Showing recent results 271 - 285 of 1045 products found.
-
Unitech Scales And Measurements Pvt. Ltd
Fuel flow- CH-2 Load- CH-3 Air flow- CH-4 Water flow- CH-5 Inlet water Temperature- CH-6 Outlet water Temperature- CH-7 Room Temperature- CH-8 Exhaust Temperature- CH-9 SpeedDisplay 16 x 2 Line LCD Display with back light
-
NUL-239 - Neulog
The NeuLog chloride sensor can be used to measure the concentration of chloride ions (Cl-) in aqueous samples. This measurement can be an indication of the salinity of water samples.The sensor can be used to study samples of drinking water with different degrees of chlorination.
-
L30 Multi-level Switch SS Shaft - Whitman Controls
As many as five level control points and up to 48” in overall length. Mount at top or bottom of tank. Fully customizable. Typically used in potable water, hot water, acids and various solvent applications.
-
L31 Multi-level Switch Stainless Steel - Whitman Controls
As many as six level control points and up to 72” in overall length. Mount at the top or bottom of a tank. It can be fully customized. Typically found in potable water, hot water, acids, and various solvent applications.
-
L31 - Whitman Controls
As many as six level control points and up to 72” in overall length. Mount at the top or bottom of a tank. It can be fully customized. Typically found in potable water, hot water, acids, and various solvent applications.
-
Sequoia Scientific, Inc.
The optical Volume Scattering Function(VSF) is an ‘inherent optical property’ of water that is used by optical oceanographers to predict light propagation, image degradation, remote sensed ocean color, biological environment etc. in water.
-
PSG01 - CL System
PSG01 - PC Programmable Pulse Signal Generator for use in water hydrolyser (water-powered car project). Programmed via laptop or PC. See links for more information on the water / hydrogen powered car project.
-
-
-
MRC ltd.
Are used to quickly measure the turbidity (or cloudiness) of water.
-
SG-B07 - Jinge Testing Machine Co.,Ltd
Mainly used to test the waterproof performance of paper and paperboard. After dropping the water droplets through the upper test tube, check the state of the water flow marks and compare the standard table as the basis of the waterproof level.
-
KROHNE Messtechnik GmbH
This is because pH and ORP measurements are used in conditions spanning measuring pure water in power plant cooling water systems, for instance but also in harsher environments like various chemical applications and industrial wastewater treatment plants.
-
PCE Instruments
At PCE Instruments you will find both standard and waterproof conductivity meters. There are also conductivity meters available for flowing water or pure water (highly recommended for relevant industries) as well as ones Conductivity Meters for flowing water or pure water as well as the ones with different conductivity measurement ranges. with different conductivity measurement ranges. An important factor in our conductivity meters is that they normally measure electric conductivity in µS/cm, however they can also take measurements in mg/l (for direct reading of content in dissolved solid substances). The relation is established as follows: 2 µS/cm = 1ppm (parts per million) = 1 mg/l.
-
Gas Analyzer - Metrohm AG
All-inclusive system for water determination in liquefied and permanent gases
-
