060 -
6TL Engineering
128 relays DPST double matrix (4×16). Switching up to 250Vac and 2A CAN Control (or Ethernet with Ethernet to CAN Gateway) Drivers dll & VIs available
-
40-660A-002 -
Pickering Interfaces Ltd.
Model 40-660A-002 is a 10-Channel 2-Pole Power Multiplexer, suitable for switching inductive/capacitive loads up to 8A at 250VAC. It is available with a choice of 1-pole (10A) or 2-pole (8A versions).
-
NC3000 -
Noisecom
The NC 3000 Series calibrated coaxial noise sources are well suited for receiver testing, noise figure measurements, or applications that require broadband noise and fast switching times.
-
40-660A-001 -
Pickering Interfaces Ltd.
Model 40-660A-001 is a 10-Channel 1-Pole Power Multiplexer, suitable for switching inductive/capacitive loads up to 10A at 250VAC. It is available with a choice of 1-pole (10A) or 2-pole (8A versions).
-
LEMSYS
For testing Switching characteristics: up to 600A and up to 1500V. Short-circuit test up to 2500A. For testing Static characteristics: up to 2000A and up to 10 kV for the static tests.
-
50-120-021 -
Pickering Interfaces Ltd.
This of PCI switching cards are available in both Changeover (SPDT) and Normally Open (SPST & DPST) configurations. Connections are made via a front panel 200 pin female connector.
-
42-166-001 -
Pickering Interfaces Ltd.
The 40/42-166-001 is a PXI/PXIe high density power relay module with 10xSPST switches rated at 30A. The 40/42-166 range is available with SPST, SPDT or SP4T switching configurations.