Filter Results By:
Products
Applications
Manufacturers
-
product
Electrical Safety Testers
.AC/DC withstand voltage test & ground bond test .Insulation resistance test(ST60).Arc detection.Zero crossing turn-on,turn-off operation switch.Controllable ramp-up time .Ture RMS cut-off current measurement .Automatic fail indicator of alarm lamp and buzzer.VFD display.Standard PLC interface .Option RS-232,RS-485
-
product
Battery Load Tester
MD4260
Test capabilities: Battery voltage, battery cranking, battery charging volts and good/bad battery test. Test batteries on and off the car in just 30 seconds. Heavy duty copper-plated clamps. Internal loaded unit with a 100-amp load capacity. Load safety switch to prevent arcing. For 6- and 12-volt batteries.
-
product
xDSL PDH Analyzers
Wuhan Sunma Technology Co., Ltd.
xDSL / PDH Analyzer mainly used for comprehensive transmission test of SDH/PDH network and equipment and widely applied in the R&D, manufacture, acceptance inspection, performance monitoring, maintenance and measuring of networks and equipment. The instrument SunmaFiber provided can insert and measure varieties of errors and alarms in PDH and SDH systems (including on-line and off-line test), perform performance analysis on various errors as well as modulate and test jitter signals at a max. test rate of 2488MHz (STM16).
-
product
Tooling And Fixturing
Control develops and supplies fixtures and test accessories :*For a vast field of applications - ICT (In-Circuit Test), functional test, Flash programming, EoL (End-of-Line) test systems, etc.*For all handling systems currently used in the market: online or offline, mechanical, pneumatic or vacuum operation*From simple mechanical fixtures, with a few hundred probes and low production volumes, to highly complex accessories with thousands of probes, double-sided probes, double acting, etc.
-
product
Fuel Injection Pressure Tester with 2 Gages & Quick Couplers in Storage Case
53980
Tests gasoline fuel pump pressure on most domestic and imported fuel injection equipped vehicles.Quick couplers provide for fast and easy hook-up.Kit contains adapters to test all GM vehicles with Multi-port and some Throttle Body Injection (TBI). Tests all Chrysler cars with Multi-port turbos and some TBI.Use on most Ford TBI systems equipped with or without small Schrader test valve.Tests all Ford vehicles with Multi-port fuel injection systems.
-
product
Fuel Injection Pressure Tester w/2 Gages & Quick Couplers
53950
Tests gasoline fuel pump pressure on most domestic and imported fuel injection equipped vehicles.Quick couplers provide for fast and easy hook-up.Kit contains adapters to test all GM vehicles with Multi-port and some Throttle Body Injection (TBI). Tests all Chrysler cars with Multi-port turbos and some TBI.Use on most Ford TBI systems equipped with or without small Schrader test valve.Tests all Ford vehicles with Multi-port fuel injection systems.
-
product
PXIe-4112, 2-Channel, 60 V, 1 A PXI Programmable Power Supply
782857-01
The PXIe‑4112 is a programmable DC power supply with isolated outputs. It helps simplify the task of designing automated test systems for a wide range of applications—from aerospace and defense to automotive and component test—by eliminating the need to mix multiple instrumentation form factors in a given test rack. It also has standard output disconnect functionality that allows isolation from the device under test (DUT) when not in use, and remote sense to correct for losses in system wiring.
-
product
PXIe-4113, 2-Channel, 10 V, 6 A PXI Programmable Power Supply
782857-02
The PXIe‑4113 is a programmable DC power supply with isolated outputs. It helps simplify the task of designing automated test systems for a wide range of applications—from aerospace and defense to automotive and component test—by eliminating the need to mix multiple instrumentation form factors in a given test rack. It also has standard output disconnect functionality that allows isolation from the device under test (DUT) when not in use, and remote sense to correct for losses in system wiring.
-
product
VXT PXIe Vector Transceiver
M9421A
Purpose-built for rapid solution creation and faster throughput in manufacturing test of wireless components, power amplifiers, and RF front-end modules Increase test density and reduce your footprint with up to four VXT instruments in one 18-slot chassis Reduce development time with open-source test libraries and reference solutions Start closer to your finish line with built-in FPGA-accelerated measurements Optimize test routines using proven software for noise figure and standard-specific measurements
-
product
Contact Resistance Measurement System
CRMS
The CRMS is a system designed to allow any user to measure the resistance of each set of relay contacts associated with the relay under test. The test system consists of a CONTACT RESISTANCE MEASUREMENT UNIT (CRMU), a MULTIPLE RELAY TEST RACK, as well as an interconnect CABLE ASSEMBLY. Either DC or AC energy to pick and drop relay coils under test for all contact measurements is supplied from the CRMU and easily interfaces with the Multiple Relay Test Rack. For additional and more thorough testing of relays an external relay tester can be interfaced to the Multiple Relay Test Rack to supply energy to the relay coil. It is recommended that the UTE Relay Tester With Timer/Counter (UTE Product # 15967-00) be utilized so the operator can take full advantage of the unique features it offers
-
product
Elvior TestCast
TTCN-3
Elvior TestCast is a TTCN-3 test development and execution platform which includes TTCN-3 editor, TTCN-3 compiler and TTCN-3 executive. TestCast can be used for testing software or hardware components in a wide range of industry sectors. Candidate systems for testing with TestCast can be found from the industry sectors where TTCN-3 is widely used as an accepted generic test language - telecommunication, IOT, transport and automotive, military and defense. TestCast is ideal for incremental project development. It can be used for testing of an individual task or process. One can continue with the integration tests of a subsystem consisting of processes and later to integrate those subsystems and test them together as a whole software subsystem. It is even possible to continue to perform software/hardware integration tests where TestCast can be used to test software embedded in target hardware.
-
product
Analogue (1kV below) Insulation Tester
8052 IN
Standard Electric Works Co., Ltd
● High quality Taut Band movement.● Three insulation test voltages(DC) : 250V, 500V, 1000V.● Two continuity test on “low ohms” : 3Ω & 500Ω.● AC voltmeter with linear scale up to 600 Vac.● 200mA short circuit current for continuity.● 1mA test current on insulation test at nominal voltage.● Automatic discharge of capacitive and inductive circuit with charge stored in the circuit under test.● Live warning and display of external voltage presence.● Fuse, air gap, crowbar and overload protected.● On line battery monitoring shows if battery is ok.● Manual zero ohm adjustment.● Low battery consumption.● Mirror scale.● Push and turn locking switch for continuous and hand free testing.● Supplied with high quality test leads.
-
product
Analogue (1kV below) Insulation Tester
1652 IN
Standard Electric Works Co., Ltd
● High quality Taut Band movement.● Three insulation test voltages(DC) : 250V, 500V, 1000V.● Two continuity test on “low ohms” : 3Ω & 500Ω.● AC voltmeter with linear scale up to 600 Vac.● 200mA short circuit current for continuity.● 1mA test current on insulation test at nominal voltage.● Automatic discharge of capacitive and inductive circuit with charge stored in the circuit under test.● Live warning and display of external voltage presence.● Fuse, air gap, crowbar and overload protected.● On line battery monitoring shows if battery is ok.● Manual zero ohm adjustment.● Low battery consumption.● Mirror scale.● Push and turn locking switch for continuous and hand free testing.● Supplied with high quality test leads.● BS 16 edition.
-
product
Analogue (1kV below) Insulation Tester
8031 IN
Standard Electric Works Co., Ltd
● High quality Taut Band movement.● Three insulation test voltages(DC) : 250V, 500V, 1000V.● Two continuity test on “low ohms” : 2Ω & 20Ω.● AC voltmeter with linear scale up to 600 Vac.● 200mA short circuit current for continuity.● 1mA test current on insulation test at nominal voltage.● Automatic discharge of capacitive and inductive circuit with charge stored in the circuit under test.● Live warning and display of external voltage presence.● Fuse, air gap, crowbar and overload protected.● On line battery monitoring shows if battery is ok.● Manual zero ohm adjustment.● Low battery consumption.● Mirror scale.● Push and turn locking switch for continuous and hand free testing.● Supplied with high quality test leads.● BS 16 edition.
-
product
Electric Servo Motor Type 3-axis Vibration Tester
The Electric Servomotor Vibration Test System Is A New Vibration Test System Developed Based On The Control Technology Of AC Servomotors That We Have Cultivated Since Its Establishment.
-
product
Battery Load Tester
BTMQ-18
Battery Load Tester LED Analog , Capacity of battery:160Ah, Rated test voltage:6/12 v, Voltage accuracy:+/- 0.1 v, Test cycle:10 seconds
-
product
Circbord
8019-1
VECTOR Electronics and Technology, Inc.
Single sided board, circuit pattern one side only, holes not plated thru.Ideal for common busses, signal line running longer distances, for hard wire of test circuits or discrete components. Tracks run close to board edges. 3U X 160mm Eurocard size will fit into 3U DIN Metric subrack.
-
product
Coverage Analysis
VeroSource
VeroSource-A verifies that all complex decisions (i.e., decisions with at least two conditions) have taken all possible outcomes; and that every condition within the decision has taken all possible outcomes that have independently affected the decision’s outcome. VeroSource automates the capture and structural coverage analysis of the source code under test.
-
product
CPRI Sniffer & Analyzer
SIQMA SC2820
The SIQMA SC2820 CPRI Analyzer is the market’s highest-performing, lowest-cost CPRI test instrument. Unlike other solutions, which have been retrofitted to support CPRI, the SIQMA’s high-performance signal processing hardware was designed specifically for CPRI applications. Because of this, the SIQMA SC2820 offers unparalleled performance at half the price of other CPRI analyzers.
-
product
Dynacell Load Cells
2527 Series
Dynacell is the world's first truly dynamic load cell, designed from the outset for measuring dynamic loads. Dynacell introduces the following advantages: *Reduces dynamic load errors which can be a significant percentage of reading*Increases productivity by allowing higher frequency operation while maintaining test validity *Improvements such as doubling the frequency are common
-
product
Economical LED Display for Remote Annunciator Applications
AN-3100D-LC
LED Illumination for long life, low power Laser Printed window Legends Compact Size Barrier, screw terminal connection Panel or 19" Rack Mounting 4 Windows Sizes: 3x3, 1.5x3, 1x3, 1.5x1.5 Selectable Window Colors: White, Red, Blue, Green Amber Built-in Test Pushbutton option
-
product
FPGA Digital IO XMC
XF07-523
Curtiss-Wright Defense Solutions
The XF07-523 is a rugged Kintex-7 FPGA based XMC with digital IO. The combination of direct high-speed I/O ports and FPGA processing makes the XF07-523 ideal for demanding applications including radar, imaging and test equipment across commercial and defense market spaces. The XMC form-factor is ideal to SWaP constrained platforms such as UAVs and fighter aircraft.
-
product
Industrial Ovens
Curing, drying, ageing, annealing or any heat processing tests at higher temperatures Envisys has the oven to meet your needs Whether it is a standard conventional drying application using shelves or conveyor drying or drying through infrared bulbs Envisys provides all types of drying solutions with custom configured designs and sizes.
-
product
Low-Thermal EMF LXI Matrices
Pickering low-thermal EMF LXI matrices offer excellent thermal stability and substantially reduced thermal EMF figures when compared to a conventional switching matrix. Typical applications include signal routing in automatic test equipment, selecting thermocouple inputs, switching amplifier gain circuits and high accuracy DC microvolt measurements.
-
product
Optical Time Domain Reflectometer
OTDR II
The OTDR II (Optical Time Domain Reflectometer) excels in fault finding on fibre cabling with industry-leading specifications and performance levels on both single-mode and multimode fibre networks. Not only does OTDR II deliver accurate test data and pass/fail results, it also offers automated fault-finding capabilities that help to minimise network downtime.
-
product
Rhopoint IQ Flex 20
Rhopoint IQ Flex 20Conventional gloss instruments are suited to large flat areas and test, as curved surfaces cause errors. The small footprint of the IQ FLEX 20 makes it much more effective on curved surfaces than a conventional glossmeter; its compact size and shape also allows access to difficult to reach areas.
-
product
Temperature Controlled Water Bath
WB
Digital temperature controllerStainless steel tank with structural steel baseTiming circuit refreshes water for a full two minutes each hour preventing buildup of weak acid and stale waterWater level adjustable by standpipe changeOverhead wire tray with openings for optional test leadsHolds 15 SLI storage batteries (BCI group 24)
-
product
UV Radiation Detector
*UV Index measurement from 0-20 (0.5 increment) UVA and UVB*4 digits*Alarm clock : 30 second alarm sound*Alarm chime enable / disable*Clock function : Month, Date, Hour, Minute, Second*Hour format : 12/ 24 selectable*4 years calendar*LC display test
-
product
Virtual Network Emulator
NetropyVE™
NetropyVE™ is the virtual edition of the Netropy network emulator. It offers advanced capabilities to benchmark, troubleshoot, and optimize the performance of critical applications in virtualized test environments. Every virtual machine can be assigned a unique WAN access profile, and then controlled to insert latency, jitter, packet loss, and congestion. Simulate Bandwidth, Latency & Jitter, Loss.
-
product
Magnet Tester
The Magnet Tester invented by JUNG locates magnetic fields and notify it with its integrated lamp: compact, simple and fast!Easily check switch conditions with zero set-up time and no need to halt operations. The magnetic field test stylus is an indispensable tool for countless companies and toolboxes. Its light-function also makes it as an ideal flashlight.