Showing results 2236 - 2250 of 5667 products found

  • GAO5855 - E1 Service Tester

    Company: GAO Tek

    This E1 service tester is a multi-functional digital transmission system test device, designed for the installation test, engineering check and acceptance, daily maintenance of the E1 PCM line (G.703 2Mbit/s), mainly performing channel test, alarm analysis, fault finding and signaling analysis of the E1 (2Mb/s) line. This instrument mainly has following functions:

  • GAO A0060004 - Multi-Function Network Cable Tester

    Company: GAO Tek

    This multi-function network cable tester is specially designed to determine cable length and test for open circuits, short circuits, cross connections, reverse connections and pairing connections and report the position of broken wires.Its multiple functionfeatures together with its fast and accurate testing capability make it a valuable tool for engineers and technicians to use in the installation and maintenance of cabling systems.

  • Continuous Flow Leak/Flow Testers

    Company: ATEQ

    Part of the Grafx simplicity comes from using a touch screen. What ATEQ® had in mind was first and foremost an easy interface that could be understood by even beginners in the leak detection field. Moving forward, it was obvious that combining an easy interface with a touch screen would transform the Grafx G – Flow Tester into a plug and play machine for continuous flow leak testing applications.

  • GAO2018 - E1 BER Tester

    Company: GAO Tek

    GAO2018 E1 BER (Bit Error Rate) Tester is a much small and multi-functional handheld E1 line test instrument , specially designed for E1 PCM line access, maintenance, check and acceptance. It provides BER test, alarm analysis, signaling analysis and so on which can be extensively used in R&D, production, installation and maintenance of SDH, PDH, PCM, DATA Protocol Converter. It is a useful tool for faster problem resolution.

  • MP1590B - Network Performance Tester

    Company: Anritsu

    The MP1590B Network Performance Tester is a measuring instrument capable of measuring IP networks up to 10 GbE using the Ethernet plug-in modules of the Anritsu MD1230A test system, as well as traditional functions including testing of PDH, DSn, SDH/SONET, and OTN equipment and jitter measurement, with only one box. A new EoS unit supports EoS measurement, virtual concatenation, and LCAS measurement to enable testing of next-generation SDH/SONET equipment.

  • MP1590B Network Performance Tester

    Company: Anritsu

    The MP1590B Network Performance Tester is a measuring instrument capable of measuring IP networks up to 10 GbE using the Ethernet plug-in modules of the Anritsu MD1230A test system, as well as traditional functions including testing of PDH, DSn, SDH/SONET, and OTN equipment and jitter measurement, with only one box. A new EoS unit supports EoS measurement, virtual concatenation, and LCAS measurement to enable testing of next-generation SDH/SONET equipment. The traditional MP1590A plug-in units can also be used without changes

  • HTYB-2H - Oxide Arrester (MOA) Tester

    Company: Wuhan Huatian Electric

    HTYB-2H Oxide Arrester (MOA) Tester special applies to test gapless arrester MOA bad contact internal defects of power system under 10KV. Measured the leakage current under DC reference voltage (U1Ma) of MOA and 0.75 U1mA .This device composed by DC HV power source, measuring and controlling system, all components in one case, small in volume, light in weight .

  • QT-GPT - Gas Permeability Tester

    Company: Qualitest International

    Gas Permeability Tester- QT-GPT-500 is used to test the gas transmission rate (GTR) of packaging material. This instrument is widely used in food industry, pharmaceutical industry, cosmetics flexible packaging materials industry (plastic film, barrier materials, sheets, metal aluminum, PVC, PVC sheets), colleges, universities and quality institutions for gas (O2, CO2, N2, Non-inflammable gas and non-etchant gases) permeation test and quality control.

  • 19301A - Impulsing Winding Tester

    Company: Chroma ATE

    The Chroma 19301A Impulse Winding Tester applied with high/ low inductance test technology has 1000V impulse voltage and 200MHz high speed sampling rate that can satisfy mos t of the power inductors test requirements for wide range of inductance products from 0.1uH to 100uH. The built-in Area Size Comparison, Differential Area Comparison, FLUTTER value and LAPLACIAN value functions are able to inspect the coils for poor insulation effectively.

  • 19305 series - Impulsing Winding Tester

    Company: Chroma ATE

    The Chroma 19305 series Impulse Winding Tester included with one channel(19305) and 10 channels output (19305-10), the 19305 series has 6kV impulse voltage and 200MHz high speed sampling rate to improve sensitivity of discharge detection. To test more than 10uH, the built-in Area Size Comparison, Differential Area Comparison, FLUTTER value and LAPLACIAN value functions are able to inspect the coils for poor coil insulation.

  • 11802/11803/11805/11890/11891 - Programmable HF AC Tester

    Company: Chroma ATE

    Chroma 11802 Series Programmable High Frequency AC Tester is a digital controlled high frequency AC source platform, can be combined with high frequency voltage/current step-up module to provide high voltage/high current. Chroma 11802 Series output test frequency is 20kHz~200kHz, which cover application frequency range for various SMPS, LCD inverter and etc.

  • ADTS553F - pitot static testers

    Company: Barfield

    The ADTS553F air data test set is a portable three-channel flightline pitot static tester. It provides pitot static air data validation, leak testing, fault-finding and avionics instrumentation testing forany aircraft requiring angle of attack two off static-controlled channels, in addition to a pitot test channel. The ADTS553F can also be used as a standard two-channel flightline air date test set.

  • ADTS554F - pitot static testers

    Company: Barfield

    The ADTS554F air data test set is a portable four-channel flightline pitot static tester. In three-channel mode, it provides pitot static air data validation, leak testing, fault-finding and avionics instrumentation testing for any aircraft requiring angle of attack two off static-controlled channels, in addition to a pitot test channel. The ADTS554F can also be used as a standard two-channel flightline air data test set or two simultaneous two-channel air data test sets.

  • DC400A - Fuel Quantity testers

    Company: Barfield

    The DC-400A is a completely self-contained, portable, lightweight, internal battery powered DC fuel quantity system Test Set. The tester is specifically designed, when used with the proper Adapter Module, to meet the requirements for testing and calibration of a wide range of Aircraft DC Fuel Quantity Systems. The Interchangeable adapter modules customize the DC400A to interface directly with a specific aircraft without the need for an external adapter cable. The digital monitor function monitors the fuel quantity indicator/signal conditioner output directly in pounds, volts, ratio, etc., depending on the module.

  • Electrical Safety Tester

    Company: Lisun Electronics

    Basic testing methods of Glow wire device> and UL 746A, IEC829, DIN695, VDE0471, the Glow wire tester ZRS-3H/ZRS-3HS is suitable for resistance to abnormal heat and fire test on lighting lamps, electronic products and household appliances. Adopting high-temperature coating spraying on steel structure and imported instrument display, with easy operation, stable performance the equipment is applicable to flame resistance tests of all levels of QC departments and corresponding enterprises.

Products

Applications

Manufacturers