Showing recent results 3751 - 3765 of 4813 products found.
-
SME1203 - Scientific Mes-Technik Private Ltd
Single Phase , 3 kV Impulse winding testing Low inductance impulse test: down to 10 μH Low energy test without damaging the coil Fast detection of winding insulation at a speed of 5.5 Meas/sec 4 kinds of waveform comparison methods Up to 40 MSPS sampling rate 320×240 dot-matrix graphic LCD display Multi-trigger mode programmable Voltage, Time and Frequency measuring functions Direct display of comparison result
-
-
3660B/D - PRODIGIT ELECTONICS CO.,LTD.
The 3660B/D is an all-in-one stand-alone unit with built-in hardware and software for all testing requirements. Up to 24 test programs can be edited on a PC with Prodigit's 9906A Application Software (WindowsTM version) and downloaded to and stored in the 3660A built-in EEROM for quick access. Power supply (U.U.T.) information including part number, test requirements and results is shown on the large LCD display.
-
#9008-DL - Innovative Products of America
The Super MUTT places a load on the trailer's electrical circuits to identify wiring problems while providing remote control operation over both air brakes and lights. Built to facilitate a one-man testing operation, the Super MUTT reduces guesswork and inspection time to prevent failures that lead to expensive road calls and citations. The remote control allows for repetitive air brake actuation at each axle to reveal developing problems often missed by normal testing procedures.
-
Holding Informtest
The product is intended for use at enterprises producing and operating electronic objects, as a technological control system and delivery of finished products for electrical testing of control objects (OK).
-
StarTrinity.com
UDP NetworkTester is a freeware tool which enables you to measure quality of your IP network. It can also be used to generate UDP flood or to simulate UDP DoS attack. SIP call is usually established using a SIP session with a bidirectional RTP stream. SIP and RTP protocols are based on UDP transport protocol.
-
MINC I EURO - Maschinenbau Haldenwang GmbH & Co. KG.
The test lane-compatible MINC I EURO guarantees a verification of the axle geometry in seconds when the test vehicle drives over (up to 3.0 t axle load) as well as a fully automatic evaluation of the deviation in m / km. The measured values are displayed either in analog form on a dial or by transmission to a PC screen (including graphic representation).
-
MINC-PROFI - Maschinenbau Haldenwang GmbH & Co. KG.
The test lane-capable MINC-PROFI guarantees that the axle geometry is checked in seconds when the test vehicle drives over it (up to 2.0 t axle load) as well as fully automatic evaluation of the deviation in m / km. The measured values are displayed either in analog form on a dial or by transmission to a PC screen (including graphic representation).
-
9901HT-8762 - Hydraulic Technology, Inc.
The 9901HT-8762 Hydraulic Hose Test System is utilized by the United States Marine Corp. for their portable forward base maintenance stations. The system includes it's own onboard "quiet" air compressor and a set of 37 degree flared test adapters from 3/16" through 2" as well as an onboard calibration gauge and pneumatic castors for use on rough terrain.
-
TOB-SM8124 - Xiamen Tob New Energy Technology Co., Ltd
200V 20 Ohm Portable Battery Tester For Battery Voltage and Resistance Testing. TOB-SM8124 Resistance Voltage Tester is a portable battery tester used for battery voltage and internal resistance test, it is Suitable for lithium-ion battery, nickel-metal hydride, lithium manganese, lead-acid battery and other single battery or battery pack with voltage no more than 200V.
-
7893 - Innovative Products of America
The 7-way Flat Pin Trailer Circuit Tester quickly and easily tests trailer circuits on most light to medium duty trucks and campers. Just plug the plug tester into the trailer plug socket and activate the lights, brakes, turn signal etc.
-
PCCtest 350 - Sycard Technology
The PCCtest 350 socket tester provides a quick and easy way of verifying the operation of a host socket. Housed in a type II PC Card, the PCCtest includes software to test a wide variety of socket controllers from Intel, Cirrus Logic, Vadem, Ricoh, Omega Micro and VLSI Technology. The PCCtest socket tester verifies all signals on the 16-bit PC Card interface including accurate Vcc and Vpp measurements.
-
MBT 2200 LON - Maschinenbau Haldenwang GmbH & Co. KG.
*Basic module for constructing a test lane*Especially suitable for adoption and diagnostic roads*For cars and vans up to 3.5 t and 2200 mm track width and up to 5 t and 2800 mm track width.*With the optional lifting device perfectly suited for the inspection of multi-axle car trailers.*Multi-analog display with two hands (diameter 2 x 350 mm) Display option for:**brake tester**Slip testers**Shock Absorber Tester*Difference display (3-digit + LED bar) for the evaluation of:**Braking force difference**Difference axle damping**Radlaufabweichung*Program control by 32-bit microprocessor electronics enables the finest resolution of the measurement results*Dimensions Display Standard (H x W x D) 630 x 870 x 240 mm*Dimensions Display with option * (H x W x D) 910 x 870 x 300 mm* All-wheel drive, digital display Variodata or marquee
-
CAMI Research Inc. (CableEye®)
A USB Type-C test interface board for CableEye cable and harness testing systems. Consisting of a daughter board, populated with two USB-C female connectors, it allows users to continuity-check USB Type-C terminated cables using the CableEye tester while seeing the connectors-under-test rendered graphically. The CB26U fits all CableEye models.ConfigurationA leader in development of PC-based cable and wire harness, continuity, resistance and hipot test systems for over 20 years, CAMI offers the CableEye suite of products complete with accessories – including “connector boards”. The selection of these test fixture boards is constantly growing and is currently numbering over 60 – most of which are populated with ‘families’ of connectors. When pre-populated boards are used, the tester GUI automatically displays a graphic of the connectors under test.Sold as a set of two boards, each CB26U accepts two USB Type-C connectors. In addition to the latest CableEye software, it requires the CB26 small-frame motherboard (Item 756) for operation, and plugs into one of two available slots – two USB-C-connectors can be tested simultaneously. The CB26 (with CB26U) attaches to the tester like a regular connector board.WarrantyAll connector boards are included in CableEye’s standard, renewable one-year warranty of the tester for which it was purchased.Contact sales@camiresearch.com or +1 (978) 266-2655 for a quote.
-
26847 - C2G, Lastar, Inc.
The LANtest Pro is a small hand-held tester that enables the user to quickly read the status of Ethernet twisted pair cables. It tests for faults such as open circuits, shorts, crossed pairs, reversed pairs and split pairs in seconds.