Filter Results By:
Products
Applications
Manufacturers
Control
Known value
- Pickering Interfaces Inc.
product
PCI Resistor Card 2-Channel 1.5 Ohm To 4.09k Ohm With SPDT
50-293-123
The 50-293 is a Programmable Resistor card with either two channels of 16-bit or four channels of 8-bit resistor chains in a single PCI card. The card is ideal for simulating sensors for control and management systems under test, allowing the user to verify system response in design verification or manufacturing test applications.
-
product
Protocol Control Control
PC2
The PC2 software from SCSI Toolbox, LLC brings a new level of parallel SCSI protocol control to your test environment. Designed in cooperation with LSI Logic to work with their Fusion-MPT Message Passing Interface technology, PC2 allows all negotiated parameters to be displayed or set for all devices connected to any SCSI Host Bus Adapter based on the LSI53C1030 chip set. PC2 also provides the means to generate hardware SCSI bus resets.
-
product
Controls
Our modular controls range from simple power supplies to more complex inspection systems. These controls are easy to setup, simple to install and easy to maintain.
-
-
product
Controls
HydrationLink
The HydrationLink system consists of 5 Chem-add loops and Auto-Tub Leveling controls.
-
product
Control Cables
TRIUMPH specializes in cable controls which are mechanical connections between controls and actuation systems used in a variety of applications. Our systems provide higher reliability, lighter weight, and greater control box selection. Current controls include wire rope, push-pull controls, sliding friction controls, ball-bearing controls and low-resistance and backlash mechanical control system cables. Wire Rope Controls: Wire Rope is used in applications where weight is critical, and the system operates in tension only. Assemblies are built to your required standards with unlimited configuration capabilities. Sliding Friction Controls: High load capacity in tension and compression. Flexible in any direction, wide temperature range and easy installation. No adjustment or lubrication needed during the life of the control. Ball Bearing Controls: Ball Bearing controls are a self-contained system that performs linear motion under tension or compression loads.Precise and accurate movement with high load capacity offering weight savings, low friction and high efficiency. Quick disconnect ends available.
-
product
Bay Control
Schweitzer Engineering Laboratories, Inc.
Integrated bay control systems combine complete bay control with high-speed breaker protection, allowing you to deploy a full substation protection, control, and monitoring solution that is flexible for your application.
-
product
Control Transformers
Osborne’s Control Transformers are commonly used to step down primary circuit voltages to lower voltages to be used for control circuit applications. These units set the standard for premium, high performance, hand crafted control transformers. Your customers will appreciate your decision to work with the quality and reliability of Osborne Transformer’s control transformers.
-
product
Acoustic Control
Acoustic Control provides accurate control for high-level noise testing of reverberant chambers or progressive wave tubes. Based on the Spider hardware platform, Acoustic Control achieves quick and reliable control of the noise level to the reference octave spectrum and the overall sound pressure level (OASPL). Included safety features guarantee the safety of the unit under test.
-
product
Control Transformers
ENTES control transformers ensure the safe operation of measuring devices with 24 VAC supply voltage for electical control panels. Input voltages of Control transformers are either fixed (230 or 400V) or selectable with taps (400;230+15-15).
-
product
Control Unit
Epec 3724
Epec 3724 Control Unit has an optimized number of both input and output pins to be used for numerous roles in the control system. The total number of I/O pins is 52, and the I/O solution is based on the same proven in use combination as in the previous 2024 control unit. This product is our all-time favourite and a real multipurpose controller for distributed control systems.
-
product
Control Center
COSYMA
COSYMA is the control centre for APCOS®4000, consisting of a comprehensive and versatile application software that includes the following components:*Communications Network Control (CNC)*Radio & Device Control (RDC)*Secure Automatic Military Message Handling System (SAMMS)
-
product
Control Unit
EC-501A & EC-501A(G)
Dynatrol® EC-501A and EC-501A(G) Control Unit combines with the DJ and G Series Dynatrol® Level Detectors, including Sealed and Suspended units. Within the Control Units, a SPDT relay is operated from the On/Off signal of the Dynatrol® Level Detector. Simply actuate process control equipment, level alarms or indicator lights from the contacts of this control unit.
-
product
Control Unit
Epec 3606
Epec 3606 Control Unit is a compact and robust multifunction controller with a high calculating power. It can be used as a stand-alone controller for smaller systems or as part of a bigger, decentralized control system. Epec 3606 control unit has 21 I/O pins in total.
-
product
Control Unit
Epec 4602
Epec 4602 Control Unit has a wide range of programmable I/Os for different implementations. Epec 4602 can control 10 hydraulic blocks simultaneously by using 20 PWM outputs and 10 feedbacks. It can be used as a stand-alone controller or as part of decentralized control system.
-
-
-
product
Control Systems
Control Systems – With these components by MCD, building up complex systems is essentially simplified. Control tasks are distributed to intelligent sub-systems and are controlled by them.
-
product
Control Center
Schweitzer Engineering Laboratories, Inc.
The essential elements in the reliable operation of the bulk electric system (BES) are control centers that continuously monitor and control generation and transmission power flows. Visualization, situational awareness, and analytic software help ensure that control center personnel always know what is happening with the BES.
-
product
Transmission Control
Schweitzer Engineering Laboratories, Inc.
Transmission control systems provide flexible local control and SCADA integration for substation and line protection assets, improving your system’s reliability and efficiency.
-
product
Motor Control
A product portfolio that offers motor drivers (brushed, brushless, stepper, load & relay) and integrated motor control systems for all your motor control solutions.
-
product
Industrial Control
Schweitzer Engineering Laboratories, Inc.
Industrial control systems require reliable automation solutions that can integrate with relays, meters, and plant controls to ensure the safe operation of industrial facility power systems.
-
product
Pressure Control
Precise control of compressed gas is an intelligent approach to calibration. Ralston Instruments offers a number of pressure control devices for use in a wide range of applications and pressure levels.
-
product
CONTROL TRANSFORMERS
Our control transformers are robust, flexible in design and come with short lead time. Basically an ideal solution for control panel builders who need transformers in a hurry.
-
product
Cockpit Controls
TRIUMPH Mechanical Solutions produces cockpit controls and quadrants specifically designed to meet unique customer requirements. Our Electro-Mechanical Cockpit modules are frequently married to our push/pull controls to produce combined output devices. For example, a throttle quadrant with switch/transducer outputs and mechanical cable connections to an engine control system.
-
product
Capacitor Controls
*Industry leader in capacitor controls for rural electric, public power and investor owned*Targeted to the special needs of the utility operator*VarCom Controls are simple to use, yet provide sophisticated system auditing*Plug and play–VarCom Controls work with a variety of cap bank switch, sensor, SCADA/DMS software and communication devices
-
product
Generation Control
Schweitzer Engineering Laboratories, Inc.
Safely operating a generating facility requires reliable automation solutions that can integrate with relays, SCADA, and plant controls. With a generation control solution, you will realize operational efficiencies and increased reliability.
-
product
Master Control
D SERIES
The D Series Master Control provides positive fuel shutoff (complete shutdown) with manual override at the control to allow the operator to manually override the valve each time the engine is started.
-
product
Control Units
For integration into a larger system or for automated measurements, the gain control unit for automated systems lets you control the settings of the intensifier attachment. The control unit uses standard TTL and analog signals for communication, allowing the user to switch the intensifier on or off, alter the gain and the anode current limit of the image intensifier without the need of software integration.
-
product
Electronic Controls
Global Digital Instruments, LLC
Global Digital Instruments Electronic Controls
-
product
Motion Control
Curtiss-Wright Defense Solutions
Bring new levels of stability and control to almost any military or industrial application. Every high-precision motion control system we build is fully integrated and tailored for your application’s unique requirements.
