Showing recent results 3106 - 3120 of 4622 products found.
-
R1L-BR - TEGAM Inc.
The R1L-B series Ohmmeter/Bonding Tester is a digital microohmmeter designed to measure resistances from 10 to 20 . It is used in applications such as metal bonding, switch, circuit breaker, circuit resistance and other contact and connection resistance tests as well as higher resistance measurements for circuit analysis and resistor testing up to 20 . The instruments utilize the four-terminal, Kelvin technique to eliminate errors caused by the resistance of the leads. Resistance readings are viewed on a 3 1/2 digit display,
-
IST-8800 - IST Information Scan Technology, Inc.
The IST-8800 is a fully programmable, low cost tester that provides parameter measurements or parametric GO/NO GO test for transistors, diodes, MOS-FETs, Regulators, Triacs, Zeners, SCRs, and J-FETs. These devices can be tested up to 5 amps or 1200 volts with a measurement range down to the nano amp range. Only four universal test fixtures are required which can test the device across a wide range of packages.
-
3030 Tower - SPEA S.p.A.
3030 Tower is an In-Circuit tester equipped to execute power functional tests. The system allows the execution on the board, after the In-Circuit or parametric test, of all the measurements required for the functional test of power devices: converters, power supplies, generators, power drivers. 3030 Tower can test single-board power supplies and modules, as well as complex power supply and power module units.
-
HS-PSTT - HenergySolar
HS-PSTT large Range Type Tester is a high-grade semiconductor material Type testing equipment,has the feature that testing large range,special suitable for testing the high-Resistivity Silicon Material(contains Silicon Core, phosphorus stick, Boron stick and so on),the resistivity require range is 0.0001～19999Ω·cm, Covers all measurement requirements of various silicon material type testing at the semiconductor and solar energy level at present .
-
TF318 - TESTEX Testing Equipment Systems Ltd.
SPI Flammability Tester (Vinyl Material), to determine the ignition properties of vinyl plastic film material according to CFR 16 Part 1611 U.S.A. Flammable Fabrics Act for flammability of apparel vinyl plastic film.The rate of burning shall not exceed 1.2 in./s as judged by the average of five determinations lengthwise and five determinations transverse to the direction of processing, when specimen is placed at an angle of 45 degree and expose to the standardized flame (22# fire nozzle, 1/2 inch. In length).
-
HS-3FC II - HenergySolar
Super Silicon Resistivity and Type Tester is specially designed for silicon sorting，it can quickly test the silicon type, heavy-doped, resistivity and current, and can be widely used in all kinds of silicon sorting, like granular polysilicon material, break semiconduct silicon wafer, chunk material, top and tail material and so on. Furthermore, it integrates two probes, three probes and four probes. With the three probes, it could show type and heavy type simultaneously, strongly improved the sorting efficiency.
-
MP500 TCL3 - Micropross
The MP500 TCL3 is the newborn in the Micropross testers family, and combines advanced signal generation features to an unmatched flexibility and possibilities of evolution. This tool is to be used in the characterization of contactless smartcards, readers, and NFC devices. The MP500 TCL3 main features are : generation of terminal and smartcard waveshapes, according to the following specifications : ISO 14443 A/B, ISO 15693, FeliCa, Mifare, NFC Forum tags (1,2,3,4)
-
Primetest 250 - Di-Log
Seaward's lightweight, portable Primetest 250 PAT tester is unique in its range of safety tests. The PrimeTest 250 will perform all of the tests required by the IEE Code of Practice, including RCD trip, protective conductor current and touch current where required. The unit also includes a 250V DC insulation test suitable for testing sensitive electrical appliances and surge protected leads.
-
DOW61000-18 - Lisun Electronics Inc.
DOW61000-18 damped oscillatory wave immunity tester consist of powerful test host and high performance damping oscillating wave module. It is fully meets IEC 61000-4-18, EN61000-4-18 and GB/T 17626.12 standards requirement about slow damped oscillatory wave and provide high accuracy test solution for damped oscillatory wave immunity test of electronic products.
-
HTO - Hention Electrical Equipment Co., Ltd.
HTO Transformer Ohmmeter also called DC resistance tester is used for rapid measurement of DC resistance of transformer windings, motor winding, the reactor winding, arc-suppression coil, PT and other inductive devices. It can be used to check the welding quality of welding joints, short circuit, damaged, lead errors, the state of the tap switch and other issues.
-
34000 - S & G Tool Aid Corp
Test compression on all domestic and foreign cars and most trucks. Adapters fit vehicles with 14mm and 18mm plugs including long reach and 5/8" hex plugs. Flex hose eliminates need to remove auxiliary equipment such as power brakes and steering, air conditioning and manifold. Screw in adapters guarantee accuracy over push-in type testers. Quick side release valve permits retest without removal of adapters. Gage ranges 0-300 PSI and 0-21 BAR. Supplied in storage pouch.
-
MicroPhase I - Hachmann Innovative Elektronik
MicroPhase I is an easily operated phase comparator, dual voltage detector and maintenance tester. Its automatic, thorough self-test ensures reliable function. The permanently enabled interface-testers warn against defect interfaces. The integrated "Universal Phase Comparator" compares two different interface signals, even if they are of different interface type or voltage. A unique error control avoids switching errors caused by erratic or unfeasible phase comparison.
-
LinkTest™ DualE1 - GL Communications Inc.
GL's LinkTest DualE1 is a handheld dual-port tester for E1 and data communications (V.11 / X.24, V.24/RS232, V.35, V.36/RS449, EIA-530, EIA-530A) interfaces. With the support of a large range of software options for E1 services and sub rate multiplexing system, this handheld unit provides a scalable test solution for E1 and data testing. It provides a large, clear screen with a full set of physical layer tests for E1 balanced and unbalanced circuits including BERT, VF, round trip delay and signal level.
-
PST-3 - Rexus Corp.
This product is design with LCD to show your ATX power voltage. Simple tester for switching power supply. It makes it easy to test the power supply output. ATX PSU each output connectors check. Tests 20-pin and 24-pin power supplies. Tests SATA power. Tests Pentium 4 power connector. Tests PCI-Express power connectors. Tests Xeon power connectors. Tests Floppy drive connectors. Tests standard 4-pin power supply connectors.
-
C Model - PJ Electronics, Inc.
These Digital High Frequency Surge Testers are the ultimate in ruggedness & durability. Fourteen / sixteen gauge steel construction and mobility on 6" heavy duty rubber wheels makes it a favorite for use in harsh industrial environments. The performance of PJ's exclusive/unique High Frequency Technology is capable of testing the integrity of any turn-to-turn insulation, including low inductance windings.
